RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: edp
Showing results 1 to 25 of 500
Search took 0.78 seconds.
Forum: Kit Building
02-13-2020, 07:00 PM
Replies: 855
Views: 40,901
Posted By edp

I used Titebond when I built CG Electras w/o any...

I used Titebond when I built CG Electras w/o any loosening, even on a panic pull out. Just a nice thin bead is all that was needed on the ribs. I then wrapped w/ an Ace Bandage to gently hold in...
Forum: Kit Building
01-19-2020, 09:39 AM
Replies: 855
Views: 40,901
Posted By edp

Thank you. I've always like the Debonair and...

Thank you.
I've always like the Debonair and Bonanza series. I build Ballistic Pattern birds but will finish other's scale stuff for a challenge.
Forum: Kit Building
01-19-2020, 08:23 AM
Replies: 855
Views: 40,901
Posted By edp

https://cimg0.ibsrv.net/gimg/www.rcuniverse.com-vb...

https://cimg0.ibsrv.net/gimg/www.rcuniverse.com-vbulletin/2000x1504/100_1309_f80f98b40ba4343172ae4c52813b51cf86975e74.jpg...
09-05-2019, 06:01 AM
Replies: 242
Views: 36,017
Posted By edp

Fair enough, I have two vinyl cutters that I cut...

Fair enough, I have two vinyl cutters that I cut masks with. Your was IS much faster. I'll spend an hour to mask, three minutes to shoot and another half hour to unmask.
Your bird is looking good....
09-04-2019, 01:42 PM
Replies: 242
Views: 36,017
Posted By edp

Paint them, Ziroli 72" version. KlassKote w/ dead...

Paint them, Ziroli 72" version. KlassKote w/ dead flat additive. I used silver ultracote sanded at different angles for covering and the paint sticks very well. I've been following this build as I...
Forum: Kit Building
07-02-2019, 04:34 PM
Replies: 15
Views: 940
Posted By edp

Fillers and Thickeners for Polyester and Epoxy...

Fillers and Thickeners for Polyester and Epoxy Resins (http://fiberglasssupply.com/Product_Catalog/Fillers/fillers.html)
Look under modifiers. I use this stuff all the time mix as little or as...
03-25-2019, 01:54 PM
Replies: 3
Views: 270
Posted By edp

https://cimg5.ibsrv.net/gimg/www.rcuniverse.com-vb...

https://cimg5.ibsrv.net/gimg/www.rcuniverse.com-vbulletin/2000x1504/100_2023_a68aa0b3b8d869b9f2c0d05672cfd46bd0412954.jpg...
03-08-2019, 06:52 PM
Replies: 118
Views: 19,776
Posted By edp

Here is the Phoenix 8 from earlier...

Here is the Phoenix 8 from earlier post.https://cimg1.ibsrv.net/gimg/www.rcuniverse.com-vbulletin/2000x1111/p1_90f20430556055630c850bad9b62d12f1cabb718.jpg...
03-05-2019, 06:50 AM
Replies: 118
Views: 19,776
Posted By edp

Ken, now that is sharp! It will show up very well...

Ken, now that is sharp! It will show up very well in all sky conditions.
Good job,
Ed
08-04-2018, 01:02 PM
Replies: 139
Views: 25,690
Posted By edp

The firewalls are offset to help w/ single engine...

The firewalls are offset to help w/ single engine flight. During takeoff w/ full power, only a little rudder was really needed. In the air it tracked arrow straight as it was designed to be a pattern...
02-28-2018, 10:44 AM
Replies: 11
Views: 2,207
Posted By edp

Did you pick that up at the Wooster, Oh swap shop?

Did you pick that up at the Wooster, Oh swap shop?
02-20-2018, 08:57 PM
Replies: 235
Views: 36,760
Posted By edp

I didn't know he had a post, but here is mine on...

I didn't know he had a post, but here is mine on a Zeroli 72" P-47 and E-flite release.
02-10-2018, 10:03 AM
Replies: 39
Views: 13,195
Posted By edp

I have been using Klass Kote a lot lately. ...

I have been using Klass Kote a lot lately.
https://www.rcgroups.com/forums/showthread.php?2803097-BAC-Phoenix-8-build#post36510096
Toward the end is the finishing of my Phoenix 8.
02-10-2018, 09:49 AM
Replies: 3
Views: 435
Posted By edp

I was in the Navy in the early '80's and I don't...

I was in the Navy in the early '80's and I don't think all squadrons used the the same font. Some were block and some more rounded. Here are a couple of our EA-6B Prowlers.
02-10-2018, 08:51 AM
Replies: 3
Views: 435
Posted By edp

AmarilloUSAF font is close.

AmarilloUSAF font is close.
02-10-2018, 08:44 AM
Replies: 39
Views: 13,195
Posted By edp

My RCAIIR Illusion

Going into the air this Summer
01-12-2018, 03:07 PM
Replies: 14
Views: 754
Posted By edp

The paint is bad but the reducer, well that's a...

The paint is bad but the reducer, well that's a different story. I shoot when she is out for the day and I can open up the house. I do run a fan that draws the fumes out my large basement window.
I...
01-12-2018, 11:15 AM
Replies: 14
Views: 754
Posted By edp

This is Klass Kote over burnished Ultracote. I...

This is Klass Kote over burnished Ultracote. I used the dead flat additive. I wet sanded w/ 2000 grit wet to break the lines and weather it a little. The star and bars are decals. I made stencils for...
08-25-2017, 04:11 AM
Replies: 4
Views: 1,140
Posted By edp

This is the Pica-Cox ARF. The gear are Robart's...

This is the Pica-Cox ARF. The gear are Robart's Bonanza gear. The cockpit was scratch built. I may still have a spare canopy if you need it.
Ed
04-30-2017, 08:16 AM
Replies: 7
Views: 1,615
Posted By edp

Check out RCAIIR. He has one listed....

Check out RCAIIR. He has one listed. rcaiir@gmail.com
He is where I got my Illusion from.
04-17-2017, 10:00 AM
Replies: 118
Views: 19,776
Posted By edp

No drawings but everything is set 0-0-0. The side...

No drawings but everything is set 0-0-0. The side thrust is built into the nose ring.
Contact Leo http://www.klasskotemo.com/patternplane.html He makes the T2A's now and will have...
04-17-2017, 05:52 AM
Replies: 118
Views: 19,776
Posted By edp

Do yours look like this? These are the ones that...

Do yours look like this? These are the ones that I use for mine.
http://www.rcuniverse.com/forum/attachment.php?attachmentid=2210283
04-16-2017, 12:46 PM
Replies: 118
Views: 19,776
Posted By edp

These are good flying airplanes. I need to do the...

These are good flying airplanes. I need to do the white and add the graphics yet. I have too many projects going at once.
http://www.rcuniverse.com/forum/attachment.php?attachmentid=2210199I'm...
04-14-2017, 01:22 PM
Replies: 5
Views: 1,189
Posted By edp

Oops, your fuselage star and bar is upside down....

Oops, your fuselage star and bar is upside down. You are not the first beautiful warbird I've seen to have one.
Forum: Kit Building
03-30-2017, 02:35 PM
Replies: 13
Views: 1,095
Posted By edp

Cool, glad we could help.

Cool, glad we could help.
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.