RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 5
1
2
3
Last »
Search: Posts Made By: FlyJ
Showing results 1 to 25 of 107
Search took 0.41 seconds.
Forum: RC Jets
04-11-2024, 04:15 PM
Replies: 100
Views: 17,402
Posted By FlyJ

Tank mount goes behind the tube. It should also...

Tank mount goes behind the tube. It should also be glued to the wingtube sleeve for additional stiffness.

Vector rods need to be trimmed slightly. Degrease the threaded rods very well, then hysol...
Forum: RC Jets
04-07-2024, 06:46 AM
Replies: 17
Views: 971
Posted By FlyJ

[email protected]

[email protected]
Forum: RC Jets
04-06-2024, 09:23 PM
Replies: 17
Views: 971
Posted By FlyJ

There’s a new update from Vspeak that will allow...

There’s a new update from Vspeak that will allow you to use the single white wire as your throttle cable directly from your CB. Avoid all the throttle communication over the Bus.

Email Volker and...
Forum: RC Jets
03-19-2024, 05:22 PM
Replies: 1
Views: 228
Posted By FlyJ

I’d recommend using a potentiometer and a...

I’d recommend using a potentiometer and a momentary push button. The button will be used to shut the turbine down (this replaces the trim down). when the button is pressed, the Arduino sends a low...
Forum: RC Jets
01-21-2024, 01:19 PM
Replies: 100
Views: 17,402
Posted By FlyJ

Carbon frame and full PB will not save weight....

Carbon frame and full PB will not save weight. That makes 0 sense, it's a moment arm. The farther the weight is forwards the more it effects the CG. I opted for a small PB, then to add weight in the...
Forum: RC Jets
01-21-2024, 08:47 AM
Replies: 100
Views: 17,402
Posted By FlyJ

https://cimg2.ibsrv.net/gimg/www.rcuniverse.com-vb...

https://cimg2.ibsrv.net/gimg/www.rcuniverse.com-vbulletin/2000x1504/img_5022_f24adfc24eb07d8113e018861bba8b6ab94cf69c.jpeg
Forum: RC Jets
01-20-2024, 11:00 AM
Replies: 100
Views: 17,402
Posted By FlyJ

I've got about 15 flights on mine now and settled...

I've got about 15 flights on mine now and settled on a nice CG. Total weight is 12.7kg (28lbs) with fuel in the UAT. All batteries are next to the nose wheel, and I have ~200g in the nose of the...
Forum: RC Jets
12-25-2023, 09:16 AM
Replies: 6
Views: 1,152
Posted By FlyJ

1/5 or 1/6 BVM F-16 CARF F-100

1/5 or 1/6 BVM F-16
CARF F-100
Forum: RC Jets
12-23-2023, 11:22 PM
Replies: 14
Views: 1,390
Posted By FlyJ

I flew mine without a cockpit and had all the...

I flew mine without a cockpit and had all the batteries behind the nose gear. It’s a much cleaner airframe than the rebels so it takes more time to burn off speed. If you hold it off the runway it...
Forum: RC Jets
12-23-2023, 03:58 PM
Replies: 14
Views: 1,390
Posted By FlyJ

I had the prior and it was an absolute dream to...

I had the prior and it was an absolute dream to fly. Very low stress airplane in every way. It slows down wonderfully due to its long high aspect wings with light wing loading. I’d recommend this...
Forum: RC Jets
12-07-2023, 09:38 AM
Replies: 15
Views: 991
Posted By FlyJ

Doesn't sound like you did anything wrong. Sounds...

Doesn't sound like you did anything wrong. Sounds like a faulty motor if anything. Can you try to use the GS200 screen to retract the gear instead of the matchbox? From the main screen you can click...
Forum: RC Jets
11-21-2023, 11:22 PM
Replies: 1,019
Views: 272,676
Posted By FlyJ

EDIT WITH SOLUTION: Turns out I needed to reteach...

