RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: highhorse
Showing results 1 to 25 of 500
Search took 0.58 seconds.
Forum: RC Jets
Yesterday, 12:03 PM
Replies: 14
Views: 673
Posted By highhorse

The answer to that is evident in the OP.

The answer to that is evident in the OP.
Forum: RC Jets
10-02-2022, 06:16 PM
Replies: 14
Views: 673
Posted By highhorse

Yet another positive and productive post from the...

Yet another positive and productive post from the Zeeb. Why don’t you just get another hobby and stop trolling fellow RC-ers threads?
Forum: RC Jets
10-02-2022, 09:49 AM
Replies: 14
Views: 673
Posted By highhorse

JetCat Users: What Oil?

So…I was away from turbines for a while and have noticed a warning in my P-100RX manual which was not present in my older Jetcat manuals. They now specifically disallow synthetic 2-stroke oils and...
Forum: RC Jets
10-02-2022, 07:42 AM
Replies: 867
Views: 173,357
Posted By highhorse

As mentioned multiple times above, I would...

As mentioned multiple times above, I would strongly suggest just shimming the engine if it pitches with throttle change. Mixing elevator to throttle will be very problematic for a turbine because of...
Forum: RC Jets
09-30-2022, 12:45 PM
Replies: 867
Views: 173,357
Posted By highhorse

…In that case then I’d start with 3 deg down as...

…In that case then I’d start with 3 deg down as per the drawings and shim in more later if needed. I used 4-ish deg down on two similar scratch-builds -one of which has a full 50% more thrust than...
Forum: RC Jets
09-30-2022, 11:53 AM
Replies: 867
Views: 173,357
Posted By highhorse

The bottom line is that with a variety of models...

The bottom line is that with a variety of models including the Turbs and Reactions, 4-5 degrees is about right, or at least very close. This post Other Turb Thread...
Forum: RC Jets
09-30-2022, 11:41 AM
Replies: 867
Views: 173,357
Posted By highhorse

Understandable supposition, but fortunately not...

Understandable supposition, but fortunately not the case. As the thrust (or more precisely, the eflux) of any given turbine(s) varies from idle to full blow, so does its influence on the horizontal...
Forum: RC Jets
09-30-2022, 04:58 AM
Replies: 867
Views: 173,357
Posted By highhorse

Angle doesnt vary with turbine size, fwiw. I have...

Angle doesnt vary with turbine size, fwiw. I have the exact info you’re looking for but am in a meeting at the moment. WIll post it later today unless someone beats me to it.
Forum: RC Jets
09-26-2022, 09:25 AM
Replies: 66
Views: 16,392
Posted By highhorse

Alas, my search for a source of LowBoys was for...

Alas, my search for a source of LowBoys was for naught…almost. While not able to locate a direct replacement, I did find two items that I think could do quite nicely. I hope that one of both of these...
Forum: Marketplace
09-23-2022, 06:50 PM
Replies: 2
Views: 147
Posted By highhorse

From which model Boomer please? What are the...

From which model Boomer please? What are the dimensions from mounting lugs to axles, and what are the wheel sizes? Thanks.
Forum: RC Jets
09-23-2022, 07:29 AM
Replies: 4
Views: 413
Posted By highhorse

Elan

Elan
Forum: RC Jets
09-18-2022, 03:02 PM
Replies: 66
Views: 16,392
Posted By highhorse

Sorta cool switch there, but does it reverse?...

Sorta cool switch there, but does it reverse? Seems to me that reverse is pretty indispensable?
Forum: RC Jets
09-15-2022, 09:27 AM
Replies: 63
Views: 5,481
Posted By highhorse

Dear God. RCU is going Kardashian? Don’t folks...

Dear God. RCU is going Kardashian? Don’t folks get upset when you place engines on their cars for photo ops?
09-12-2022, 07:39 PM
Replies: 2
Views: 229
Posted By highhorse

RX manual in English?

I have looked several times on the JetCat site but can’t locate a 100RX manual in English. Anyone steer me in the right direction please? Thanks.
Forum: RC Jets
09-11-2022, 11:05 AM
Replies: 66
Views: 16,392
Posted By highhorse

I may have found a source for low-cg jugs but...

I may have found a source for low-cg jugs but need to call the supplier and ask a few questions. This search for Low Boys could almost be a thread unto itself.
Forum: RC Jets
09-09-2022, 09:48 PM
Forum: Marketplace
09-07-2022, 03:39 PM
Replies: 2
Views: 343
Posted By highhorse

Nice idea. Too small for my planed though. Would...

Nice idea. Too small for my planed though. Would be interested in a set if you upsize to 8” width or more.
Forum: RC Jets
09-01-2022, 04:16 PM
Replies: 63
Views: 5,481
Posted By highhorse

My two 90’s are on the way after a wait of...

My two 90’s are on the way after a wait of several months. Woot Woot! Busy fall/winter in the making!
Forum: RC Jets
08-31-2022, 04:31 PM
Replies: 63
Views: 5,481
Posted By highhorse

Glad the info helped.

Glad the info helped.
Forum: RC Jets
08-31-2022, 04:29 PM
Replies: 867
Views: 173,357
Posted By highhorse

That would’ve taken me all day

That would’ve taken me all day
Forum: RC Jets
08-31-2022, 09:36 AM
Replies: 63
Views: 5,481
Posted By highhorse

Gents, The diesel question above made me...

Gents,

The diesel question above made me curious, even though I fly only kero. My curiosity coupled with a desire to not see speculation or erroneous info rule the day, I queried Gaspar once...
Forum: RC Jets
08-30-2022, 06:16 PM
Replies: 4,624
Views: 916,538
Posted By highhorse

I will refurb and remaiden the used one I bought...

I will refurb and remaiden the used one I bought when my Xicoy 90 finally arrives.
Forum: RC Jets
08-30-2022, 11:07 AM
Replies: 63
Views: 5,481
Posted By highhorse

Confusion, yes. I am well aware of the...

Confusion, yes. I am well aware of the distributorship as I bought my 120 from Keith and have two 90’s on order. No one has remotely implied that he’s less than 100% honest, let alone myself. When I...
Forum: RC Jets
08-30-2022, 10:51 AM
Replies: 63
Views: 5,481
Posted By highhorse

Mmmm…sorta. Lack of detail. When I asked for more...

Mmmm…sorta. Lack of detail. When I asked for more info you were in fact the very one who sent me to Gaspar.
Forum: RC Jets
08-29-2022, 10:03 PM
Replies: 63
Views: 5,481
Posted By highhorse

Well as with another recently posted question you...

Well as with another recently posted question you can get a lot of guessed-at answers here, or you can do what i did - go to the main Xicoy site and contact Gaspar for the straight scoop.
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright © 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.