RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: DriftingDragon
Showing results 1 to 25 of 500
Search took 0.66 seconds.
Replies: 10,815
Views: 708,514
Posted By DriftingDragon

i would say get proline powerstrokes, well worth...

i would say get proline powerstrokes, well worth the money, they are durable, mine on the front have hit curbs at ~100kmh and they didnt get damaged, my video shows it working
Replies: 10,815
Views: 708,514
Posted By DriftingDragon

im using the slash 4x4 in the from obviously...

im using the slash 4x4 in the from obviously mine are at least length, but i tested them it gives it a good ride height when adjusted, i would think the rears would be pretty close.



...
Replies: 16
Views: 14,064
Posted By DriftingDragon

seeing as you will be in sand you may want a...

seeing as you will be in sand you may want a sealed can you could look at something like this HPI Racing Flux Vektor 5900kv http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXDHGM&P=7

it should...
Replies: 7
Views: 2,976
Posted By DriftingDragon

turns out there was some corrosion on the battery...

turns out there was some corrosion on the battery plug of the esc
Replies: 7
Views: 2,976
Posted By DriftingDragon

Awesome thanks for the help ill double check the...

Awesome thanks for the help ill double check the wires in the morning. If that fails ill give castle a call.

Thanks again.
Replies: 7
Views: 2,976
Posted By DriftingDragon

its a 7.4v 7100mah 90c lipo rocket power i...

its a 7.4v 7100mah 90c lipo rocket power

i have run it on 7.2v 3000mah reedy wolf pack nickles

and like i said it was running fine yesterday, topping out around 80kmh
Replies: 7
Views: 2,976
Posted By DriftingDragon

*Update* it seems when i turn it on it now arms...

*Update* it seems when i turn it on it now arms then no power gets to the receiver and the light on the receiver turns off.

so when i power on it arms, does the beeps, there is no power to the...
Replies: 16
Views: 14,064
Posted By DriftingDragon

I was running a castle cm36 4600kv was quite alot...

I was running a castle cm36 4600kv was quite alot of power bought for 60 worth about 20 now

I also ran a reedy sonic 5t 550 total overkill but lots of fun high speeds and can be geared to the moon...
Replies: 7
Views: 2,976
Posted By DriftingDragon

Exclamation URGENT HELP NEEDED Mamba Monster 2 stopped work wont arm or calibrate

Hey guys I could really use some help, I have been using my Mamba Monster 2 for about 2 months now it was running fine but i go to turn it on and it starts jittering in reverse. so i turn it off and...
12-30-2013, 02:12 PM
Replies: 5
Views: 2,172
Posted By DriftingDragon

i got it sorted out, i wasnt seeing one of the...

i got it sorted out, i wasnt seeing one of the settings
12-28-2013, 05:56 PM
Replies: 5
Views: 2,172
Posted By DriftingDragon

I do have the balance plug in, i will take in my...

I do have the balance plug in, i will take in my charger and see if my lhs can set it up for me or get me a working one
12-28-2013, 08:49 AM
Replies: 5
Views: 2,172
Posted By DriftingDragon

its a 7.4v 7100mah/90c i tried that and for...

its a 7.4v 7100mah/90c

i tried that and for me its only showing 3s and 6s
12-27-2013, 02:59 PM
Replies: 5
Views: 2,172
Posted By DriftingDragon

Question HELP NEEDED! GT Power A606-D

Hello guys, I just converted to Lipo and I needs some help

I got a GT Power A606-D charger and a CRC 2s 7100/90c rocket fuel

I was told by the guys at my LHS to use the Lipo Balance mode at...
Replies: 10,815
Views: 708,514
Posted By DriftingDragon

its funny you say that but they were covered in...

its funny you say that but they were covered in orange surface rust



EDIT: axels came in will have video soon of this monster.


are there any ways to keep weight on the front without having...
Replies: 10,815
Views: 708,514
Posted By DriftingDragon

thanks, dang i guess i gotta wait, cvs...

thanks, dang i guess i gotta wait, cvs definitely when i have the money
Replies: 10,815
Views: 708,514
Posted By DriftingDragon

are there any drive shafts that will fit other...

are there any drive shafts that will fit other then the hpi or the cv axles
Replies: 10,815
Views: 708,514
Posted By DriftingDragon

hey guys its been a while since i have been on ...

hey guys its been a while since i have been on
current setup: Reedy 4.5T 550 CC mamba Monster 26/87 2 reedy wolfpack 3000mah
...
Replies: 6,954
Views: 767,340
Posted By DriftingDragon

RE: Official Tamiya TT-01 Thread

i have been recently tinkering with my tt01 and has anyone figured out how to fit a 36T pinion to the 61t spur (stock) i had 23T in it but it wasnt satisfying,

current setup is
ESC: Castle...
04-27-2013, 07:50 PM
Replies: 8
Views: 1,603
Posted By DriftingDragon

RE: SCX- 10 ESC issue

as for the not detecting i was grabbed the wrong plug
04-27-2013, 03:11 PM
Replies: 8
Views: 1,603
Posted By DriftingDragon

RE: SCX- 10 ESC issue

its was a nimh it was just a garbage battery it only out put 3v at full throttle a new batt has fixed it
04-26-2013, 09:25 PM
Replies: 8
Views: 1,603
Posted By DriftingDragon

SCX- 10 ESC issue

I just bought a Honcho this evening it runs good but if i go full throttle it will cut the power to the esc so it just stops

is it a setting in castle link?

when i hook it up it recognize...
Replies: 3,214
Views: 369,657
Posted By DriftingDragon

RE: The Official Traxxas Slash short-course race truck

if your using nickel batteries get it opened up and put as many at the front as u can
Replies: 3,214
Views: 369,657
Posted By DriftingDragon

RE: The Official Traxxas Slash short-course race truck

are there any 6 or 8 pole motors that will fit the slash?
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.