RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: partshunt
Showing results 1 to 25 of 77
Search took 0.67 seconds.
Forum: Gas Engines
11-09-2022, 01:12 AM
Replies: 133
Views: 7,818
Posted By partshunt

Ed, I have the same engine, 50cc-7 cyl UMS with...

Ed, I have the same engine, 50cc-7 cyl UMS with UMS carb. Poor instruction book, I did not know the plug wires have to go on with a hard snap to make them seat, otherwise they misfire, Also, I cannot...
Forum: Gas Engines
10-28-2022, 10:21 AM
Replies: 133
Views: 7,818
Posted By partshunt

Got a couple of questions that I asked the...

Got a couple of questions that I asked the supplier but no reply. Was asking what is the spark plug gap for the UMS 50cc- 7Cyl.??? Also, using a remote temp hand held sensor, what is the temperature...
Forum: Gas Engines
10-15-2022, 04:20 PM
Replies: 133
Views: 7,818
Posted By partshunt

Hello Timbers, You asked why I could see the...

Hello Timbers, You asked why I could see the spark, well only those arcing near the slott at the end. The slot is about 3/8 to 1/2 inches and those plugs arcing can seen. Others may arc hidden from...
Forum: Gas Engines
10-14-2022, 10:24 PM
Replies: 133
Views: 7,818
Posted By partshunt

Timbers, it is a 50cc 7 cylinder. Yes, that is...

Timbers, it is a 50cc 7 cylinder. Yes, that is the first thing I did, no difference. I cleaned the plugs and reinstalled them. I see air bubbles in the fuel line originating at the pump. I will deal...
Forum: Gas Engines
10-14-2022, 12:44 PM
Replies: 133
Views: 7,818
Posted By partshunt

UMS 7 cyl radial misfiring.

I have a new UMS 7 cylinder radial, ran good for half an hour then it became erratic, could not keep it running. Stalls on acceleration and found it misfiring. Discovered two cylinders with leaking...
Forum: Gas Engines
09-25-2022, 11:50 PM
Replies: 133
Views: 7,818
Posted By partshunt

Hyjinx, you say in your post you are building a...

Hyjinx, you say in your post you are building a custom T-28. Did you get the plans from a supplier or did you draw up your own plans?. I ask because I like the T28 and flew one of Dave Platts old...
Forum: Gas Engines
09-03-2022, 02:31 PM
Replies: 133
Views: 7,818
Posted By partshunt

Anybody have experience with Evolution Oil? UMS...

Anybody have experience with Evolution Oil? UMS is supposed to previously be an Evolution radial and this oil is for those engines, it must be ok for UMS I would think. Anybody have bad experiences...
Forum: Gas Engines
09-02-2022, 07:52 PM
Replies: 133
Views: 7,818
Posted By partshunt

Hi there; If you recall a while back I asked...

Hi there; If you recall a while back I asked about Minnie Motors. I would like to say, I finally received the UMS 50-7 cyl. I am getting ready to run it and they say use two stroke oil. I have new...
08-10-2022, 12:32 AM
Replies: 1
Views: 608
Posted By partshunt

Hi, Can you Google the manual and if it is not in...

Hi, Can you Google the manual and if it is not in English, your computer should be able to translate it to English. Maybe print it out or just save to a memory stick...
Forum: Gas Engines
07-03-2022, 12:30 PM
Replies: 133
Views: 7,818
Posted By partshunt

I guess it will rectify itself eventually. Thank...

I guess it will rectify itself eventually. Thank you for the good wishes and Maxam, thanks, it is good to know some people get lucky that the 7-35 was in stock. Mine was back ordered and I understand...
Forum: Gas Engines
07-03-2022, 12:45 AM
Replies: 133
Views: 7,818
Posted By partshunt

Well, I can accept some of the slow reasons but...

Well, I can accept some of the slow reasons but it is going far enough for this kid. Two months is too long to order an item. I sent the money in British Lbs as he wanted. He has the loot. When he...
Forum: Gas Engines
07-02-2022, 11:00 AM
Replies: 133
Views: 7,818
Posted By partshunt

Has anyone purchased a UMS Radial from Minnie...

Has anyone purchased a UMS Radial from Minnie Morris Engines in the UK? I have ordered one two months ago, I am still waiting???
Forum: Gas Engines
06-25-2022, 10:07 AM
Replies: 133
Views: 7,818
Posted By partshunt

Karolh, which size is your seven cylinder. I ask...

