RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: scott page
Showing results 1 to 7 of 7
Search took 0.02 seconds.
Replies: 373
Views: 69,164
Posted By scott page

Just looked at the D8 telemetry still available...

Just looked at the D8 telemetry still available (not much). The hub that was used in the past had really small wires and easily broken or pulled out plugs. They had a ton of sensors back in 2011 --...
Replies: 373
Views: 69,164
Posted By scott page

If telemetry is not your thing then the D8...

If telemetry is not your thing then the D8 receivers are a very good choice. I doubt of much of the D8 telemetry gear is even available anymore but it was delicate and difficult to deal with IMO. ...
Replies: 373
Views: 69,164
Posted By scott page

I've never done the calibration setup - but I...

I've never done the calibration setup - but I have a flying buddy that does. Frankly, I don't see a use or it. but he thinks it's the cat's meow. Basically -- it allows you to have both ailerons...
Replies: 373
Views: 69,164
Posted By scott page

It will not harm your transmitter and is not...

It will not harm your transmitter and is not dangerous to use the transmitter. In fact - you can use the transmitter without the SD card at all on a Taranis. The message is an indicator that the...
Replies: 373
Views: 69,164
Posted By scott page

First the concept-- when you move the rudder in...

First the concept-- when you move the rudder in either direction you want the elevator to move in the negative direction (up).
To do this you create two new input lines. One with rudder input...
Replies: 373
Views: 69,164
Posted By scott page

Download the 2.2.4 version of OpenTX Companion @...

Download the 2.2.4 version of OpenTX Companion @ http://www.open-tx.org/2019/07/11/opentx-2.2.4 and install on the computer. This will allow you to set your preferred settings and then downlod...
Replies: 373
Views: 69,164
Posted By scott page

I had the same issue with mine... concerned me...

I had the same issue with mine... concerned me for a moment... but...
The new firmware (2.3.2) is a product of OpenTX developers while the firmware that FrSky ships on the Tx is a FrSky mangled...
Showing results 1 to 7 of 7


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.