Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: eagledancer
Showing results 1 to 25 of 500
Search took 1.12 seconds.
Forum: Kit Building
06-09-2017, 12:11 PM
Replies: 2,281
Views: 186,644
Posted By eagledancer

i can also only see 1-99 on the list

i can also only see 1-99 on the list
10-27-2015, 01:55 PM
Replies: 2,049
Views: 318,239
Posted By eagledancer

i am also interested in how the new version...

i am also interested in how the new version preforms, not currently flying mine either, i had a issue with a elevator servo unplugging itself in flight caused a roll out of a turn and straight down....
10-23-2015, 02:32 PM
Replies: 1,010
Views: 232,067
Posted By eagledancer

I set thrust at 0-0 on this plane.

I set thrust at 0-0 on this plane.
05-24-2015, 07:05 PM
Replies: 1,010
Views: 232,067
Posted By eagledancer

if you have not yet glued the dowels in the...

if you have not yet glued the dowels in the center section you would be very wise to glue the dowels in the wing panels and have them slide into the center section! they are very easy to break off...
05-24-2015, 04:03 PM
Replies: 1,010
Views: 232,067
Posted By eagledancer

the way i did it was with a round file on the...

the way i did it was with a round file on the second rib then using a piece of ply with a hole in it glueing it in at the correct position for 3 degrees
03-17-2015, 04:17 PM
Replies: 395
Views: 45,275
Posted By eagledancer

well i best subscribe to this thread beings i...

well i best subscribe to this thread beings i just acquired one of these kits
01-06-2015, 02:47 PM
Replies: 1,315
Views: 336,568
Posted By eagledancer

i DO know that len, i had a half a tank or so of...

i DO know that len, i had a half a tank or so of fuel left in it and didnt feel like taking it out, its just a ARF anyway. so i figured slightly nose down to compensate for the fuel left in the tank...
01-06-2015, 04:03 AM
Replies: 1,315
Views: 336,568
Posted By eagledancer

engine is first place 2.3 plenty of power. no...

engine is first place 2.3 plenty of power. no video of the first 4 flights. day was very overcast which made it a little difficult to see the plane if i let it get out very far. very nice flying...
01-01-2015, 02:49 PM
Replies: 1,315
Views: 336,568
Posted By eagledancer

balanced slightly nose heavy with full tank of...

balanced slightly nose heavy with full tank of fuel. nice flying aircraft! did some playing around with flap/elevator mix and got that dialed in.
01-01-2015, 10:32 AM
Replies: 1,315
Views: 336,568
Posted By eagledancer

thank you so much!!!!!!!! now for test flights!

thank you so much!!!!!!!! now for test flights!
01-01-2015, 08:50 AM
Replies: 1,315
Views: 336,568
Posted By eagledancer

hey guys are there anyone still around? i need...

hey guys are there anyone still around? i need the cg point on this bird, just acquired one that is totally built and never flown, just got done changing over to spectrum radio and double checking...
Forum: Kit Building
12-31-2014, 03:59 AM
Replies: 2,281
Views: 186,644
Posted By eagledancer

jeffo try a zoar 30x14 on your reeves unit. i...

jeffo try a zoar 30x14 on your reeves unit. i found that prop worked the best on my camel
Forum: Kit Building
12-29-2014, 04:56 PM
Replies: 2,281
Views: 186,644
Posted By eagledancer

gear reduction is the only way to get that big of...

gear reduction is the only way to get that big of a prop on a 1/3 pup with that engine you have 2 choices that i know of mick reeves has a unit for a zenoah g-62 that is 1.75:1 biggest prop i was...
Forum: Kit Building
11-09-2014, 11:31 AM
Replies: 2,281
Views: 186,644
Posted By eagledancer

http://www.rcuniverse.com/forum/attachment.php?att...

http://www.rcuniverse.com/forum/attachment.php?attachmentid=2046060i guess i best get in line for a brotherhood # here is my BUSA 1/3 nieuport 28 in swiss markings
11-01-2014, 03:42 PM
Replies: 1,010
Views: 232,067
Posted By eagledancer

keep in mind with the reeves unit it actually...

keep in mind with the reeves unit it actually performs better with magnito ign. found mine performed best with a 30x14 xoar prop. and use a spring starter! with this setup prop is always in a...
11-01-2014, 09:55 AM
Replies: 1,010
Views: 232,067
Posted By eagledancer

hi AndyF put a high torque servo in each lower...

hi AndyF
put a high torque servo in each lower panel out in the wing directly in front of horn you wont like the tube set up. make sure you have LOTS of up and small amount of down on your ailerons...
Forum: The Clubhouse
06-26-2014, 03:38 PM
Replies: 123
Views: 6,264
Posted By eagledancer

just another step of the out of control...

just another step of the out of control government that wont follow the law
10-07-2013, 03:56 AM
Replies: 1,010
Views: 232,067
Posted By eagledancer

0-0 thrust is where i have set mine. and this is...

0-0 thrust is where i have set mine. and this is my second pup. wing and tail incidences set as per plans. i do use quite a bit of down elevator trim but have found this to be normal on most ww1...
Forum: The Clubhouse
09-11-2013, 04:16 PM
Replies: 41
Views: 2,461
Posted By eagledancer

our clubs dues include mowing fee, and one member...

our clubs dues include mowing fee, and one member gets paid to mow. works out very well
09-01-2013, 11:35 AM
Replies: 230
Views: 31,870
Posted By eagledancer

i have been using this system for almost 20 years...

i have been using this system for almost 20 years now on 1/4 scale and larger aircraft. it works well! 2 switches and 2 batterys. i always use 2000 batteries in parallel. or larger. yes thats right 2...
Forum: Kit Building
08-29-2013, 03:28 AM
Replies: 63
Views: 12,791
Posted By eagledancer

have you checked your engine thrust line? sounds...

have you checked your engine thrust line? sounds like it may be off. also check reflex of ailerons
Forum: RC Jets
08-18-2013, 12:49 PM
Replies: 379
Views: 16,970
Posted By eagledancer

here is my opinion, the problems the site has had...

here is my opinion, the problems the site has had in the recent past i have come to this site less and less. i am LESS then impressed with the site then with the LAST update. and i will continue to...
Forum: Gas Engines
07-24-2013, 03:30 PM
Replies: 39
Views: 2,851
Posted By eagledancer

RE: How does a gas engine act when hot?

from what i am seeing you will constantly have overheating issues with that install. your best bet is to invert the engine, ya i know it will suck for the scale looks but a dr1 deadstick is NOT FUN!
07-17-2013, 03:36 PM
Replies: 226
Views: 17,194
Posted By eagledancer

RE: OHIO DAWN PATROL 2013!

OH NO dont put a air compressor hose in there~no body can tell when someone passes gas!!
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.