Karolh, which size is your seven cylinder. I ask because on the 7 cylinder 50cc , comes with UMS carb, or you can get the Walbro carb. Is yours seven cylinder bigger with the Walbro carb, gasoline...
Forum: Glow Engines
06-07-2022, 09:48 PM
Replies: 10
Views: 595
Posted By partshunt

Thank you for the suggestion. I have ordered K&B...

Thank you for the suggestion. I have ordered K&B engine parts to rebuild my ole 61 from MECOA and missed out ordering the plugs. However, thinking I could buy modern low idle plugs if they work...
Forum: Glow Engines
06-06-2022, 12:48 AM
Replies: 10
Views: 595
Posted By partshunt

Greetings, can anyone advise from their best...

Greetings, can anyone advise from their best experience which glow plug is best for idle. The engine is an old K&B 61 with an original glow plug have an idle bar. I cant find any such glow plugs any...
Forum: Gas Engines
05-19-2022, 08:35 PM
Replies: 133
Views: 7,818
Posted By partshunt

What is the wingspan of the Stearman, also the...

What is the wingspan of the Stearman, also the projected weight for that model, UMS 260 Radial is big motor.
Forum: Gas Engines
05-14-2022, 07:41 PM
Replies: 133
Views: 7,818
Posted By partshunt

thank you for that information. Mine will come...

thank you for that information. Mine will come with the UMS carb, not the Walbro but it is an option The 50cc 7 cyl the UMS carb is standard , optional is the Walbro as you probably know. . ......
Forum: Gas Engines
05-14-2022, 12:37 AM
Replies: 133
Views: 7,818
Posted By partshunt

This UMS forum is what I have been looking for. I...

This UMS forum is what I have been looking for. I just bought a 50cc, 7cylinder ums on gasoline. Does anyone have experience with the 50cc? It is not supplied with the Walbro carb, it has the UMS...
09-07-2021, 12:25 PM
Replies: 3
Views: 1,472
Posted By partshunt

I will check with R Price, however, what is the...

I will check with R Price, however, what is the point of the starter winding up to 1200 rpm, no glow, no start until the starter comes to near stop ,that is when the glow plug kicks, why so late?,...
09-06-2021, 03:34 AM
Replies: 3
Views: 1,472
Posted By partshunt

My Ram 1000 will not start. I did an experiment...

My Ram 1000 will not start. I did an experiment and connected another glo plug externally, to watch when it glows. I click on the RUN" mode and and each time the starter winds up to about 1200 RPM,...
08-29-2021, 11:51 AM
Replies: 3
Views: 1,472
Posted By partshunt

RAM gas turbine will not start.

Maybe some one can help me. My rebuilt Ram gas turbine will not start, wont even flash or fire up at all after burnt out 3-4 glo plugs. It does three trys and then shuts down like it should. I notice...
Forum: Glow Engines
07-19-2021, 10:37 PM
Replies: 22
Views: 6,765
Posted By partshunt

Does anyone know the status with Mike White...

Does anyone know the status with Mike White regarding Bruce Satra Morton M5 parts. Is he selling off everything or going to produce and sell Morton Parts including the Super Morton.? I have two...
Forum: Marketplace
05-30-2021, 06:10 PM
Replies: 15
Views: 2,742
Posted By partshunt

I am confused, you cal them all "turbines"....

I am confused, you cal them all "turbines". However, there is only one Turbine Engine pictured for sale with three aircraft in the lot, Right?, only one engine, and three planes (aircraft). Am I...
01-07-2021, 09:28 PM
Replies: 6
Views: 1,777
Posted By partshunt

Thank you for the advice. That is basically the...

Thank you for the advice. That is basically the way I understand starting withsout a solenoid. I copied and pasted your info in my Turbine note. I have a screen and filter, also a fuel shut off. Need...
01-07-2021, 04:12 PM
Replies: 6
Views: 1,777
Posted By partshunt

Carlos, I have one more question. I bought this...

Carlos, I have one more question. I bought this ram with only 1 solenoid so I plugged it in the FUEL port, not the gas port. I need one for the gas port but the instructions warn not to use any other...
Showing results 1 to 25 of 77
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright © 2022 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.