RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: thesouth1
Showing results 1 to 25 of 392
Search took 0.54 seconds.
06-13-2011, 02:46 PM
Replies: 11
Views: 907
Posted By thesouth1

RE: tmaxx question

Agreed Snook! lol...

And also there is a difference between the "S-Maxx" and the "Sport Maxx".
S-Maxx actually stood for Stadium Maxx and had 2 speeds, no reverse and 2WD. It came out at the...
06-13-2011, 02:34 PM
Replies: 3
Views: 733
Posted By thesouth1

RE: Tmaxx Tranny Problem

+1 on this suggestion. I have had the same issue many times. My advice is to "get to know your transmission". Don't be afraid to take it out, apart and see what's going on in there. If you have the...
06-13-2011, 02:11 PM
Replies: 4
Views: 433
Posted By thesouth1

RE: tmaxx to electric

I posted something about this long ago... here is the link to the thread for sake of cluttering this one.
RC Universe
(7th post down)
03-12-2010, 12:06 PM
Replies: 10
Views: 998
Posted By thesouth1

RE: o.s. .18 question

The block, I would almost gaurentee is different. Not on the out side but on the inside. Where you have ports on your sleeve, you have a cut out in the block. So if the TZ has a different sleeve the...
06-16-2009, 11:51 PM
Replies: 14
Views: 1,214
Posted By thesouth1

RE: Rebuild 1.5 Pro or go to 2.5R

Did you happen to keep the OWB and pullstart? If you did I need them!!
06-14-2009, 03:36 PM
Replies: 4
Views: 382
Posted By thesouth1

RE: idleing over reving help

Sounds like the linkage might not be closeing all the way.....
06-05-2009, 12:37 PM
Replies: 9
Views: 1,057
Posted By thesouth1

RE: T-E maxx conversion

Sure, I have posted it here before.
the link:
Hot Racing (http://www.hot-racing.com/index.cgi?partnumber=EEC2000T01&c=137)
Its a little pricey but you do not have to change much on your...
06-05-2009, 10:40 AM
Replies: 2
Views: 464
Posted By thesouth1

RE: Is a 3.3 tranny waterproof?

It should be fine. Its dry gears, no lube in there. Only concern would be the bearings but, I wouldn't worry about the Transmission.
06-05-2009, 09:35 AM
Replies: 9
Views: 1,057
Posted By thesouth1

RE: T-E maxx conversion

Or you could try one of these...

http://i160.photobucket.com/albums/t187/thesouth1/MaxxEconversion.jpg
06-04-2009, 12:53 PM
Replies: 7
Views: 694
Posted By thesouth1

RE: should i buy a t-maxx 3.3 for $150

See his response here:
http://www.rcuniverse.com/forum/m_8814679/tm.htm

This current thread is no longer valid.
06-02-2009, 08:37 PM
Replies: 1
Views: 395
Posted By thesouth1

RE: compair 3.3 to car v-8s

This will answer most if not all your questions. A great page Ifound while surfing today!http://www.rcuniverse.com/forum/js/fckeditor/editor/images/smiley/msn/wink_smile.gifEnjoy!

How is RC Engine...
06-02-2009, 08:11 PM
Replies: 30
Views: 3,471
Posted By thesouth1

RE: RPM True-Track

Here is the link to them on Traxxas.com (http://www.buytraxxas.com/advanced_search_result.php?osCsid=us9okvlso4u02h6v259980pl90&partnum=5153r)
I have some but they are silver in color...

Edit.....
06-02-2009, 07:54 PM
Replies: 7
Views: 694
Posted By thesouth1

RE: should i buy a t-maxx 3.3 for $150

I'll buy it if you don't. :D
06-02-2009, 07:45 PM
Replies: 30
Views: 3,471
Posted By thesouth1

RE: RPM True-Track

Edited for color contrast.
06-02-2009, 02:52 PM
Replies: 3
Views: 457
Posted By thesouth1

RE: .21 BB pipe on TRX 3.3?

I do not believe that it would work out to well.
That pipe is for a BB(BigBlock) engine and the 3.3 (3.3 cubic centimeter = 0.201 378 355 51 cubic inch)isn't what Iconsider a BB, on the verge, but...
06-02-2009, 09:17 AM
Replies: 30
Views: 3,471
Posted By thesouth1

RE: RPM True-Track

Here is my thread from last year.</p>

</p>

RPM True-Track (http://www.rcuniverse.com/forum/m_7080059/anchors_7080059/mpage_1/key_/anchor/tm.htm#7080059)</p>
04-15-2009, 08:29 AM
Replies: 26
Views: 2,844
Posted By thesouth1

RE: Pro-Line RunTime fuel tank

I done a thread on this a while back : Pro-Line Run Time (there are pictures)
And yes, I have experienced the 25-30 min. run time.
03-26-2009, 02:00 PM
Replies: 4
Views: 517
Posted By thesouth1

RE: TRS Question.

Another method can be found here&gt; Misbehavin' RC.
03-26-2009, 01:58 PM
Replies: 8
Views: 749
Posted By thesouth1

RE: THS racing manifold.

I do not believe this manifold will work with your Resonator. It connects to the pipe via three little springs on a flange that is on the THS or similar "buggy" type pipe. The Resonator connects via...
03-25-2009, 09:13 AM
Replies: 2
Views: 626
Posted By thesouth1

RE: www.xtownrc

Not to bad to plug on the forums as long as the site has fair prices and great customer service.
I am in Xenia Oh, and have met Gerry and Kevin when it was first starting up, and have their site...
03-20-2009, 07:29 PM
Replies: 1
Views: 318
Posted By thesouth1

RE: t-maxx transmission question

On the "exploded view" it shows that the shiny pawl goes toward the spur and the black pawl goes toward the front. I am sure there is a reason for that.
Exploded view.
03-18-2009, 03:42 PM
Replies: 11
Views: 929
Posted By thesouth1

RE: Which Fail Safe

If you ever decide to up-grade your Transmitter to say a Spektrum system, it has a built in failsafe. Many other aftermarket radio manufacturers have this also.
03-17-2009, 02:12 PM
Replies: 12
Views: 3,858
Posted By thesouth1

RE: Lowering the T Maxx

Looks like he's using zip-ties.
03-17-2009, 07:07 AM
Replies: 3
Views: 361
Posted By thesouth1

RE: Spur Gear

Would help to know which transmission you have.
On a 2.5 trans a 72 spur with a 18CB will give great take-off.
03-17-2009, 07:05 AM
Replies: 28
Views: 2,133
Posted By thesouth1

RE: Has anyone ever broke an RPM part?

I have ripped the eye from lower A-Arms before also. Only done it twice and the replaced both times. I sent one in because the eye got elongated and they replaced it too.
Showing results 1 to 25 of 392
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.