RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: can773
Showing results 1 to 25 of 500
Search took 0.85 seconds.
06-10-2020, 01:45 PM
Replies: 18
Views: 6,519
Posted By can773

Hi Jim, Yes it is the D3 controller, Adam...

Hi Jim,

Yes it is the D3 controller, Adam Debowski produces them out of Poland. There were a few in use at the WC in 2019, Onda from the Japanese team was using it, I was using it, as well as a...
08-15-2019, 10:08 PM
Replies: 34
Views: 8,855
Posted By can773

Hi Mavros Best three final placings of your...

Hi Mavros
Best three final placings of your team added together, any combination of junior or senior counts. Lowest score wins. Title defenders are not included.
If you have less than three member...
11-02-2017, 06:28 PM
Replies: 48
Views: 23,570
Posted By can773

Most of P-17, obviously quite a strong wind on...

Most of P-17, obviously quite a strong wind on this flight!

http://www.youtube.com/watch?v=4enIHyWH1SE
10-30-2017, 07:19 PM
Replies: 3
Views: 3,667
Posted By can773

The main reason is the knife edge performance,...

The main reason is the knife edge performance, the biplanes have an advantage over most if not all monoplanes (canalizer or not).

For guys flying the FAI F sequence, and unknowns the biplanes...
09-16-2017, 06:29 AM
Replies: 49
Views: 7,510
Posted By can773

I heard the entry was in the mid 70's, in 2007 I...

I heard the entry was in the mid 70's, in 2007 I believe it was 78, so that would be comparable. I just think its a long trip and a bad time of year for many countries.

Most of the WC I have been...
09-15-2017, 04:02 PM
Replies: 49
Views: 7,510
Posted By can773

I have also heard only 10 judges because of the...

I have also heard only 10 judges because of the entry.

Chad
09-04-2017, 09:20 AM
Replies: 17
Views: 4,271
Posted By can773

Hi Andrew, I made my box here using a 50m...

Hi Andrew,

I made my box here using a 50m distance, then verified it with the 150m distance. My marked lines using the 50m distance were so close I was within maybe 1m of the pole location...
07-26-2016, 06:28 AM
Replies: 205
Views: 36,831
Posted By can773

I ran the heaviest packs I had (1255g) at the...

I ran the heaviest packs I had (1255g) at the Nats this year, just to get my Acuracy right up as close to 5050g as I could get :-) Derek said I was 5020g, and I was even thinking about adding...
07-22-2016, 05:33 AM
Replies: 205
Views: 36,831
Posted By can773

haha, probably not! They will just stop making...

haha, probably not! They will just stop making them and move on! :)
07-21-2016, 06:00 AM
Replies: 205
Views: 36,831
Posted By can773

High markup is everywhere in the world, I am...

High markup is everywhere in the world, I am surprised no one complains about Apple, as probably most people reading this own or have owned an iPhone (me included), and some probably even go out and...
04-25-2016, 05:04 AM
Replies: 205
Views: 36,831
Posted By can773

Spill the beans Alejandro!

Spill the beans Alejandro!
08-01-2015, 08:56 AM
Replies: 9
Views: 3,231
Posted By can773

I changed from Mode 2 to Mode 4 (or 3 depending...

I changed from Mode 2 to Mode 4 (or 3 depending on who you ask) about 15 years ago, and have never looked back. IMO its a plus for F3A flying, and makes rolling maneuvers less work. Obviously there...
06-14-2015, 06:16 AM
Replies: 732
Views: 176,272
Posted By can773

Hi Jim I don't know how it compares to the...

Hi Jim

I don't know how it compares to the Neu, since I haven't used one. However, the Pletty contra, compared to the Advance....is hard to compare. The RPM range of the single prop is wider, so...
Forum: RC Jets
05-12-2015, 07:38 PM
Replies: 615
Views: 129,168
Posted By can773

+1 the air gear and built up wings are just fine....

+1 the air gear and built up wings are just fine. With the spring change there is no reason not to use them, unless you really want to stay away from a pneumatic set for whatever reason.
Forum: RC Jets
04-07-2015, 05:15 PM
Replies: 8
Views: 1,181
Posted By can773

The 7003SB are FAASTest Rx's and unfortunately...

The 7003SB are FAASTest Rx's and unfortunately are not compatible with the 14Z or 12Z radios, only the 14SG and 18Z.

http://www.futaba-rc.com/receivers/fhss-s-fhss-compat.html
03-10-2015, 03:04 PM
Replies: 12
Views: 7,236
Posted By can773

Hi Jim, I have not played with the start...

Hi Jim,

I have not played with the start power on the Jeti Spin, so I don't know what options are available. With the Advance motor and Auto setting it starts very smooth, so have never had a...
03-05-2015, 12:38 PM
Replies: 12
Views: 7,236
Posted By can773

Here is what I use with the Jeti Spin, should be...

Here is what I use with the Jeti Spin, should be similar I would guess. I still adjust the endpoints on the 18 to get it exactly right, but it will get you close.

Temp Protection - 100C
Brake -...
02-21-2015, 09:25 AM
Replies: 2
Views: 735
Posted By can773

I think it was either a 63A012, or 64A012, I just...

I think it was either a 63A012, or 64A012, I just can't remember where the highpoint may have been. But one of those should be pretty close.

Chad
02-12-2015, 11:56 AM
Replies: 43
Views: 16,316
Posted By can773

Good choice Mark! Glad to know I am not alone...

Good choice Mark! Glad to know I am not alone with my thoughts :)
02-12-2015, 11:55 AM
Replies: 43
Views: 16,316
Posted By can773

Hi Scott, I think that the 19.5x13 is...

Hi Scott,

I think that the 19.5x13 is certainly worth a try for you, on the few flights I have had so far (winter you know!) I really like its speed presentation. So I think if you are going for...
02-11-2015, 07:37 PM
Replies: 43
Views: 16,316
Posted By can773

I have tried a few of the three blades available....

I have tried a few of the three blades available. I have until recently always seem to end up back to the two blade props, so I think its very much a matter of preference. I have found that the...
02-04-2015, 08:46 AM
Replies: 16
Views: 2,503
Posted By can773

Hi Issac, The Canadian seller for Powerbox...

Hi Issac,

The Canadian seller for Powerbox just orders them at the higher voltage. They will do anything you want, we first started out at 6.8-6.9V, then I had 7.2V, I think the new ones he is...
01-29-2015, 02:54 PM
Replies: 2,027
Views: 592,913
Posted By can773

Oh, for a second there I thought you had 4 prop...

Oh, for a second there I thought you had 4 prop blades!
01-29-2015, 02:35 PM
Replies: 2,027
Views: 592,913
Posted By can773

JAS....whaaaat is that?!

JAS....whaaaat is that?!
01-29-2015, 02:34 PM
Replies: 16
Views: 2,503
Posted By can773

I use a Futaba BLS 171SV on rudder, I also use a...

I use a Futaba BLS 171SV on rudder, I also use a digiswitch that is regulated to 7.2V.

The 171SV servo is rated for 164 oz-in at 7.4V, I can't notice any reason why you would need more than that. ...
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.