Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: bluelevel
Showing results 1 to 25 of 439
Search took 0.29 seconds.
Forum: Marketplace
02-12-2021, 02:57 PM
Replies: 0
Views: 380
Posted By bluelevel

Mephisto V1 parts

Due to a radio failure I lost my Mephisto right after takeoff. The front half of the jet took the brunt of it, but the back surived with only cosmetic damage. I have a few parts that are in decent...
Forum: RC Jets
01-21-2021, 08:35 PM
Replies: 919
Views: 142,440
Posted By bluelevel

Sheldon, unfortunately I have not. Our Florida...

Sheldon, unfortunately I have not. Our Florida winters are not cold at all but fairly windy with lots of cross winds. Haven't taken out the Rebel Max in over a month and it's definitely not Mephisto...
Forum: RC Jets
01-10-2021, 02:57 PM
Replies: 1,966
Views: 259,803
Posted By bluelevel

In one of my jets I am using a CB220 with 3...

In one of my jets I am using a CB220 with 3 receivers (RX1 is a Rex12, RX2 is a R3 2.4 and a 900Mhz used as a backup as RX3). During the first flights I heard a "Warning" alarm, but no further info...
Forum: RC Jets
01-03-2021, 05:50 PM
Replies: 919
Views: 142,440
Posted By bluelevel

Should have big bore fittings to take the bigger...

Should have big bore fittings to take the bigger diameter tubing for a 300 size turbine
Forum: RC Jets
01-01-2021, 08:41 AM
Replies: 919
Views: 142,440
Posted By bluelevel

That's a short extension I made. Servo plug is...

That's a short extension I made. Servo plug is still there.

As to servo arms I used a 1.5 inch arm for rudder and ailerons, the flaps will need a very short one to fit. Best to look into the short...
Forum: RC Jets
12-31-2020, 04:57 PM
Replies: 919
Views: 142,440
Posted By bluelevel

Not much time today, just managed to find half an...

Not much time today, just managed to find half an hour to solder a servo extension and mount the rudder servo.
...
Forum: RC Jets
12-31-2020, 03:44 PM
Replies: 39
Views: 4,724
Posted By bluelevel

The plane was a prototype and even bigger than...

The plane was a prototype and even bigger than the XL version listed on the Skymaster website. This one is called the XXL and has a 3 piece wing. It's not yet available to the public.
...
Forum: RC Jets
12-30-2020, 10:03 AM
Replies: 919
Views: 142,440
Posted By bluelevel

Little more progress on the mid-wing section....

Little more progress on the mid-wing section. Took me a bit to find a proper way to route the gear and brake wires so that they don't interfere with the gear leg moving up or down. I attached...
Forum: RC Jets
12-22-2020, 03:46 PM
Replies: 919
Views: 142,440
Posted By bluelevel

Stay away from these!!! Had purchased a whole set...

Stay away from these!!! Had purchased a whole set for the first Mephisto I built a while ago. Great specs on paper, but what they don't tell you is that either their over-temp or over-current...
Forum: RC Jets
12-22-2020, 01:31 PM
Replies: 919
Views: 142,440
Posted By bluelevel

Skunkwrks your local hobby shop should have...

Skunkwrks your local hobby shop should have plenty different sizes of brass tubing. I didn't purchase those bushings, just cut small pieces off a longer piece of tubing with a dremel.

These...
Forum: RC Jets
12-22-2020, 12:27 PM
Replies: 919
Views: 142,440
Posted By bluelevel

The screws are 3mm and the brass sleeves replace...

The screws are 3mm and the brass sleeves replace the rubber grommets and eyelets. The brass tubing I used is 3mm inner dia and 4 point something outer dia and fits the servos' mounting holes...
Forum: RC Jets
12-22-2020, 11:48 AM
Replies: 919
Views: 142,440
Posted By bluelevel

In case that your plane starts rolling with the...

In case that your plane starts rolling with the flaps deployed (like mine did), you might find the flap servos moving in the mounts. The thicker metal screws that CARF recommends do not allow the use...
Forum: RC Jets
12-22-2020, 11:43 AM
Replies: 919
Views: 142,440
Posted By bluelevel

@ Aerosheldon The Savox 2290 and 2292 and...

