RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: jimmy7432
Showing results 1 to 18 of 18
Search took 0.11 seconds.
Forum: Gas Engines
12-04-2018, 07:14 PM
Replies: 24
Views: 2,272
Posted By jimmy7432

My set up is similar to the one pictured without...

My set up is similar to the one pictured without the large fuel filter. I have ordered a fuel filter. Will try a larger prop. I thought a larger prop would do the opposite and cause it to overheat....
Forum: Gas Engines
12-04-2018, 11:04 AM
Replies: 24
Views: 2,272
Posted By jimmy7432

The engine is 2 years old and has had this issue...

The engine is 2 years old and has had this issue from the beginning. In the beginning it would run for about 10 minutes before it would have the issue. The exhaust is side mounted and the fuel clunk...
Forum: Gas Engines
12-02-2018, 08:02 PM
Replies: 24
Views: 2,272
Posted By jimmy7432

DLE 20cc trouble

I have a DLE 20cc engine in a Citabria Pro Balsa USA plane. I am having trouble with the engine stalling at high RPM. It runs great for about 5 minutes and then just cuts out. I have tried adjusting...
02-12-2018, 06:32 PM
Replies: 25
Views: 1,692
Posted By jimmy7432

First time plans builder

What is the best way to transfer the shape of the parts to balsa to cut them out?
01-03-2018, 01:33 PM
Replies: 12
Views: 947
Posted By jimmy7432

How should I store my engines for the winter?

Most of my experience is with glow engines. But this spring I started flying a gas engine I installed on a plane I had completed. I have not seen much information on storing these engines for long...
09-14-2017, 03:49 PM
Replies: 3
Views: 659
Posted By jimmy7432

Where to get Missile red Monokote paint?

I built an airplane and covered it in Monokote Missile red. Problem is I did not buy enough of the matching spray paint to paint the cowl and wheel pants to match. I went to order more and the...
Forum: Kit Building
10-23-2016, 05:18 PM
Replies: 4
Views: 429
Posted By jimmy7432

Battery placement questions.

I am building a Citabria Pro from Balsa USA. I have the servos, receiver, batteries, engine and fuel tank roughly where I want them to go and checked the balance to get an idea if anything needs to...
Forum: Kit Building
04-08-2016, 05:51 PM
Replies: 1
Views: 532
Posted By jimmy7432

Has anyone used a Miracle Fuel dot/switch/charger?

I am looking for a switch for my new gas engine with electronic ignition. I was wondering if anyone knows anything about Miracle fuel dots and switches. They have one that has a fuel dot, 2 switches...
Forum: Kit Building
01-11-2016, 08:21 PM
Replies: 4
Views: 704
Posted By jimmy7432

Thanks for the advice. That's a big relief...

Thanks for the advice. That's a big relief because I am really looking forward to using this engine. I had already taken in account moving the cowl forward in the 1/4 inch I needed. Making a cut out...
Forum: Kit Building
01-10-2016, 07:35 PM
Replies: 4
Views: 704
Posted By jimmy7432

Cutting hole in firewall for carburetor?

I'm building a Citabria Pro kit from Balsa USA and I already bought a DLE 20cc RA engine. I did not look closely enough at the specs when I ordered the engine and I have already started the fuselage...
Forum: Kit Building
01-10-2016, 07:06 PM
Replies: 1,326
Views: 120,249
Posted By jimmy7432

Just finished a Tiger 2 kit this spring and had a...

Just finished a Tiger 2 kit this spring and had a great time flying it all summer. Fun plane to fly.
09-29-2015, 07:21 PM
Replies: 8
Views: 2,417
Posted By jimmy7432

Just wondering, are you sure it has yellowed and...

Just wondering, are you sure it has yellowed and it is not a plastic film for protection that needs to be peeled off?
09-28-2015, 07:08 PM
Replies: 0
Views: 693
Posted By jimmy7432

Covering advice

I recently ordered and received a Citabria Pro kit from Balsa USA. Just getting ready to begin working on it and looking to get some covering ideas. I have only used Monokote to cover the 2 kits I...
01-11-2015, 04:57 PM
Replies: 7
Views: 782
Posted By jimmy7432

Sorry I don't have an answer for your questions...

Sorry I don't have an answer for your questions but I am doing a rebuild myself and was wondering how you are going to replace the CA hinges. I am going to recover my plane as well and was trying to...
01-11-2015, 12:07 PM
Replies: 2
Views: 577
Posted By jimmy7432

Repair and restoring questions.

Im getting ready to restore the first kit I built. Its had several crashes and has been repaired several times but still flies well. Its a trainer and would like to keep it maybe to use as a trainer...
Forum: Kit Building
01-26-2014, 04:12 PM
Replies: 4
Views: 558
Posted By jimmy7432

So the kits do not come with full size plans? I...

So the kits do not come with full size plans? I guess the manual is detailed enough to get you through. Im looking at the Eclipse 50. 98" wingspan.
Forum: Kit Building
01-26-2014, 03:37 PM
Replies: 4
Views: 558
Posted By jimmy7432

Very encouraging. Thank you. Have built a few...

Very encouraging. Thank you. Have built a few kits and looking for my 3rd and something a little more challenging and bigger.
Forum: Kit Building
01-25-2014, 07:51 PM
Replies: 4
Views: 558
Posted By jimmy7432

Anyone ever build a kit from AMR-RC.com

Just like most of you I have been looking for more of a selection of kits and have gone through a lot of websites and there is not a lot to offer. I found a company, AMR-RC.com that has the biggest...
Showing results 1 to 18 of 18


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.