RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: dschroeder
Showing results 1 to 25 of 192
Search took 0.38 seconds.
11-14-2018, 06:03 PM
Replies: 0
Views: 432
Posted By dschroeder

Looking for build suggestions for twin electric outboard

I have a pair of new in the box hobbyco electric outboards from their RC bass boat years ago. Looking for ideas on something to build and use these on
Forum: Kit Building
06-17-2013, 11:02 AM
Replies: 17
Views: 3,480
Posted By dschroeder

RE: Midwest Super Stearman Instructions

I know it's an old post... Just bought a bare airframe at an auction. Was wondering if you had the control throws and CG info you could send me.
02-19-2011, 10:01 PM
Replies: 7
Views: 910
Posted By dschroeder

RE: bought this at a club auction...what engine?

no radio gear is in it, just the bare airframe at the moment. the engine bay is fairly small...I pulled a BME90 (St90 converted for gas) out of the closet and it drops right in.... at ST2300 fits...
02-19-2011, 06:24 PM
Replies: 7
Views: 910
Posted By dschroeder

RE: bought this at a club auction...what engine?

the weight I posted was from when I weighed the airframe (as pictured) this am
02-19-2011, 02:34 PM
Replies: 7
Views: 910
Posted By dschroeder

bought this at a club auction...what engine?

I bought this at a recent club auction...span is 80" airframe as pictured weighs 5.2 lbs. horiz stab is airfoiled (flat bottom airfoil) I was thinking around a 90 2-stroke...suggestions?

...
02-19-2011, 12:23 PM
Replies: 2
Views: 941
Posted By dschroeder

ST 2300 prop

what is a good starting prop for a St2300, its going on a cap that will be a non 3-d plane
02-11-2011, 10:29 PM
Replies: 2
Views: 1,797
Posted By dschroeder

fowler flap hinge control hookup

i have a plane with some hinges that simulate a fowler flap (similar to how the top flite cessna 182 hinges work....got the plane in the bare bones stage with no control rods installed. how should I...
02-06-2011, 08:44 AM
Replies: 1
Views: 1,297
Posted By dschroeder

dynaflite fly baby engine recomendations

I picked up a fly baby (80") at a recent club auction, its a finished airframe, covered but no instructions. does anyone have the control throws for this plane?

and what engine should I fly...
Forum: Sport Flying
01-23-2011, 08:33 AM
Replies: 5
Views: 1,078
Posted By dschroeder

RE: old OS 90-FS (pre surpass) needing a home

what about the 60 sized twist? saw it wasn't too expensive, i have the 40 sized one (the yellow version) and its alot of fun
Forum: Sport Flying
01-22-2011, 06:19 PM
Replies: 5
Views: 1,078
Posted By dschroeder

old OS 90-FS (pre surpass) needing a home

any suggestions for a cheaper arf for a sport flyer...i was given an old OS 90 4-stroke (pre surpass) so its not the most powerful thing out there...but price was right (free)
Forum: ARF or RTF
12-31-2010, 03:49 PM
Replies: 1,842
Views: 284,612
Posted By dschroeder

RE: Great Planes Escapade .40 ARF

i'm going to put a ST 45 on mine, side mounted with the cowl...hoping it all fits in there
12-31-2010, 03:44 PM
Replies: 74
Views: 14,175
Posted By dschroeder

RE: New Twin Commanche ARF

any more word on this plane showing up?
Forum: Gas Engines
12-18-2010, 03:36 PM
Replies: 2
Views: 474
Posted By dschroeder

kalt g-22 prop

I picked up a never seen fuel kalt g-22...i'm putting it on a 4-star 120...what is a good prop for this engine? (didn't get a manual with it)
Forum: 3D Flying!
12-14-2010, 06:19 PM
Replies: 1
Views: 568
Posted By dschroeder

3D prop for magnum 52 4-stroke

whats a good prop to put on a magnum 52 4-stroke...its on H9 tribute 36
Forum: Gas Engines
12-05-2010, 07:54 PM
Replies: 58
Views: 5,366
Posted By dschroeder

RE: carb diaphram replacement color/material

rock on, i'll give it a shot. have you run it in gas engines before?

Jody- i greatly appreciate your advice, kinda new to flying gassers
Forum: Gas Engines
12-05-2010, 07:34 PM
Replies: 58
Views: 5,366
Posted By dschroeder

RE: carb diaphram replacement color/material

never thought of using one of the fuel scents, i've used them in glow fuel before though. is 100LL hard on engines?
Forum: 3D Flying!
12-05-2010, 09:52 AM
Replies: 6
Views: 780
Posted By dschroeder

RE: frenzy and ST90

cool....what prop did you run on the os 91 2-stroke...wasn't sure what a good starting point would be for that plane...i'm assuming the recommended props have too much pitch they recommend a 13x6...
Forum: Gas Engines
12-05-2010, 09:50 AM
Replies: 58
Views: 5,366
Posted By dschroeder

RE: carb diaphram replacement color/material

i'm thinking about running 100LL av-gas next season to keep the smell down in the basement...does it need a specific pump diaphram or will it work with the blue or white ones just fine?
Forum: 3D Flying!
12-04-2010, 08:29 PM
Replies: 6
Views: 780
Posted By dschroeder

RE: frenzy and ST90

i was thinking about side mounting the engine...just never had much luck with inverted 2 strokes
Forum: 3D Flying!
12-03-2010, 09:29 PM
Replies: 6
Views: 780
Posted By dschroeder

frenzy and ST90

I picked up a frenzy 100, would a ST 90 fly it decent? I'm not into real "hardcore" 3d basically going to fly it as a sport aerobatic ship. I have a few profiles for serious 3d
12-03-2010, 08:07 PM
Replies: 1
Views: 482
Posted By dschroeder

OS 108

I recently purchased a used os 108, pulled the backplate and found a few small metal shavings, i think they came from the bottom of the connecting rod contacting the inside of the crankcase around...
Forum: Gas Engines
12-02-2010, 11:49 PM
Replies: 58
Views: 5,366
Posted By dschroeder

carb diaphram replacement color/material

i bought a kit to rebuild a walbro carb...i noticed there are different color/material pump parts in the kit (black, blue and a semi transparent white) whats the difference in them? they appear to...
12-02-2010, 11:47 PM
Replies: 5
Views: 1,253
Posted By dschroeder

walbro carb pump diaphram colors

i bought a kit to rebuild a walbro carb...i noticed there are different color/material pump parts in the kit (black, blue and a semi transparent white) whats the difference in them?
Forum: ARF or RTF
11-28-2010, 04:43 PM
Replies: 343
Views: 63,241
Posted By dschroeder

RE: New Great Planes Escapade 61.

i'm hoping it actually comes with the cowl unlike the original escapade that you had to buy it seperatly
Forum: ARF or RTF
11-28-2010, 03:38 PM
Replies: 1,842
Views: 284,612
Posted By dschroeder

RE: Great Planes Escapade .40 ARF

what do you all think of either a 46LA or a Evolution 36 in this plane? i have both of them laying around, figured it'd make a good match.
Showing results 1 to 25 of 192
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.