RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: David87965
Showing results 1 to 9 of 9
Search took 0.03 seconds.
08-08-2016, 04:05 AM
Replies: 13
Views: 866
Posted By David87965

I always go slighty higher than recommendations...

I always go slighty higher than recommendations just to make sure everything runs cool. for batteries, having more head room on the C-rating means cooler temps than using bare recommendation. eg. 30C...
Replies: 14
Views: 1,562
Posted By David87965

Timing was set to default which is...

Timing was set to default which is "Average/Normal", there is a lower timing option too. I did not change the timing at all. I guess i was just too hard on the motor because i did abuse it by doing 5...
Replies: 14
Views: 1,562
Posted By David87965

Does dry dust/dirt cook motors? I kicked up alot...

Does dry dust/dirt cook motors? I kicked up alot of dust with the car, Only difference of between the runs that were normal and the really abnormally high temps.

Does this graph look right?...
Replies: 14
Views: 1,562
Posted By David87965

yeah, do you know any better motors for my...

yeah, do you know any better motors for my trophy, i want it to be fast (85 km/h min) and not have to cool down until the battery goes flat... or am i dreaming lol has to be 25mm mounting holes or...
Replies: 14
Views: 1,562
Posted By David87965

I been studying the data logs and i have noticed...

I been studying the data logs and i have noticed the rate of temp increase on the ESC is the same for the third run which i had zero problems and the run that fried so this means my setup was never...
Replies: 14
Views: 1,562
Posted By David87965

ESC logs says it sent 18A average when it fried...

ESC logs says it sent 18A average when it fried but other logs before the change of tyres ran up to 32A average. i was extremely hard on the car with stock tyres and never had this 160C problem. It...
Replies: 14
Views: 1,562
Posted By David87965

Stock gearing for 4S is 15/50 but i moved to...

Stock gearing for 4S is 15/50 but i moved to 13/50 for 6S and the weather was only 15C, I am going to check bearings in the morning. I will also buy smaller pinion even though 13 is tiny as it is lol.
Replies: 14
Views: 1,562
Posted By David87965

Yep, All my posts are metric units unless stated...

Yep, All my posts are metric units unless stated otherwise. So what do i need to do? My ratios for my drive-train are 43t ring gear, 10t diff pinion with 13/50 gearing. Is this setup wrong or...
Replies: 14
Views: 1,562
Posted By David87965

Question Motor Fried, Why?

Hey guys,

I have a 1/8 Trophy Truggy Flux that has Castle 1515 2200kV on 6S. It has 13t pinion and 50t spur gear and it was running fine on stock tyres but then i change tyres to Proline badlands...
Showing results 1 to 9 of 9


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.