Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: TerrellFlyer
Showing results 1 to 25 of 500
Search took 0.73 seconds.
Forum: The Clubhouse
09-18-2008, 10:49 AM
Replies: 98
Views: 14,705
Posted By TerrellFlyer

RE: Building a runway

our field is outside Dallas,Tex.,and on an old dump site.We have a grass ,[bermuda] runway and a petromat runway. The petro is about 5 years old now and is a little scary to walk on because as the...
Forum: Sport Flying
06-21-2008, 09:51 PM
Replies: 9
Views: 1,777
Posted By TerrellFlyer

RE: Can aerobatics cause damage?

that is the down side of 3D and hard hotdogging,but the thrill is still worth the damage or sometimes destroyed plane.In a couple dozen years of aerobatics,I've lost covering on 4/5 times with...
02-12-2008, 05:01 PM
Replies: 14
Views: 1,404
Posted By TerrellFlyer

RE: New Lanier stinger

my stinger is somewhere between 10 and 15 years old,afriend wrecked it[his first plane]and was going to throw it in the trash.I rebuild the plane with lighting holes every place ,replaced landing...
Forum: Beginners
02-10-2008, 02:51 PM
Replies: 12
Views: 636
Posted By TerrellFlyer

RE: fuel ? for TT pro 46

low speed adjustment-idle is a tad rich,squeeze fuel line,engine should be adjusted to speed up slightly at low,if speeds up a lot engine is to rich,if engines dies fast ,engine is to lean,after...
Forum: Beginners
02-03-2008, 05:27 PM
Replies: 10
Views: 1,019
Posted By TerrellFlyer

RE: What do you think about Balsa USA Stick plus 40?

my stick 40 plus has couple years of flying on it and as a trainer I think it's a good plane,easy to build ,easy to fly and great price.Mine is a taildragger,servo in each aileron,os48 fs w/2 degree...
Forum: Beginners
03-30-2007, 01:36 PM
Replies: 26
Views: 3,154
Posted By TerrellFlyer

RE: First build: Venture 60 vs Sig 4* 60

:) same designer; but bruce ownes bte which makes the venture,I,ve had both and the venture wins hands down. the wood and the fit is a work of art,the flying of the venture is far superior;also Bruce...
Forum: Beginners
03-30-2007, 01:12 PM
Replies: 46
Views: 3,332
Posted By TerrellFlyer

RE: Torque on Takeoff Causing Big Trouble!

free advice:have 2 or 3degrees of right thrust on the engine, toe in on the mains, low rate with rudder,add expo if your radio is so equiped,tail wheel isn't that big a deal,hold up elevator,build...
04-17-2005, 12:35 PM
Replies: 38
Views: 3,648
Posted By TerrellFlyer

RE: How do you start your gas engine?

[8D]easy to start engines I use welder's glove on hand,prop @ 2,TEMPERMENTAL engines I use use an electrical starter
Forum: Beginners
02-08-2004, 07:05 PM
Replies: 8
Views: 607
Posted By TerrellFlyer

RE: Please help

a strip of fiber glass cloth is what you need,2"wide and 1 to 2 oz.weight should be enough,wrap the joint then epoxy or thin ca applied on the cloth will do the job. If using ca thin cover a finger...
Forum: Beginners
02-07-2004, 01:45 PM
Replies: 8
Views: 607
Posted By TerrellFlyer

RE: Please help

Hi ICE_MAN,your spinner will work fine,might need to enlarge the holes for the prop.;)
Forum: Beginners
02-06-2004, 04:31 PM
Replies: 14
Views: 915
Posted By TerrellFlyer

RE: It Flies!!!

Hi ZimboRaider, on the Eagle the fuel tank end with the line openings should face the engine,about the only time this set up changes is when using a pusher engine set up,the eagle is a tractor set...
Forum: Beginners
02-06-2004, 10:16 AM
Replies: 21
Views: 1,322
Posted By TerrellFlyer

RE: Are these good trainers?

from those choices I would go with the Tower Trainer,lighter and easier to control,the other two are more sturdy but harder to control because of wing loading,I assume an instructor is involved then...
Forum: Beginners
02-06-2004, 10:08 AM
Replies: 14
Views: 915
Posted By TerrellFlyer

RE: It Flies!!!

Congrats on the plane and the flight,loved the pic,has been raining and at night is freezing
Forum: Beginners
02-06-2004, 09:52 AM
Replies: 5
Views: 679
Posted By TerrellFlyer

RE: Engine Test Stand

On a 120 or smaller engine,I cut the space to mount the engine on a 1x4 by a couple feet long,bolt or screw the engine beams to the cut out mount,add a tank behind the engine,and a long wire for...
Forum: Beginners
02-06-2004, 09:40 AM
Replies: 10
Views: 568
Posted By TerrellFlyer

RE: Tach or Heat sensor ?

I use the GloBee tach for the last three years,but'm sure there are as good or better on the market.
Forum: Beginners
01-30-2004, 10:08 AM
Replies: 5
Views: 529
Posted By TerrellFlyer

RE: CG

Well Goplaneman,you was taught wrong.:D
Forum: Beginners
01-28-2004, 02:05 PM
Replies: 7
Views: 794
Posted By TerrellFlyer

RE: Best 50 size four stroke?

have OS FS.52 that is a pure pleasure to fly with.:D
Forum: Beginners
01-27-2004, 06:38 PM
Replies: 7
Views: 483
Posted By TerrellFlyer

RE: Engine Thrust Question !!!

Couple is normal,but have flown two planes with 4 degrees,never heard of more.
Forum: Glow Engines
01-27-2004, 10:44 AM
Replies: 14
Views: 941
Posted By TerrellFlyer

RE: How cold is too cold for a glow motor

depends on the pilot:D but you need to readjust you carb to normal running instead of four stroking.;)
Forum: Glow Engines
01-27-2004, 10:33 AM
Replies: 11
Views: 685
Posted By TerrellFlyer

RE: Help, my engine is going nuts

I use fuel with a caster blend and after run oil after each flying session,some of my engines are close to twenty years of age and still being used:D
Forum: Glow Engines
01-27-2004, 10:24 AM
Replies: 23
Views: 1,356
Posted By TerrellFlyer

RE: Tigershark Engine that can't pass the vert test

my TS is an old one that is one of the best engines I've got [about 25] has a OS #8 glow plug,15% Sig fuel,fuel tank center is 1/4 " below carb spray bar,with this set up it has been in about half a...
Forum: Kit Building
01-26-2004, 07:34 PM
Replies: 18
Views: 1,025
Posted By TerrellFlyer

RE: WONDER advice.

Pigman I have three Norvell's and I don't care for them,never know if they will start and if they do how long will they run,and yes I know what size engine the planes call for,but I would rather wake...
Forum: Beginners
01-26-2004, 02:41 PM
Replies: 12
Views: 665
Posted By TerrellFlyer

RE: visiblity

BearcatPilot, I wouldn't want to fly with the pattern only,at distance the pattern will disappear,and then so can the plane,simple rule can't see it,can't fly it.;)
01-26-2004, 02:35 PM
Replies: 2
Views: 792
Posted By TerrellFlyer

RE: Goldberg Eaglet

The plane flies great the way it is,I would add the extra weight of another servo.
01-26-2004, 02:32 PM
Replies: 3
Views: 420
Posted By TerrellFlyer

Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.