RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: gas-flyer
Showing results 1 to 25 of 29
Search took 0.11 seconds.
05-13-2015, 08:51 AM
Replies: 7
Views: 3,054
Posted By gas-flyer

Thanks Mr. Bob T Sounds like I should be in the...

Thanks Mr. Bob T
Sounds like I should be in the window of where it needs to be, very close to what you have presented. Thanks for the info and I will let you know how the new maiden turns out.
05-13-2015, 06:33 AM
Replies: 7
Views: 3,054
Posted By gas-flyer

-1 to -1.5 was the top wing

-1 to -1.5 was the top wing
05-13-2015, 06:30 AM
Replies: 7
Views: 3,054
Posted By gas-flyer

After the first few flights and knowing it was a...

After the first few flights and knowing it was a bit pitchy, certain that the cg was right. I put the meter back on it. My research discovered that it should have the lower wing and stab at 0 degrees...
05-12-2015, 08:43 AM
Replies: 7
Views: 3,054
Posted By gas-flyer

Here she is finished. It is a little pitchy so I...

Here she is finished. It is a little pitchy so I check my incidences and found the wings were a little to the positive. Hoping to get her out this week end a see how it has changed. Really look nice...
05-04-2015, 07:19 PM
Replies: 7
Views: 3,054
Posted By gas-flyer

Pitts Challenger II Plus Ultimate = Ulti pitts

So I had a Pitts Challenger II that I could not get off the ground with out the "P" factor kicking my but and U turning into the ground. Played with CG and wing incidence to no success. On the four...
Forum: ARF or RTF
03-27-2015, 09:08 AM
Replies: 19
Views: 1,262
Posted By gas-flyer

I have HD servos in two 30cc birds, a Dynaflight...

I have HD servos in two 30cc birds, a Dynaflight Decathlon and a scratch built 3-D bipe and have had zero problems. For the price and experience with their performance I will continue to use them.
01-13-2015, 12:41 PM
Replies: 16
Views: 951
Posted By gas-flyer

Holly SI-FI Batman that is crazey

Holly SI-FI Batman that is crazey
01-12-2015, 03:21 PM
Replies: 15
Views: 1,144
Posted By gas-flyer

Right that would be $300 + each

Right that would be $300 + each
01-12-2015, 02:04 PM
Replies: 15
Views: 1,144
Posted By gas-flyer

The engines in it now are old OS FP 25 with APC...

The engines in it now are old OS FP 25 with APC 9x6. I've been running 35% helo fuel and it goes pretty good. Thought about a pair of ASP 32's and running 8x7s. I think zinger has that prop in both...
01-08-2015, 03:20 PM
Replies: 15
Views: 1,144
Posted By gas-flyer

The reason I went the way I did is the limited...

The reason I went the way I did is the limited number sizes of pusher props. I wonder if I could get 35's in with out major mods.
01-08-2015, 02:03 PM
Replies: 15
Views: 1,144
Posted By gas-flyer

Thought about adding guns, rocket and bombs

Thought about adding guns, rocket and bombs
01-07-2015, 02:25 PM
Replies: 15
Views: 1,144
Posted By gas-flyer

WS 54 L 48 Its a one piece aircraft I wish I had...

WS 54 L 48 Its a one piece aircraft I wish I had done it differently by it fits in my little pick up and it fly's like a pattern bird. All said I would like to up graded the eng's to double bearings...
01-07-2015, 01:14 PM
Replies: 17
Views: 1,000
Posted By gas-flyer

MJD you mentioned a push pull setup. Take a look...

MJD you mentioned a push pull setup. Take a look at "Something Different" on the twin forum.
01-07-2015, 07:59 AM
Replies: 9
Views: 942
Posted By gas-flyer

yep flaperons and flaps mixed to elev. The first...

yep flaperons and flaps mixed to elev. The first flight was kinda scary. After the launch and some altitude I rolled left for a turn> resulting one and half rolls and a loop, later I tamed the throws...
01-06-2015, 02:39 PM
Replies: 15
Views: 1,144
Posted By gas-flyer

Something different

I call her Nitro Swoop. Power is 2 FP 25 and full 4 channel with rudders. Fly's like its on rails and with knife edge all day....
01-06-2015, 01:11 PM
Replies: 9
Views: 942
Posted By gas-flyer

Thanks for the good words, I draw up most...

Thanks for the good words, I draw up most everything I build any more. I don't thing the word "kit" is around much anymore and I usually don't do ARFs. Unless they are of the best quality and that...
01-06-2015, 11:40 AM
Replies: 51
Views: 2,928
Posted By gas-flyer

Hey CP check the XB-70 on the scratch built forum

Hey CP check the XB-70 on the scratch built forum
01-06-2015, 11:39 AM
Replies: 51
Views: 2,928
Posted By gas-flyer

Here's to the little screamer, tishhhhhh,...

Here's to the little screamer, tishhhhhh, glug,glug,glug!!! Ahhhhh
01-06-2015, 07:58 AM
Replies: 51
Views: 2,928
Posted By gas-flyer

Looks like I woke up the nest and some flash...

Looks like I woke up the nest and some flash backs. The Tripps was based on the CP V-tail sheet wing racer. I glad I'm not the only one that see this as a challenge.
01-06-2015, 07:49 AM
Replies: 8
Views: 610
Posted By gas-flyer

Thanks guys, I do fly glow, gas, and a little...

Thanks guys, I do fly glow, gas, and a little electric. Just don't tell anyone!
01-05-2015, 02:37 PM
Replies: 8
Views: 610
Posted By gas-flyer

Thanks, it came in right at 10 oz.

Thanks, it came in right at 10 oz.
01-05-2015, 11:46 AM
Replies: 9
Views: 942
Posted By gas-flyer

XB-70 Any one

Here is my version of a XB-70. I won a Radjet 800 (fun jet clone) in a club raffle and decided to strip all the gear out and let my grandson throw it around the house. This is what I came up with....
01-05-2015, 11:36 AM
Replies: 8
Views: 610
Posted By gas-flyer

Norvel .061 , master air screw 6x3, 4-hs55,4-aaa...

Norvel .061 , master air screw 6x3, 4-hs55,4-aaa pack. All monokote
01-05-2015, 11:07 AM
Replies: 8
Views: 610
Posted By gas-flyer

Remember The Hafwit?

Always wanted to 3d with 1/2a power and after seeing the Hafwit I decided to give it a try. I'm sorry but the Hafwit is kind of well ugly, so I reshaped it to look like an Edge. Fly's great and yes...
01-05-2015, 07:27 AM
Replies: 51
Views: 2,928
Posted By gas-flyer

Thank you to CP and MJD for sticking up for the...

Thank you to CP and MJD for sticking up for the new guy. No its not a 200 mph bird but it was a challenge to build it as sleek and lite as possible. So CP you asked about the elev linkage, its a...
Showing results 1 to 25 of 29
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.