RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: beaverboy
Showing results 1 to 3 of 3
Search took 0.07 seconds.
12-09-2007, 03:41 PM
Replies: 18
Views: 2,168
Posted By beaverboy

RE: stuffing tube

I ran 15% for the first 6 tanks during break in of my MV. Then I used 30% for the next 4 tanks. By then the piston and cylinder liner were broken in - no sag during full throttle runs. I think my...
12-09-2007, 12:41 PM
Replies: 18
Views: 2,168
Posted By beaverboy

RE: stuffing tube

It is simple to make a brass tubing shim (or two in case you drop one). I have had problems with "stuck" stock Aqua drive dog set screws so I use an Octura drive dog. Not trying to answer for you,...
12-09-2007, 01:35 AM
Replies: 18
Views: 2,168
Posted By beaverboy

RE: stuffing tube

I'm running the stock Mean Machine collet on an OS 18CVR-M connected to a Prather 3/16" flex shaft running in a 1/4" OD brass stuffing tube with no problem so far in my MM hull. I check the...
Showing results 1 to 3 of 3


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.