Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: tomgreen
Showing results 1 to 25 of 73
Search took 0.10 seconds.
Forum: Marketplace
09-10-2020, 09:22 PM
Replies: 8
Views: 340
Posted By tomgreen

PRICE REDUCTION, $150.00 Firm

PRICE REDUCTION, $150.00 Firm
Forum: Marketplace
09-06-2020, 06:33 PM
Replies: 5
Views: 264
Posted By tomgreen

Thanks John, will follow up with a call when...

Thanks John, will follow up with a call when shipped. 😊
Forum: Marketplace
09-06-2020, 02:20 PM
Replies: 5
Views: 264
Posted By tomgreen

Yes, I had it mounted on a Tiger 2. No crash...

Yes, I had it mounted on a Tiger 2. No crash damage, very low run time. I back up my stuff with your money back, but you will be smiling when you see this engine. I have a good rating at this site.
09-05-2020, 07:37 PM
Replies: 1
Views: 960
Posted By tomgreen

The S2, you will have to a DX6 or better to be...

The S2, you will have to a DX6 or better to be able to see your voltage of your flute pack. That's it.
09-05-2020, 07:33 PM
Replies: 4
Views: 560
Posted By tomgreen

Grampi50, I would start with a drift calibration...

Grampi50, I would start with a drift calibration flight. Then put your trims back to centered, and then make any corrections turning the servo pushed connecting at the dashboards needed.
Forum: Marketplace
09-04-2020, 02:26 PM
Replies: 8
Views: 340
Posted By tomgreen

Thanks Ralph, but I think that is to low for all...

Thanks Ralph, but I think that is to low for all you would be getting. Have a great weekend of flying.
Tom
Forum: Marketplace
09-03-2020, 08:07 PM
Replies: 8
Views: 340
Posted By tomgreen

Jr xp9393h

I have a XP9303H radio, with a Spektrum 2.4 DSM2 Module for it. Also 2 RS600 recievers, 2 R790 scanselect recievers, 2 R600 recievers, and 1 NER - 226X reciever.
Two Antenna's, and the charger cord....
Forum: Marketplace
09-03-2020, 07:48 PM
Replies: 5
Views: 264
Posted By tomgreen

IS Engine

I have a OS MAX 55 AX. Great Shape
Forum: Marketplace
09-03-2020, 07:06 PM
Replies: 0
Views: 186
Posted By tomgreen

JR 72 MHz TO RD Synthhesized Module

Synthesized 72 KHz TO RD Module
09-02-2020, 06:27 PM
Replies: 0
Views: 213
Posted By tomgreen

Tail rotor blade

I have a Blade 120 s2 helicopter where the tail blade gets loose and will not rotate. I wonder if I should glue it on, or just threading a wire through the hole and again press it back onto the...
08-20-2020, 12:18 AM
Replies: 2
Views: 640
Posted By tomgreen

six questions

I thought this site would overrun with answers to the AMA poll questions.
08-11-2020, 08:31 PM
Replies: 4
Views: 1,278
Posted By tomgreen

I also are new to this ,and are flying a Blade...

I also are new to this ,and are flying a Blade R120s2. I love this but it,s a little big to fly in the house. At least while am learning.
08-11-2020, 08:22 PM
Replies: 0
Views: 311
Posted By tomgreen

Need help on a softer landing

I am new to this and are flying a Blade 120s2 , and a DX6Gen2 radio. I am doing pretty good at hover at about 5ft high, and going from side to side. Working on flying a box now. But when I go to...
08-04-2020, 06:16 PM
Replies: 3
Views: 1,212
Posted By tomgreen

Blade

I to an new at this and have the 120 S2 and a DX6 G2. Every thing was going good when I popped the rear rotor blade off. Got it back on and just spins around in circles. Also I have the flute mode on...
Replies: 1
Views: 294
Posted By tomgreen

I would use the throttle trim. Set the trim high...

I would use the throttle trim. Set the trim high to a steady idle and the lower end of the trim would kill the motor when all the way down.
12-23-2019, 01:01 AM
Replies: 3
Views: 750
Posted By tomgreen

Everything about this hobby is $$$$$.

Everything about this hobby is $$$$$.
Forum: Marketplace
10-03-2019, 01:36 AM
Replies: 0
Views: 215
Posted By tomgreen

JR XP9303H 9 Ch Scan Select Transmiter

I have a JR XP9303 9Ch Scan Select Transmitter. I have the Spectrum 2.4 DMS2 Module with it. Also a have 8 JR FM receivers for it. This set up is ready to put in to your plane.
Free Shipping, Firm...
09-29-2019, 12:07 PM
Replies: 3
Views: 750
Posted By tomgreen

Altimeter

I just received my new Jolly Logic altimeter to put inside of my sailplane. Trying to keep my flights over 400 ft. The nice thing about this is it can be put in any plane, glider, or even a rocket.No...
09-10-2019, 09:15 PM
Replies: 2
Views: 3,492
Posted By tomgreen

I can't see it

I went out to do some glider time, temp was about 100, and the wind was blowing about 10-15 mph.Nice puffy white clouds in the sky over a blue back ground.
Up it goes, climbed out fast, leveled it...
08-13-2019, 01:59 PM
Replies: 1
Views: 489
Posted By tomgreen

Battery Question

I have A Flite 3S 11.1V 1300mAn (14.4Wh) that I am using in my glider. When I start have a battery reading of 12.6 All, #1 4.18, #2 4.20 and #3 4.20).When I land , this is the reading All 11.3,( #1...
07-30-2019, 07:38 PM
Replies: 0
Views: 1,229
Posted By tomgreen

AR620 Problem

I went to fly one of my planes that has a AR620 receiver it. Using a DX6 G3 radio. The bind went find, then had no movement when moving the sticks. Double checked the battery, there good. I then...
06-28-2019, 10:16 PM
Replies: 0
Views: 1,102
Posted By tomgreen

New DX6 transmitter

Well I went and bought a DX6 transmitter. I have been using a JR 9303XP for the last years. I have to say this new one is really nice, but will still keep the JR around. It's hard to give it up, it...
Forum: Marketplace
12-04-2018, 11:10 PM
Replies: 0
Views: 284
Posted By tomgreen

JR recievers

1 JR R600 FM 6 CH Receiver CH 21 20.00
2 CH 21 20.00
3 CH 21 ...
Forum: Marketplace
09-14-2018, 04:49 PM
Replies: 0
Views: 319
Posted By tomgreen

JR Recivers

I have a JR R790 ScanSelect Reciever for $40.00.
JR R600 on Ch 21 - 23.00
JR RS600 on Ch 21 - 23.00
JR RS600 on Ch 27 - 23.00

Will ship for FREE
09-14-2018, 12:16 PM
Replies: 2
Views: 1,178
Posted By tomgreen

Andy, thank you for your fast reply to my...

Andy, thank you for your fast reply to my question. All set

Tom / Mesa, Az.
Showing results 1 to 25 of 73
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.