RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 20
1
2
3
11
Last »
Search: Posts Made By: TampaRCGuy
Showing results 1 to 25 of 500
Search took 1.09 seconds.
Forum: Marketplace
09-13-2019, 12:50 AM
Replies: 0
Views: 170
Posted By TampaRCGuy

4 Futaba S3152 and 1 Futaba S3151 like new for sale

Just pulled these from a plane I just sold last week. Like new condition.

$130 shipped in the US. PayPal OK
Forum: Marketplace
09-17-2018, 12:57 AM
Replies: 2
Views: 1,266
Posted By TampaRCGuy

I never got notification of your question. ...

I never got notification of your question.

This is the 1/6th Scale Pica T-28B.
- 65 inch span.
- 50.5" length
- 10 lbs
- .61-0.90 glow
- 5 or 6 channels

you can email me ta...
Forum: Marketplace
09-03-2018, 01:49 AM
Replies: 2
Views: 1,266
Posted By TampaRCGuy

Pica T28B 1/6th Scale Framed up, almost ready to cover

This is a 99% framed up Pica 1/6 T-28B. Almost ready to cover. Cockpit is completed.
Includes the following:

Pica T28B framed up.
New Spring Air retracts. Retracts have been updated from Spring...
Forum: Marketplace
09-03-2018, 01:37 AM
Replies: 3
Views: 397
Posted By TampaRCGuy

Futaba R6014HS 14 Channel Rx Excellent Condition

Excellent condition Futaba R6014HS 14 Channel RX. No longer needing.
$130.00 Shipped in the US.
Forum: YS Engines Support
01-30-2018, 03:33 AM
Replies: 1
Views: 1,036
Posted By TampaRCGuy

DZ160 won't shut down

test running a DZ160 and when the carb barrel is closed, the engine ticks over and will not stop. I did adjust the spring screw with no change. Sounds like an air leak. Where is the most common place...
Forum: RC Warbirds and Warplanes
11-06-2017, 02:11 AM
Replies: 1,844
Views: 258,077
Posted By TampaRCGuy

retracts

I had them in my P40. Really not good. One day they just started acting up. It was the retracts, not the box. Long story short, after 4 months and 3 exchanges they were replaced with the air Robart's...
Forum: Futaba Radios Direct support forum
01-31-2016, 07:02 AM
Replies: 1
Views: 680
Posted By TampaRCGuy

Futaba Sbus questions on TF Giant P40 setup

Hi Bill,

I have a few questions on a Sbus and conventional setup on a TF Giant Scale P-40.

Current equipment:
Futaba R6208SB Sbus Rx
Futaba 12Z Tx
2 Futaba S9155 Digital servo's
2100 LiFe...
Forum: RC Warbirds and Warplanes
01-30-2016, 05:35 AM
Replies: 1,844
Views: 258,077
Posted By TampaRCGuy

Has anyone made the stabs removable on the P40...

Has anyone made the stabs removable on the P40 Giant Scale ARF instead of gluing them?
Forum: Giant Scale Aircraft - General
01-30-2016, 05:16 AM
Replies: 1,699
Views: 604,132
Posted By TampaRCGuy

Hi All, I just got in the TP P-40 Giant...

Hi All,

I just got in the TP P-40 Giant Scale ARF and DLE55RA motor,

I did not see this question posted anywhere in the thread. Has anyone made the Stab removable instead of gluing it to the...
Forum: Electric Pattern Aircraft
11-19-2012, 12:03 PM
Replies: 1,677
Views: 405,841
Posted By TampaRCGuy

RE: Extreme Flight Vanquish 2m Build Thread

[/quote]

I have several sets of the 5S and 5S, and several sets of a 6S and 4S. When it is time to have new batteries, I will probably use the 45C's if I make weight.
Forum: Electric Pattern Aircraft
11-19-2012, 10:49 AM
Replies: 1,677
Views: 405,841
Posted By TampaRCGuy

RE: Extreme Flight Vanquish 2m Build Thread

Hey guys, I have been using the PowerEdge 5000 5S 30C's in my Vanquish with great success. We have updated the PowerEdge battery line and the 30C 5000's have been discontinued and replaced by the 45C...
Forum: Electric Pattern Aircraft
10-28-2012, 08:27 AM
Replies: 1,677
Views: 405,841
Posted By TampaRCGuy

RE: Extreme Flight Vanquish 2m Build Thread

your's came out heavier than mine did, I am at 11 lbs 2 oz and I know why mine did. If you are using the Torque motor, that weighs nearly 5-6 oz less than my Dualsky. What do you have for a rx...
Forum: Electric Pattern Aircraft
08-30-2012, 02:47 AM
Replies: 1,677
Views: 405,841
Posted By TampaRCGuy

