Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: planeguy52
Showing results 1 to 13 of 13
Search took 0.66 seconds.
12-12-2019, 12:30 PM
Replies: 1
Views: 709
Posted By planeguy52

Has anybody mentioned that you also need two...

Has anybody mentioned that you also need two independent power supplies for your chargers.
Forum: Marketplace
04-20-2019, 08:55 PM
Forum: Marketplace
04-15-2019, 07:14 PM
Forum: Marketplace
02-11-2019, 03:10 PM
Replies: 1
Views: 264
Posted By planeguy52

14sg

Hi Jose, I can offer $325 shipped to 49829
Forum: Marketplace
10-11-2018, 07:56 PM
Replies: 5
Views: 633
Posted By planeguy52

which parts do you need?

which parts do you need?
11-16-2014, 05:55 AM
Replies: 20
Views: 2,602
Posted By planeguy52

Balsa USA, sets of 6 and 12 inch bits. The BEST.

Balsa USA, sets of 6 and 12 inch bits. The BEST.
Forum: Gas Engines
07-08-2013, 07:23 PM
Replies: 6,363
Views: 679,769
Posted By planeguy52

RE: SYSSA 30CC GAS MADE IN USA

I also have a syssa 30 in a 110 Rascal. You need to force feed air into the top of the cowl. I used a pair of scoops similar to the type on a Cub. Your carb is pulling hot air right over the muffler...
07-28-2009, 10:43 PM
Replies: 9
Views: 884
Posted By planeguy52

RE: max spinner rpm

Thanks for the info guys, Tru turn it is.
07-27-2009, 08:31 PM
Replies: 9
Views: 884
Posted By planeguy52

max spinner rpm

Hi guys, I am mounting a Jett 60lx on a Balsa USA Northstar and would like to run a 2 1/4 inch plastic Dubro spinner to match the cowl. Jett claims up tp 18k rpm. I need info on safe rpm for...
07-03-2009, 10:49 AM
Replies: 1
Views: 481
Posted By planeguy52

10 c throttle slow function

Going "buy the book" and cannot get throttle slow function to work on 10 c in acro mode. Need Help.
Replies: 0
Views: 569
Posted By planeguy52

hacker b40 8 L pole number ?

I want to set up the gov. function on my Shulze speed control and need to know the number of poles in the Hacker B40 8L motor.
09-11-2006, 08:24 AM
Replies: 1,825
Views: 244,248
Posted By planeguy52

RE: H9-F6F Hellcat 60 ARF

Thanks D. After we made the trade you tell me the Cat is JUNK. Have fun with the Cub. DB
01-09-2005, 08:39 PM
Replies: 8
Views: 775
Posted By planeguy52

RE: What no steering?.

Hitec had an update out to use a longer screw to mount the servo arm. Make sure the screw goes in just past the top of the case. DB
Showing results 1 to 13 of 13


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.