@ Aerosheldon

The Savox 2290 and 2292 and definitely good servos. The stronger 2290 should be used on flaps & rudder, the quicker 2292 for the rest. You might also look at the Bluebird BLS-H51B...
Forum: Marketplace
10-31-2020, 02:09 PM
Replies: 2
Views: 176
Posted By bluelevel

Leo bags

Hi Angus,

shipping to Fernie, BC via USPS is $65.00. If you agree, please send your Paypal payment of $245.00 to [email protected]

Thomas
Forum: RC Jets
10-31-2020, 12:49 PM
Replies: 47
Views: 12,066
Posted By bluelevel

I have for sale a set of custom wing, rudder &...

I have for sale a set of custom wing, rudder & stab bags for the 3.0m Leonardo. These are listed here in the Classifieds section....
Forum: Marketplace
10-31-2020, 12:42 PM
Replies: 2
Views: 176
Posted By bluelevel

Redwings Leonardo 3.0m Revoc wingbags

I have for sale a brand new set of wing, rudder, stab and equipment bags for a 3.0m Redwings Leonardo. These soft padded fabric bags are top quality and custom made. This set retails for $290.00 plus...
Forum: Marketplace
10-29-2020, 04:51 PM
Replies: 0
Views: 203
Posted By bluelevel

CM-Jets tank fuel & smoke (fits Redwings Leonardo)

I have for sale a very nice CM-Jets kevlar fuel & smoke tank combo that fits a 3m Leonardo. It holds 6l of fuel and 1.5l of smoke oil. It's made for a 3m Redwings Leonardo but will fit other planes...
Forum: RC Jets
10-29-2020, 04:46 PM
Replies: 47
Views: 12,066
Posted By bluelevel

In case someone needs it, I still have a nice...

In case someone needs it, I still have a nice CM-Jets kevlar fuel & smoke tank combo that fits a 3m Leonardo. It holds 6l of fuel and 1.5l of smoke oil. I also have a set of custom Revoc wing bags...
Forum: Marketplace
10-28-2020, 11:52 AM
Replies: 2
Views: 261
Posted By bluelevel

Kevlar fuel tank (Redwings Leonardo)

I have for sale a brand new (never uused or assembled) kevlar fuel tank. It comes from a redwings Leonardo 3m model, but will fit other jets as well. It measures 7x4x10 inches.

Buyer to pay for...
Forum: Marketplace
10-26-2020, 07:21 PM
Replies: 4
Views: 450
Posted By bluelevel

Kingtech KP800 fuel pump (for K180 & K210)

I have for sale a Kingtech KP800 fuel pump. It fits all Kingtech K180 and K210 turbines. It's the newer version with the integrated self-priming valve. The pump was purchased as a spare and is in...
Forum: Marketplace
10-26-2020, 07:19 PM
Replies: 0
Views: 272
Posted By bluelevel

Kingtech K210 Gen2 ECU

I have for sale a Kingtech Gen2 ECU. It's programmed for a Kingtech K210 turbine. The ECU was a spare and is in excellent working condition.

I will assume Paypal fees, buyer to pay for shipping.
Forum: Marketplace
10-26-2020, 07:17 PM
Replies: 0
Views: 178
Posted By bluelevel

Kingtech Turbine Batteries

I have for sale 2 almost new original Kingtech turbine LiFe batteries. Both were flown only a handful of times and are being sold only because I changed brands and have no use for them anymore.
...
Forum: Marketplace
10-26-2020, 07:14 PM
Replies: 0
Views: 243
Posted By bluelevel

Kingtech K210-G2 *** lots of accessories & low runtime ***

I have for sale a Kingtech K210-G2. It comes with over $200 in accessories (see list below) and has a very low runtime. The turbine is in excellent condition with no damage history.

It comes with...
Forum: Marketplace
10-25-2020, 01:51 PM
Replies: 3
Views: 309
Posted By bluelevel

See attached picture. All servos have the same...

See attached picture. All servos have the same PID, although not marked on all boxes...
Forum: Marketplace
10-24-2020, 11:55 AM
Replies: 0
Views: 146
Posted By bluelevel

Bavarian Demon Cortex Pro Gyro

For sale is a Bavarian Demon Cortex Pro gyro. It comes with all factory accessories (wire loom) plus a USB programming cable..

My price includes Paypal fees, buyer to pay for shipping.
Showing results 1 to 25 of 439
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.