RE: Extreme Flight Vanquish 2m Build Thread

I normally do not use the brake on my electric aicraft. Using props up to 10" pitch, no brake was ok. Once I started to use the 13" and higher pitched props, I found that I needed the brake. I...
Forum: Electric Pattern Aircraft
08-25-2012, 04:05 AM
Replies: 1,677
Views: 405,841
Posted By TampaRCGuy

RE: Extreme Flight Vanquish 2m Build Thread

Seep some CA on every joint that you can reach. While I found no areas that did not have a good glue joint, it took less than 5 minutes to do.
Forum: Electric Pattern Aircraft
08-19-2012, 02:57 AM
Replies: 1,677
Views: 405,841
Posted By TampaRCGuy

RE: Extreme Flight Vanquish 2m Build Thread

Remember, this is not a 3D aircraft. You will only use 11-15 degrees of throw on the elevator. I also used the S9650's, but due to the width of the Dubro arms, I used a metal servo arm so I did not...
Forum: Electric Pattern Aircraft
08-14-2012, 04:51 AM
Replies: 1,677
Views: 405,841
Posted By TampaRCGuy

RE: Extreme Flight Vanquish 2m Build Thread

One of the things to consider in batteries if you are sport flying vs running a pattern sequence is your power on vs power off. Running a pattern sequence, you have many power off moments in 45, 60...
Forum: Electric Pattern Aircraft
07-29-2012, 02:19 PM
Replies: 1,677
Views: 405,841
Posted By TampaRCGuy

RE: Extreme Flight Vanquish 2m Build Thread

I also have the S9650's in the tail. You will have to remove some of the ply mount to where the servo screws would be, maybe 2-2.5mm. Just keep trimming until you can get them in. It took me about an...
Forum: Electric Pattern Aircraft
07-05-2012, 06:54 AM
Replies: 1,677
Views: 405,841
Posted By TampaRCGuy

RE: Extreme Flight Vanquish 2m Build Thread

My Dualsky 6360 was the same way. I elected to slot the X-mount to use the existing blind nuts in the firewall.
Forum: Electric Pattern Aircraft
07-04-2012, 07:43 AM
Replies: 1,677
Views: 405,841
Posted By TampaRCGuy

RE: Extreme Flight Vanquish 2m Build Thread

I will check the CG for you the next time I put it back together. Honestly, I just follwed Brians trim chart. All was good except I had some pitch in KE. I moved the batteries forward and the KE...
Forum: Electric Pattern Aircraft
07-04-2012, 07:19 AM
Replies: 1,677
Views: 405,841
Posted By TampaRCGuy

RE: Extreme Flight Vanquish 2m Build Thread

Just got back from another 4 flights on the Vanquish.

Changes from the last outing:
Decreased the wing incidence to .7 pos. I think I was at .8 or even .9.
Moved the ESC as forward as I...
Forum: Electric Pattern Aircraft
07-03-2012, 02:36 AM
Replies: 1,677
Views: 405,841
Posted By TampaRCGuy

RE: Extreme Flight Vanquish 2m Build Thread

Same here! The Vanquish is my 4th EF plane. I see Chris and Curtis a few times a year at the various shows. At the SMS show in Perry, GA, our booths are next to each other. Actually, the IMAC...
Forum: Electric Pattern Aircraft
07-02-2012, 04:46 PM
Replies: 1,677
Views: 405,841
Posted By TampaRCGuy

RE: Extreme Flight Vanquish 2m Build Thread

Never use a filter or choke with Futaba equipment or any of the newer JR equipment.
Forum: Electric Pattern Aircraft
07-01-2012, 04:48 AM
Replies: 1,677
Views: 405,841
Posted By TampaRCGuy

RE: Extreme Flight Vanquish 2m Build Thread

I do not actually know, I did not check it. On the 3rd flight of the day I moved the batteries back some and felt the plane was tail heavy. More work to do. I am not worried about the thrust line yet.
Forum: Electric Pattern Aircraft
06-29-2012, 02:02 PM
Replies: 1,677
Views: 405,841
Posted By TampaRCGuy

RE: Extreme Flight Vanquish 2m Build Thread

One thing to keep in mind about wing incidence, the wing flies level. If you have too little wing incidence, the fue will fly tail down. Too much wing incidence, the fuse will fly tail high. The...
Forum: Electric Pattern Aircraft
06-29-2012, 08:59 AM
Replies: 1,677
Views: 405,841
Posted By TampaRCGuy

RE: Extreme Flight Vanquish 2m Build Thread

Just read Brian H Triangular Trimming method a few times. Based on his trimming, I am tail heavy before I moved the battery for the third flight. It won't be to next week where I will fly again but I...
Showing results 1 to 25 of 500
 
Page 1 of 20
1
2
3
11
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.