EDIT WITH SOLUTION: Turns out I needed to reteach the signal type with both receivers plugged in. Simple fix. I must have taught the gyro with only one receiver was plugged in the first time. Works...
Forum: RC Jets
11-19-2023, 07:39 PM
Replies: 6
Views: 826
Posted By FlyJ

Contact Carlos at CMJ. He will make custom fuel...

Contact Carlos at CMJ. He will make custom fuel bags for you.

https://cmjets.com/
Forum: RC Jets
11-06-2023, 12:25 PM
Replies: 857
Views: 268,877
Posted By FlyJ

I have a SW-140 for sale. Sent you a PM.

I have a SW-140 for sale. Sent you a PM.
Forum: RC Jets
08-08-2023, 06:32 AM
Replies: 21
Views: 4,398
Posted By FlyJ

Be sure to take off with the gyro OFF for the...

Be sure to take off with the gyro OFF for the first flight!!! Only switch the gyro on once you’re at a good safe height. If something isn’t working properly, you’ll want a bit of altitude to turn the...
Forum: RC Jets
07-27-2023, 12:50 PM
Replies: 1,950
Views: 404,285
Posted By FlyJ

Did you also teach the end points after teaching...

Did you also teach the end points after teaching the mounting position?
Forum: RC Jets
07-27-2023, 11:11 AM
Replies: 1,950
Views: 404,285
Posted By FlyJ

It's not a problem to have the elevators move in...

It's not a problem to have the elevators move in different directions during the teach portion. Once you go through the mounting position teach and the end points teach, you'll see the elevators move...
Forum: Marketplace
07-03-2023, 07:14 PM
Replies: 0
Views: 276
Posted By FlyJ

CARF Sukhoi 2.75m

Need space in the shop so getting rid of this low time Sukhoi. Only been flown a handful of times, in excellent condition.

JR 8711s all around
Powerbox Mercury
SWB rudder tray

DA-120 not...
Forum: RC Jets
06-29-2023, 04:43 PM
Replies: 12
Views: 2,141
Posted By FlyJ

Rebel max. 54lbs with fuel, lands at a walking...

Rebel max. 54lbs with fuel, lands at a walking speed.
Forum: Marketplace
06-25-2023, 11:26 AM
Replies: 0
Views: 251
Posted By FlyJ

Jr 8477

4x JR 8477SS mounted but never flown. 500oz, 0.1s/60°.

$125 each or $460 for all four. Free shipping within USA.

https://gator-rc.com/jr-propo-dfa-s8...ue-at-hv?amp=1...
Forum: Marketplace
06-20-2023, 03:19 PM
Replies: 3
Views: 753
Posted By FlyJ

Sent you another PM. Very interested in picking...

Sent you another PM. Very interested in picking this up!
Forum: Marketplace
06-11-2023, 07:52 AM
Replies: 3
Views: 753
Posted By FlyJ

Sent you a PM

Sent you a PM
Forum: RC Jets
05-23-2023, 11:05 AM
Replies: 11
Views: 1,841
Posted By FlyJ

I put this in CAD for you and it shows the...

I put this in CAD for you and it shows the geometry problem well.

Setup:
4" servo arm
2" control horn
18" wires

When both arms are horizontal, hole-to-hole lengths are 18" (this is set by...
Forum: RC Jets
05-23-2023, 06:39 AM
Replies: 1,950
Views: 404,285
Posted By FlyJ

Just use the 12x with a 26D.

Just use the 12x with a 26D.
Forum: RC Jets
05-18-2023, 03:12 PM
Replies: 778
Views: 163,697
Posted By FlyJ

I don't think I have any brakes that will hold...

I don't think I have any brakes that will hold the airplane about 50% throttle. Sounds like they're already quite strong. Are you using electron or JP?
Showing results 1 to 25 of 107
 
Page 1 of 5
1
2
3
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.