RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: gooseF22
Showing results 1 to 25 of 500
Search took 0.63 seconds.
Forum: RC Jets
05-21-2019, 02:39 AM
Replies: 1,573
Views: 176,460
Posted By gooseF22

My jet setup with the CB200 is as follows, and it...

My jet setup with the CB200 is as follows, and it works very well.. (lots of ways to skin the cat)

CB200 rX1 - A Rex 12, with a Rex900 plugged into it directly with a failover active on the E2...
Forum: RC Jets
02-24-2019, 07:55 PM
Replies: 736
Views: 85,994
Posted By gooseF22

Ok.. understand.. you have given it some thought...

Ok.. understand.. you have given it some thought and experience.. my experience with the has not been so good, so I punted, and fell back on the ECU telemetry.

have fun flying.. the telemetry is...
Forum: RC Jets
02-24-2019, 07:53 PM
Replies: 736
Views: 85,994
Posted By gooseF22

Really isn't the thread for it, but No I dont...

Really isn't the thread for it, but No I dont have a starting place. I just went with the default value to start with, dont remember what it is. Its a trial and error process.. ratio of current...
Forum: RC Jets
02-23-2019, 07:28 PM
Replies: 736
Views: 85,994
Posted By gooseF22

Kekelala Strongly recommend you remove the Jeti...

Kekelala
Strongly recommend you remove the Jeti MFlow from your setup.. it doesn't work on the suction side at all. It will cause you a flameout guaranteed. Its designed for the pressure side. and...
Forum: RC Jets
02-21-2019, 05:26 PM
Replies: 501
Views: 104,946
Posted By gooseF22

Well.. This day finally came... After Hundreds...

Well.. This day finally came... After Hundreds and hundreds of flights on my old Boomer Elan, she was retired today.. It was mothballed with the radio gear, and fuel system in tact, but the motor...
Forum: RC Jets
02-21-2019, 05:12 PM
Replies: 1,573
Views: 176,460
Posted By gooseF22

oh my that's Purdy David!

oh my that's Purdy David!
Forum: RC Jets
02-21-2019, 05:09 PM
Replies: 14
Views: 1,019
Posted By gooseF22

LOL.. nicht!

LOL.. nicht!
Forum: RC Jets
12-21-2018, 08:42 AM
Replies: 3
Views: 599
Posted By gooseF22

Jeti DS-12 Transmitter

AeroPanda is accepting Pre orders on the new Jeti DS-12, mid level transmitter.
It has a single 2.4 module and a 900MHz module and its priced very nicely!
Check it out!
...
Forum: RC Jets
10-21-2018, 06:44 AM
Replies: 6,460
Views: 1,177,056
Posted By gooseF22

I had a 100 powered Bandit and 100 powered...

I had a 100 powered Bandit and 100 powered flash.. both were Plenty fast and flew off grass. Alas, my old eyes struggle with them these days, but sure loved that flash. Its fast, tough, slows down...
Forum: RC Jets
10-14-2018, 05:17 AM
Replies: 12
Views: 816
Posted By gooseF22

reduce the feed to pump voltage to a 2S Lipo or...

reduce the feed to pump voltage to a 2S Lipo or so around 8v.. problem will probably go away.. using 12 volts is too much for that pump in my opinion, even with the speed controller.

I have talked...
Forum: RC Jets
10-14-2018, 05:14 AM
Replies: 46
Views: 2,160
Posted By gooseF22

Bob, it was great.. Thank you for the great...

Bob, it was great.. Thank you for the great time.. Things ran very smoothly due to your club and teams leadership.. there was tons of flying and it was great to see all the bubbas one last time...
Forum: RC Jets
10-08-2018, 05:24 AM
Replies: 13
Views: 2,254
Posted By gooseF22

Rumor has it that the 140 Harlock viperJet/ M70...

Rumor has it that the 140 Harlock viperJet/ M70 combo is a large beast in a small wrapper. :)
Forum: RC Jets
10-02-2018, 06:09 AM
Replies: 797
Views: 86,280
Posted By gooseF22

This is the exact setup I am running on my...

This is the exact setup I am running on my Havoc.. the 2.4's are presently in Dual path for the first dozen flights, then I will move 2.4's to default / clone.
What Im finding is the second 2.4...
Forum: RC Jets
09-09-2018, 08:30 AM
Replies: 1,573
Views: 176,460
Posted By gooseF22

there is an additional backup tone emitted when...

there is an additional backup tone emitted when it goes to 900 High in addition to signal lost. Look in the config
Forum: RC Jets
09-09-2018, 07:12 AM
Replies: 21
Views: 1,006
Posted By gooseF22

they sag too much IMO.. I tested them for awhile,...

they sag too much IMO.. I tested them for awhile, and ended going back to a small lipo, and making it easy to swap.. I tried to build or redo all my planes so that its easy to pull the packs, since...
Forum: RC Jets
09-09-2018, 07:08 AM
Replies: 58
Views: 4,016
Posted By gooseF22

Great seeing everyone, too bad we only got a...

Great seeing everyone, too bad we only got a little flying in, thanks to the vendor support, it was outstanding!.. see ya'll next yr.
Forum: RC Jets
09-06-2018, 07:48 PM
Replies: 58
Views: 4,016
Posted By gooseF22

just arrived, Nick and dwayne right behind me

just arrived, Nick and dwayne right behind me
Forum: RC Jets
08-18-2018, 04:33 PM
Replies: 58
Views: 4,016
Posted By gooseF22

See you guys thursday.. Im bringing the Camper...

See you guys thursday.. Im bringing the Camper this time.
Forum: RC Jets
07-28-2018, 04:50 PM
Replies: 58
Views: 4,016
Posted By gooseF22

I think Im campering in this yr. not sure yet

I think Im campering in this yr. not sure yet
Forum: RC Jets
07-19-2018, 05:21 PM
Replies: 58
Views: 4,016
Posted By gooseF22

bump.. see you there

bump.. see you there
Forum: RC Jets
07-15-2018, 07:11 PM
Replies: 797
Views: 86,280
Posted By gooseF22

rebind the receivers to the transmitter first

rebind the receivers to the transmitter first
Forum: RC Jets
07-15-2018, 06:29 PM
Replies: 15
Views: 1,309
Posted By gooseF22

It depends on what you are going to do with it.....

It depends on what you are going to do with it.. I find that most jets don't need that much capability, and that a CB200 will do the job, or a combination of 200 and 100's. But the CB400 is pretty...
Forum: RC Jets
07-08-2018, 05:08 AM
Replies: 6
Views: 514
Posted By gooseF22

Put a servo on the throttle channel to see if its...

Put a servo on the throttle channel to see if its moving smoothly and getting stable input.. usually its a bad extension when that happens
Forum: RC Jets
07-07-2018, 08:09 PM
Replies: 1,573
Views: 176,460
Posted By gooseF22

Then the cB200 is bad

Then the cB200 is bad
Forum: RC Jets
07-07-2018, 03:47 AM
Replies: 1,573
Views: 176,460
Posted By gooseF22

Unplug that battery and see if the amps transfer...

Unplug that battery and see if the amps transfer to the other channel.. If they dont, then you have a bad CB200 pretty simple actually
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.