RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: WyomingJEEPFREAK
Showing results 1 to 25 of 43
Search took 0.71 seconds.
Replies: 144
Views: 7,401
Posted By WyomingJEEPFREAK

RE: how old are you ?

42 and love my savage. Too bad I have to fix my Jeep that hobby takes more money then my RC toys
07-25-2005, 10:05 PM
Replies: 3
Views: 462
Posted By WyomingJEEPFREAK

RE: How the crap do you get the air filter back on easily?

Dont take the whole thing off, Just remove the filter
07-25-2005, 10:03 PM
Replies: 11
Views: 722
Posted By WyomingJEEPFREAK

RE: How the!???!!!

Buy a New one. They are cheap and you wont get out bashing and have it break again
06-26-2005, 09:42 PM
Replies: 14
Views: 615
Posted By WyomingJEEPFREAK

RE: Wont Start when hot

I have richened the HSN untill it sputtersand backed it down untill it runs. The thing will wheelie on comand but seems to lose power at wot. I have sealed the engine. Can it have anything to do with...
06-26-2005, 07:00 PM
Replies: 14
Views: 615
Posted By WyomingJEEPFREAK

RE: Wont Start when hot

I have good smoke when at full throttle and when starting off. I have tried to richen it to the point that it sputters at WOT and backed it off enough to run good. If it sputters can I fix it with...
06-26-2005, 11:45 AM
Replies: 14
Views: 615
Posted By WyomingJEEPFREAK

RE: Wont Start when hot

Ok, So how do I make it run cooler? I am running the sugested glow plug mc9 I believe
06-25-2005, 05:24 PM
Replies: 14
Views: 615
Posted By WyomingJEEPFREAK

Wont Start when hot

After running my truck if it dies or I shut it down it wont start untill it cools. Is it running too rich too lean ?
06-22-2005, 07:20 PM
Replies: 3
Views: 528
Posted By WyomingJEEPFREAK

Savage not shifting!

I have a savage 25 with a collari .30 the problem is that it shifts only half the time. the rest of the time it acts like it gets stuck in 1st gear. can someone please help me out with this?
06-17-2005, 12:20 AM
Replies: 11
Views: 894
Posted By WyomingJEEPFREAK

RE: HELP!!!!!

My flywheel is way to close to the block and my clutch bell is freezing up because of the brass bushing
06-14-2005, 02:55 AM
Replies: 11
Views: 894
Posted By WyomingJEEPFREAK

RE: HELP!!!!!

[:@] Damn, I have a Collari .30, Stock Savage 25 flywheel. OK Give me my sign.:eek:
06-13-2005, 11:53 PM
Replies: 11
Views: 894
Posted By WyomingJEEPFREAK

HELP!!!!!

What bushing are you all using behind the flywheel? My flywheel is going too deep and my clutchbell doesnt fit right. Hope this makes sense?
06-09-2005, 07:58 PM
Replies: 0
Views: 434
Posted By WyomingJEEPFREAK

Tuning Collari 30

ok, I have put probably close to a gallon of fuel through my new collari. That was between Wyoming and california. I am back in Wyoming and no matter what I try I cant get it to run right. I get ALOT...
05-26-2005, 02:28 AM
Replies: 2
Views: 450
Posted By WyomingJEEPFREAK

RE: Werks Info

Thank you, Sent them an email
05-26-2005, 01:46 AM
Replies: 2
Views: 450
Posted By WyomingJEEPFREAK

Werks Info

Is there a phone number for Werks? Also an email address.
05-24-2005, 11:28 PM
Replies: 8
Views: 547
Posted By WyomingJEEPFREAK

RE: Shuts off when I use the brake

I have turned it all the way in, I opperated the carb and it stays half open all the time I cant get it to shut anymore. I have to hold the brake to get it to idle down
05-24-2005, 11:02 PM
Replies: 8
Views: 547
Posted By WyomingJEEPFREAK

Shuts off when I use the brake

I got my colarri in and can start it but I cant idle it down and when I push the trigger forward for brake it shuts off my carb and kills the engine. Also my throttle linkage has about the spacing of...
05-24-2005, 10:58 PM
Replies: 11
Views: 600
Posted By WyomingJEEPFREAK

RE: Collari Thread

I have the silver needle
05-24-2005, 03:08 AM
Replies: 11
Views: 600
Posted By WyomingJEEPFREAK

RE: Collari Thread

Thanks for that Info, I have another question. Is there supposed to be a sleve between the engine and carb? Might sound dumb but I got NOTHING with this engine and it is brand new. Cost too much to...
05-24-2005, 12:32 AM
Replies: 11
Views: 600
Posted By WyomingJEEPFREAK

Collari Thread

Where is the collari .30 engine thread? I need to get mine set up
05-23-2005, 10:25 PM
Replies: 4
Views: 715
Posted By WyomingJEEPFREAK

RE: Exhaust Problem

The manifold on my savage is too big in diameter. Is there a manifold that will fit from another size engine?
05-23-2005, 07:21 PM
Replies: 4
Views: 715
Posted By WyomingJEEPFREAK

Exhaust Problem

OK, I got my collari .30. Looks good and I hope it runs as good as it looks but, What did you guys with the savage 25 use for exhaust header and pipe?I need something I can get from like Hobbytown...
05-23-2005, 02:30 AM
Replies: 6,157
Views: 660,292
Posted By WyomingJEEPFREAK

RE: PICS OF YOUR SAVAGES !!

Thanks I found it:eek:
05-23-2005, 02:23 AM
Replies: 6,157
Views: 660,292
Posted By WyomingJEEPFREAK

RE: PICS OF YOUR SAVAGES !!

My Savage, Waiting for the Collari .30 and The real expensive toy Waiting for the new drive shaft I broke this trip up Carnage Canyon. Will my luck ever change? Jumbo Kongs are hard on the savage and...
05-23-2005, 02:09 AM
Replies: 5
Views: 694
Posted By WyomingJEEPFREAK

RE: Race story - Savage vs Dad's DS650 quad

Nice short story. You should write books. But still I would have liked to have seen that. Cool Man
05-22-2005, 02:34 PM
Replies: 7
Views: 458
Posted By WyomingJEEPFREAK

RE: One way slipping

what are you using to start it with? I used a cordless drill one and ruined mine. Best thing to use is the roto starter To turn it over.
Showing results 1 to 25 of 43
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.