RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: HomeDawwg
Showing results 1 to 4 of 4
Search took 0.09 seconds.
Replies: 762
Views: 191,019
Posted By HomeDawwg

RE: Official HPI E-10 Thread

Look at the picture you posted of the mount. The top mounting hole on the hot-racing mount is not centered, here is a side profile mock-up.
http://img14.imageshack.us/img14/608/mounty.jpg

...
Replies: 762
Views: 191,019
Posted By HomeDawwg

RE: Official HPI E-10 Thread

Nice to see HPI finally released an alloy motor mount. The first thing i bought for my e10 was the hot-racing aluminium motor mount, imo is an essential item otherwise the gear mesh just isnt right...
Replies: 762
Views: 191,019
Posted By HomeDawwg

RE: Official HPI E-10 Thread

That link doesnt say anything about motor limit, so i would stay away from it.

The stock e10 esc can handle 21-27 turn motors (and in my opinion you wouldnt want any faster than that in this car)....
Replies: 762
Views: 191,019
Posted By HomeDawwg

RE: Official HPI E-10 Thread

Mine stock e10 also does this. I think like phmaximus mentioned, that the alloy shafts/cvs would improve it. Ive run mine for a little while now as is and it still drifts well, so im not sure it...
Showing results 1 to 4 of 4


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.