RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: OEMFlyer
Showing results 1 to 25 of 81
Search took 0.69 seconds.
01-07-2013, 09:27 PM
Replies: 7
Views: 2,703
Posted By OEMFlyer

RE: Defective Gens ACE Lipo Batteries

Make that 2 2200 mhr 25c failed!
01-01-2013, 11:41 AM
Replies: 7
Views: 2,703
Posted By OEMFlyer

RE: Defective Gens ACE Lipo Batteries

I have at least one Gens Ace 2200mah 25c doing this. I have several more of various mah that I dont know about yet due to flying season being over until spring. Will keep you posted.
Replies: 5
Views: 2,974
Posted By OEMFlyer

RE: Eflite 110 info

Have you tried to set the throttle range on your esc? I am not familiar with the esc you are using but most esc's set as follows. First, for safety reasons remove the prop from the motor. Turn on...
01-18-2012, 08:25 PM
Replies: 4
Views: 1,228
Posted By OEMFlyer

RE: Need help programming flaperons on Dx6i, just won't work

What receiver do you have? If it is an AR500 ( 5channel) you cannot use flaperons. There are two aileron ports in this receiver but they are still only one channel. This was done so you could plug in...
03-20-2011, 08:14 PM
Replies: 1
Views: 747
Posted By OEMFlyer

RE: Using DX7 on simulator?

It depends on which simulator you plan on using. You can use it with the Pheonix simulators. Realflight simulators have propriatary controllers so you cannot use it with them. There may be others...
Replies: 6
Views: 2,525
Posted By OEMFlyer

RE: emax bl2826/06

I have this motor in a converted .40 size trainer (Hobbico Avistar). I have not measured thrust with it but it pulls this 5lb. plane along with authority. I run a 12 x 6 master airscrew "electric...
01-14-2011, 07:14 PM
Replies: 5
Views: 528
Posted By OEMFlyer

RE: aircraft 4 3 cell 2100mah lipos

There are a boatload of planes that you could use this size lipo in. Most are in the 32oz. flying weight range and 450 to 500 size brushless motors.
06-15-2010, 01:46 PM
Replies: 9
Views: 1,529
Posted By OEMFlyer

RE: Spektrum Recievers....

I don't know if it will work or not. This would be a question to ask Spektrum or Horizon hobby. If you are going to try this anyway, I would make sure it will pass a range check first.
04-02-2010, 05:53 PM
Replies: 2
Views: 764
Posted By OEMFlyer

RE: 55

I agree with dbc. I have the blue one and it flies very well. It probably tracks straighter on the ground than any of my planes. Just point it the direction you want to take off and go! I too think...
03-18-2010, 10:34 PM
Replies: 2
Views: 1,315
Posted By OEMFlyer

RE: Eflite 60 Amp Brushless esc

I usually try to keep about 10-15% below the rated amps. It's really not a good idea to over amp an esc, especially if you are using the esc's bec. If you smoke the esc in flight you will have zero...
03-14-2010, 04:53 PM
Replies: 1
Views: 1,179
Posted By OEMFlyer

RE: EC3 connector from Hobbyking

I dont Know about the ones from HobbyKing but the E-Flite EC3 connectors are rated for about 60 amps. If you want that same type of connector you can go to EC5's which are rated up to 120 amps. They...
01-10-2010, 09:19 PM
Replies: 5
Views: 2,059
Posted By OEMFlyer

RE: Parkzone T-28 vs Corsiar.

Tail draggers aren't nessisarily more difficult to take off and land just a little different. When taxiing a tail dragger it is best to keep up elevator on to keep pressure on the tail wheel so you...
12-17-2009, 09:07 PM
Replies: 9
Views: 940
Posted By OEMFlyer

RE: Wanting to fly, maybe...

Better yet, get a good simulator and practice- practice- practice. Then find a club and instructor like goirish said!
12-13-2009, 08:43 PM
Replies: 12
Views: 1,623
Posted By OEMFlyer

RE: Converting a largeish airplane to electric

Try running the motor for a short time and then after you shut it down and disconnect the battery, feel the motor shaft where it enters the motor on each end. If it is cool or the same temp as the...
12-12-2009, 09:13 PM
Replies: 4
Views: 960
Posted By OEMFlyer

RE: Beginner Question re wires from motor?

The three wires that come from the motor do indeed connect to the matching wires from the esc. The color coding of these wires means nothing. Connect these wires in any order and yor motor will run....
12-10-2009, 09:58 PM
Replies: 3
Views: 1,070
Posted By OEMFlyer

RE: Elevon problem..

I have a dx5e transmitter but I havent used it for a while. Your post got my curiosity up so I got it out to look. Sure enough it does have an elevon/delta mix. The switch is with the servo reversing...
12-08-2009, 09:11 PM
Replies: 3
Views: 4,871
Posted By OEMFlyer

RE: Lipo 3s minimum voltage

Ed:
You are correct. This is also called an "automatic detecting cut off"and this setting is set as the default on many escs. The problem with this is that if your battery is not fully charged...
12-03-2009, 06:03 PM
Replies: 20
Views: 2,638
Posted By OEMFlyer

RE: twin engine choices

I just finished an E-Flight Fairchild PT-19 ( 2lbs 4oz auw) that I powered with an emax 2815-09 along with an emax 40 amp esc. from toysonics.com. This motor is supposed to be in the 400-500 size...
12-01-2009, 12:19 AM
Replies: 2
Views: 1,002
Posted By OEMFlyer

RE: Best Pitts Plane

I have always been partial to the model 12 Pitts. IMO the radial engine Pitts planes are the nicest looking. E-Flite makes a balsa and ply arf with a 40" wingspan. You can check it out at Horizon...
11-15-2009, 09:18 PM
Replies: 2
Views: 1,672
Posted By OEMFlyer

RE: Midwest AT-6 Texan

All I can say is WOW! Beautiful planeGreat job.
11-15-2009, 09:09 PM
Replies: 1
Views: 577
Posted By OEMFlyer

RE: New ARF

Sounds great-keep us posted!
Replies: 2
Views: 626
Posted By OEMFlyer

RE: Brushless speed control

There is no good way to tell unless you can match it up to a known wattage esc like jzrf6c said. I think Hobby-Lobby sells some that are wrapped in black shrink wrap too. You can get a rough idea by...
11-08-2009, 09:29 AM
Replies: 5
Views: 1,191
Posted By OEMFlyer

RE: SPEKTRUM DX5e question

Yes, as long as it is a Spectrum DSM2 receiver.
11-05-2009, 09:05 PM
Replies: 7
Views: 2,101
Posted By OEMFlyer

RE: Equivalent motor for the Eflite 480

Toysonics.com has Emax bl motors. I think the 2810 or 2815 would be in that size range. I have a smaller one (2210) and a larger one (2826). I have had very good luck with both. Very strong...
10-31-2009, 04:50 PM
Replies: 9
Views: 3,198
Posted By OEMFlyer

RE: E-Flite's new Bonanza A36 of F33V. EP

I think the rule is to go down 1 size in diameter or 1 size in pitch.
Showing results 1 to 25 of 81
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.