RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: exnordel
Showing results 1 to 25 of 40
Search took 0.34 seconds.
08-05-2010, 09:39 PM
Replies: 20
Views: 2,570
Posted By exnordel

RE: Monokote How to best seal the edges from fuel???

I have used the clear nail polish on occasion, it seemed to work well.

Vince
08-05-2010, 09:30 PM
Replies: 23
Views: 4,767
Posted By exnordel

RE: rc plane mid air with full scale plane?

When flying in a high traffic area as indicated above it is advisable to have an observer standing next to you advising of approaching traffic.

Vince
08-04-2010, 10:16 PM
Replies: 23
Views: 4,767
Posted By exnordel

RE: rc plane mid air with full scale plane?

Idiot is right, both of them.

Vince
08-01-2010, 06:05 PM
Replies: 6
Views: 1,786
Posted By exnordel

RE: VERY BAD CRASHES

De-evolution:D

Vince
Forum: Kit Building
08-01-2010, 01:56 PM
Replies: 2
Views: 583
Posted By exnordel

Back ordered UltraSport 60 on the way

Got a note from Tower that my back ordered US60 kit is on the way to me. UPS tracking says it will arrive Tuesday:D

Vince
07-28-2010, 06:18 PM
Replies: 43
Views: 6,160
Posted By exnordel

RE: First father-son project - Tower Trainer .60 Rebuild

You are very fortunate, my son could not have cared less about my hobby.[&o]

Vince
07-27-2010, 08:00 PM
Replies: 15
Views: 1,624
Posted By exnordel

RE: Best Firewall Sealer

No need to seal it with anything the JB Weld will do the job. With sealing it you run the risk of weighting it down which could cause the carb to flood. It should be real easy to find the pin hole or...
07-26-2010, 03:50 PM
Replies: 8
Views: 2,209
Posted By exnordel

RE: An unexpected hazzard while flying an RC plane.

Too bad you chaps do not have conceled carry in your country. No moron would attempt that in Texas for fear of being shot at.

Vince
07-24-2010, 09:52 PM
Replies: 7
Views: 1,078
Posted By exnordel

RE: P-51 Mustang WW II Original Pilot

Absolutely awesome, thanks very much for posting it.

Vince
Forum: Sport Flying
07-24-2010, 01:16 PM
Replies: 19
Views: 2,964
Posted By exnordel

RE: Maiden Flight - Ultra Sport 60!

Got mine on backorder from Tower and I will also be installing a 2 stroke in it. I agree, the US series begs for a strong screaming 2 stroke. There is just something about that engine screaming on a...
07-24-2010, 01:03 PM
Replies: 8
Views: 1,399
Posted By exnordel

RE: Macs Bolt-Through Muffler

I agree with the above comments, a very good well made attractive muffler with an acceptable noise level. I have one on a Super Tigre G45 ABC and it swings a 10 X 6 APC prop at 13.8K. I really have...
Forum: Kit Building
07-24-2010, 12:54 PM
Replies: 14
Views: 1,605
Posted By exnordel

RE: Do or Dont control surfaces TE rounded?

I agree with the consensus that there are far more circumstances that contribute to control surface flutter than tapering or rounding trailing edges. It has never been an issue with me and I have...
07-23-2010, 04:30 PM
Replies: 44
Views: 10,433
Posted By exnordel

RE: Don Anderson GP Super Aeromaster build from plans

Great thread, and a beautiful job on the Aeromaster, you are a master builder. Makes me wish I never would have sold my Andrews Aeromaster kit a few years ago.[:o]

Vince
07-23-2010, 04:22 PM
Replies: 11
Views: 3,390
Posted By exnordel

RE: Hiding On/Off Switches

I had a Bert Baker P47 (fore-runner to Yellow Aircraft) that I had dual switches hidden under a hatch right under the cockpit.

Vince
Forum: Kit Building
07-22-2010, 08:39 AM
Replies: 77
Views: 6,879
Posted By exnordel

RE: Just Griping...

I remember about 30 years ago when some of the first ARF's started appearing, I think it may have been a Lanier. The older gys back then talked about how it was going to be the end of kit building,...
07-20-2010, 10:58 AM
Replies: 3
Views: 713
Posted By exnordel

RE: Need help with dual aileron set up

I would use a channel for each aileron servo as that gives you maximum flexibility as far as programming. Depending on the length involved, a HD wiring harness is always preferred. If you are using...
Forum: Kit Building
07-19-2010, 09:23 PM
Replies: 10
Views: 1,707
Posted By exnordel

RE: Great Planes Big Stick 60, one or two aileron servos ??

Absolutely dual servos and 4-40 hardware.

Vince
07-19-2010, 08:41 AM
Replies: 27
Views: 2,067
Posted By exnordel

RE: Which battery to use...

I also switched to NIMH, but over time realized they have a much shorter life than NICAD. I switched back to NICAD, but the high capacity ones. I am now running 1100mah NICAD's in all my TX's.

...
07-11-2010, 11:03 AM
Replies: 10
Views: 1,110
Posted By exnordel

RE: Chinese Super Tigre reports

Thanks a bunch for the positive input guys. I am a Super Tigre fan from way back and I was saddened to see them sell out to the Chinese. I love Super Tigre carbs and have become quite adept at tuning...
07-11-2010, 10:53 AM
Replies: 6
Views: 1,732
Posted By exnordel

RE: can vs spray primer

Most if not all "rattle can" primers and paints are not very durable. IF you have a paint gun and your willing to go to the expense of it you can go with a professional 2K primer/surfacer like PPG's...
07-10-2010, 10:14 PM
Replies: 10
Views: 1,110
Posted By exnordel

Chinese Super Tigre reports

Would like to hear some real world reports from people who are using the Chinese Super Tigre's.

Vince
07-10-2010, 10:08 PM
Replies: 5
Views: 1,280
Posted By exnordel

RE: Up scaling plans

Decide what wing span you want then take your plans to a drafting supply place or a reproduction facility and have the plans blown up to the proper size.

Vince
Forum: Kit Building
07-10-2010, 03:50 PM
Replies: 3,096
Views: 254,019
Posted By exnordel

RE: *** Ultra Sport Brotherhood ***

Better get online with Tower and get that US60 on back order. I'm sure that once they get in stock they will go fast.

Vince
Forum: Kit Building
07-09-2010, 09:19 PM
Replies: 3,096
Views: 254,019
Posted By exnordel

RE: *** Ultra Sport Brotherhood ***

Glad to see this UltraSport thread. I flew an UltraSport 40 for about 10 years and loved it. It was recovered twice during that flying period. I had a very strong running Super Tigre 45 ABC...
Forum: Kit Building
07-08-2010, 05:50 PM
Replies: 7
Views: 993
Posted By exnordel

RE: Balsa sheeting over foam delaminating, any help?

I have found that the absolute best glue for sheeting foam wings is polyurethane (Gorilla glue). It is far lighter than epoxy, easier than contact glue to use, and when used foams up to fill evey...
Showing results 1 to 25 of 40
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.