RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: wingster
Showing results 1 to 25 of 212
Search took 0.75 seconds.
05-25-2022, 12:58 PM
Replies: 2
Views: 617
Posted By wingster

I contacted Plettenberg a few month ago. They...

I contacted Plettenberg a few month ago. They will make the motor on request. Approximately $1000! I don't think they are stocking any of their RC motors.
03-24-2022, 11:45 AM
Replies: 8
Views: 1,453
Posted By wingster

stickman/vic I sent you a private message.. ...

stickman/vic
I sent you a private message..

Thanks
Wingster.
01-20-2022, 10:24 AM
Replies: 8
Views: 1,453
Posted By wingster

The Flywheelz in the following link look like a...

The Flywheelz in the following link look like a good alternative to the Maxx wheels, but the 2-2.5" wheels haven't been in stock for months.

https://www.spotonrc.com/all-products
11-09-2021, 02:22 PM
Replies: 55
Views: 15,522
Posted By wingster

Thanks Looks interesting.

Thanks

Looks interesting.
11-08-2021, 09:47 AM
Replies: 55
Views: 15,522
Posted By wingster

Isaac Anything special about the zip ties...

Isaac

Anything special about the zip ties used to secure the battery tray? I'm always concerned about the strength of the zip ties.

John
02-28-2021, 01:50 PM
Replies: 152
Views: 64,572
Posted By wingster

To begin with I would mount the motor to the...

To begin with I would mount the motor to the wooden mount and temporarily install in the fuselage and check the clearance from backplate to the front of fuselage is adequate. You may need additional...
06-22-2020, 06:40 AM
Replies: 16
Views: 1,698
Posted By wingster

The two antennas are orientated at 90 degrees to...

The two antennas are orientated at 90 degrees to each other but are close together. Ideally they should be located farther apart.
04-01-2020, 07:12 PM
Replies: 4
Views: 1,095
Posted By wingster

The receiver battery should be connected while...

The receiver battery should be connected while setting the throttle.
01-24-2020, 08:02 PM
Replies: 17
Views: 6,719
Posted By wingster

How is the down line speed compared to the contra...

How is the down line speed compared to the contra setup?
08-17-2019, 03:05 PM
Replies: 7
Views: 4,630
Posted By wingster

It's a 42 pole motor, probably losing commutation...

It's a 42 pole motor, probably losing commutation synchronization as others have had with high pole count motors. You might try a jeti mezon esc which seem to do better with high pole count motors.
08-12-2019, 07:38 AM
Replies: 19
Views: 2,305
Posted By wingster

Looks like a Himax. Himax Brushless Motors...

Looks like a Himax.

Himax Brushless Motors 30-200 Watts (http://www.maxxprod.com/mpi/mpi-26.html)
05-29-2019, 04:44 AM
Replies: 23
Views: 9,677
Posted By wingster

Composite fuselage with film covered wings. I...

Composite fuselage with film covered wings. I found some other pictures which indicates BJ Craft construction.

SkyLeaf Leader “·‘Ì“h‘••Žå”ö—ƒƒtƒBƒ‹ƒ€“\‚è(ARF)+RSƒpƒbƒN•t+ŒÀ’èƒLƒƒƒŠƒ“ƒOBOX•t...
01-24-2019, 09:44 AM
Replies: 10
Views: 3,378
Posted By wingster

Google Translation Sounds like the Mezon...

Google Translation

Sounds like the Mezon controllers are overrated.

eason:
1. Mezon controllers are constructed differently than e.g. Master SPIN controller. Both
MEZON's only a few power...
07-21-2018, 02:49 PM
Replies: 377
Views: 58,887
Posted By wingster

I just received the Futaba version(MC9100A) from...

I just received the Futaba version(MC9100A) from Perth RC in Austraila. Shipping was about $25 and the price is reduced 10% because of the VAT tax. The price is in Aussie dollars so multiply by...
04-05-2018, 01:20 PM
Replies: 33
Views: 13,490
Posted By wingster

"I have noticed some cables (not Brodak) for...

"I have noticed some cables (not Brodak) for pull-pull are coated - what advantage might that be for our purpuse?"

You can wrap the ends a couple of times and use a match to melt the coating. ...
07-01-2017, 06:14 AM
Replies: 14
Views: 5,895
Posted By wingster

swk550 Nice info. The geared inrunners seem...

swk550

Nice info. The geared inrunners seem to have more torque with better verticals and less throttle management.
06-02-2017, 04:06 PM
Replies: 14
Views: 5,895
Posted By wingster

FinnSpeed, flyingtexan Thanks for your...

FinnSpeed, flyingtexan

Thanks for your input.

On my last flight on the Neu motor my prop and spinner flew off. This happened to me once before when the motor locked up. Before the flight the...
05-24-2017, 10:20 AM
Replies: 14
Views: 5,895
Posted By wingster

Any updates on performance and durability? ...

Any updates on performance and durability?

I'm looking to replace a Neu F3a geared motor which has once again failed. I was running a Falcon 3 blade 19.5x13 prop in an Allure. I really liked the...
04-14-2017, 12:26 PM
Replies: 9
Views: 2,260
Posted By wingster

As long as the cross wind is steady it will still...

As long as the cross wind is steady it will still fly a straight line if the rudder trim is correct.
04-13-2017, 05:23 PM
Replies: 9
Views: 2,260
Posted By wingster

Try flying directly away from you or towards you....

Try flying directly away from you or towards you. If the planes in a straight line the rudder trim is confirmed. A curved path indicates the rudder trim is not correct.
04-10-2017, 05:34 PM
Replies: 9
Views: 2,260
Posted By wingster

Before you make thrust adjustments you might want...

Before you make thrust adjustments you might want to make sure your rudder trim isn't off a couple of clicks.
11-02-2015, 01:46 PM
Replies: 732
Views: 176,334
Posted By wingster

Jason Thanks, 2 milliohms is excellent,...

Jason

Thanks, 2 milliohms is excellent, especially for a light pack.

John
11-02-2015, 06:34 AM
Replies: 732
Views: 176,334
Posted By wingster

Jason Do you have any IR data on the Dualsky...

Jason

Do you have any IR data on the Dualsky 4600 packs?
09-10-2014, 06:26 PM
Replies: 6
Views: 1,643
Posted By wingster

The Radio South springs are stiffer than the...

The Radio South springs are stiffer than the Futaba HD springs. On my 12FG I use the Futaba HD springs adjusted to maximum or near maximum.
09-02-2014, 02:35 PM
Replies: 14
Views: 2,276
Posted By wingster

Great!

Great!
Showing results 1 to 25 of 212
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright © 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.