RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: causeitflies
Showing results 1 to 24 of 24
Search took 0.01 seconds.
Forum: RC Jets
02-14-2021, 04:05 PM
Replies: 491
Views: 46,359
Posted By causeitflies

If noise didnít cause vibration your ears...

If noise didnít cause vibration your ears couldnít work:p
Forum: RC Jets
08-18-2020, 05:42 PM
Replies: 491
Views: 46,359
Posted By causeitflies

Since I use the same knob for gain on all of my...

Since I use the same knob for gain on all of my planes that have gyros, I'm thinking of changing it on all of them to digital trim so I never have to worry about the knob position.
I always thought...
Forum: RC Jets
08-18-2020, 05:21 PM
Replies: 491
Views: 46,359
Posted By causeitflies

As Wayne suggests I will leave the default gain...

As Wayne suggests I will leave the default gain at 50% and the main gains at 22 for now. Only do one step at a time to begin. Since I updated this Rx I'm treating it as a brand new gyro even after...
Forum: RC Jets
08-18-2020, 03:07 PM
Replies: 491
Views: 46,359
Posted By causeitflies

Carlos, I did figure it out. To make the gains ...

Carlos,
I did figure it out. To make the gains flight mode dependent in the Assist you have to go to the gain tuning knob and change that percentage Per flight mode.
This can also be done with...
Forum: RC Jets
08-17-2020, 12:45 PM
Replies: 491
Views: 46,359
Posted By causeitflies

I know the difference in gain should be very...

I know the difference in gain should be very small. I want to make the gains flight mode dependent but havenít been able to see where to do it in the flight modes. For instance I could turn the nose...
Forum: RC Jets
08-17-2020, 12:36 PM
Replies: 491
Views: 46,359
Posted By causeitflies

Paul, I have a cortex set up like this also. I...

Paul,
I have a cortex set up like this also. I just recently updated my assist that I have been flying Since it first came out and canít see where I can do the same with flight mode other than...
Forum: RC Jets
08-17-2020, 11:31 AM
Replies: 491
Views: 46,359
Posted By causeitflies

So for example if one has down trim with full...

So for example if one has down trim with full flaps for landing, it would be best to calibrate in that configuration? Therefor the gain would be a little higher in landing mode than cruise mode since...
Forum: RC Jets
08-14-2020, 08:00 PM
Replies: 491
Views: 46,359
Posted By causeitflies

Here's something else to read when you get a...

Here's something else to read when you get a chance. :cool:
https://www.rcgroups.com/forums/showthread.php?2409139-Many-uses-to-Jeti-logic-List-yours...
Forum: RC Jets
08-14-2020, 03:40 PM
Replies: 491
Views: 46,359
Posted By causeitflies

If you have ďdamping onlyĒ checked there should...

If you have ďdamping onlyĒ checked there should be no problem.
Forum: RC Jets
08-06-2020, 07:58 PM
Replies: 491
Views: 46,359
Posted By causeitflies

Don’t assign switch SF as throttle trim. Because...

Don’t assign switch SF as throttle trim. Because you made SF the throttle cut and throttle idle you don’t need any trim.
Forum: RC Jets
08-06-2020, 03:52 PM
Replies: 491
Views: 46,359
Posted By causeitflies

In functions assignment there’s no need for Trim...

In functions assignment there’s no need for Trim Trim max for throttle.
Forum: RC Jets
08-06-2020, 02:04 PM
Replies: 491
Views: 46,359
Posted By causeitflies

The original DS16 Doesn’t have enough memory for...

The original DS16 Doesn’t have enough memory for large Lua apps.
If the failsafe is set to idle it will stay at idle. Set it to a range outside of normal like -125% or more or to send no signal....
Forum: RC Jets
08-06-2020, 11:57 AM
Replies: 491
Views: 46,359
Posted By causeitflies

16MK2 is not available yet.

16MK2 is not available yet.
Forum: RC Jets
08-06-2020, 07:48 AM
Replies: 491
Views: 46,359
Posted By causeitflies

Also disable throttle trim buttons as they are...

Also disable throttle trim buttons as they are not needed and can be used for something else.
Forum: RC Jets
08-06-2020, 06:51 AM
Replies: 491
Views: 46,359
Posted By causeitflies

This is how I have my Throttle Idle and Throttle...

This is how I have my Throttle Idle and Throttle Cut set. This works on JetCat, Jet Central, Wren, and all versions of KingTech. Be sure to go through the "Learn" process AFTER setting this up using...
Forum: RC Jets
08-06-2020, 06:44 AM
Replies: 491
Views: 46,359
Posted By causeitflies

...

...
Forum: RC Jets
08-04-2020, 08:01 PM
Replies: 491
Views: 46,359
Posted By causeitflies

Itís all good Carlos. Itís a hobby :cool:

Itís all good Carlos. Itís a hobby :cool:
Forum: RC Jets
08-04-2020, 06:29 PM
Replies: 491
Views: 46,359
Posted By causeitflies

Throttle cut turns the engine off on turbines....

Throttle cut turns the engine off on turbines. Has nothing to do with brakes. Itís to stop the engine not the plane.
Forum: RC Jets
07-27-2020, 07:17 AM
Replies: 491
Views: 46,359
Posted By causeitflies

That video alone could sell a lot of Jeti’s.

That video alone could sell a lot of Jeti’s.
Forum: RC Jets
07-21-2020, 08:43 AM
Replies: 491
Views: 46,359
Posted By causeitflies

Your setup is exactly like mine. I am not a fan...

Your setup is exactly like mine. I am not a fan of the trim buttons and even though my Multiplex Evo had the same trims I could never really get used to them. When I first got my DS-16 I set up the...
Forum: RC Jets
07-20-2020, 12:57 PM
Replies: 491
Views: 46,359
Posted By causeitflies

Yes, I use the rudder trim for steering too. But...

Yes, I use the rudder trim for steering too. But I donít use any trim for rudder so I have extra trim buttons available.
Forum: RC Jets
07-20-2020, 12:23 PM
Replies: 491
Views: 46,359
Posted By causeitflies

So, since I don’t use throttle trim buttons on...

So, since I don’t use throttle trim buttons on any of my electrics or turbines, was wondering if anyone has come up with a use for these unused trim buttons.
For instance I know some use them for...
Forum: RC Jets
07-20-2020, 11:32 AM
Replies: 491
Views: 46,359
Posted By causeitflies

Thatís exactly how I do the manual cool down.

Thatís exactly how I do the manual cool down.
Forum: RC Jets
07-19-2020, 10:16 AM
Replies: 491
Views: 46,359
Posted By causeitflies

Although there are already very long Jeti threads...

Although there are already very long Jeti threads here and over on RCG, it's good to start a fresh one here for newcomers and especially for the new DS-12. Finding info on the other huge threads can...
Showing results 1 to 24 of 24


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright © 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.