RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: buck1856
Showing results 1 to 3 of 3
Search took 0.06 seconds.
05-21-2009, 11:07 PM
Replies: 15
Views: 1,636
Posted By buck1856

RE: Quadras, roller main bearings, questions...

Its the pic of the early Quadra 35.The rear bolts that hold the mount on.The top 2 are closer together than the bottom 2.
05-20-2009, 09:57 PM
Replies: 15
Views: 1,636
Posted By buck1856

RE: Quadras, roller main bearings, questions...

Heres a pic of the crank,ect...
You can see the thrust washers next to the bearing.They have a grove cut into the case to support them.
The seals are on the outside.
What i would dois make 2...
05-19-2009, 11:24 PM
Replies: 15
Views: 1,636
Posted By buck1856

RE: Quadras, roller main bearings, questions...

Well,since i know you have a lathe,heres what i would do.
Locate one of my brass punches.I have some fairly large ones for large bushings and bearings,ect..
Drill center out to fit crank.
Face off...
Showing results 1 to 3 of 3


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.