RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: Tip22v
Showing results 1 to 25 of 500
Search took 0.38 seconds.
Forum: RC Jets
09-28-2021, 06:27 AM
Replies: 2,851
Views: 473,146
Posted By Tip22v

Winter, Iím still flying my T1 jets as often as...

Winter, Iím still flying my T1 jets as often as possible, but Iíve also been converting and flying small micro jets:) Hope you are doing well. -Tom
Forum: RC Jets
09-27-2021, 04:33 PM
Replies: 2,851
Views: 473,146
Posted By Tip22v

So sorry to hear that. I did that on a gas...

So sorry to hear that. I did that on a gas powered plane a few years back, tough way to lose a plane. In my case I had flown the plane many times then decided to upgrade the aileron servos, I had no...
Forum: RC Jets
09-27-2021, 12:50 PM
Replies: 2,851
Views: 473,146
Posted By Tip22v

sorry to hear about your loss, what happened?

sorry to hear about your loss, what happened?
Forum: RC Jets
09-23-2021, 10:15 AM
Replies: 20
Views: 2,847
Posted By Tip22v

Okay, after studying these photos and reading the...

Okay, after studying these photos and reading the wiki page again Iím feeling a lot more confident that this is not going to be difficult to do:) I bought another X45 for this project and...
Forum: RC Jets
09-22-2021, 02:12 PM
Replies: 20
Views: 2,847
Posted By Tip22v

thanks for the info! -Tom

thanks for the info! -Tom
Forum: RC Jets
09-21-2021, 07:25 PM
Replies: 20
Views: 2,847
Posted By Tip22v

Is there a build thread for the turbine...

Is there a build thread for the turbine conversion? Iím about to start the conversion with an X45 and this is looking more difficult the more I study it. Iíve done several small EDF to turbine...
Forum: RC Jets
09-16-2021, 11:21 AM
Replies: 2,004
Views: 291,991
Posted By Tip22v

test

test
Forum: RC Jets
09-16-2021, 10:20 AM
Replies: 488
Views: 48,905
Posted By Tip22v

I think your "Lower Voltage = Higher Amperage"...

I think your "Lower Voltage = Higher Amperage" theory is the most likely scenario with this issue. This is one of the reasons I like to run a VR into my LG15 (I also regulate to 7.5v), a consistent...
Forum: RC Jets
09-16-2021, 07:19 AM
Replies: 233
Views: 44,280
Posted By Tip22v

what is the tedious pump factor setting issue? I...

what is the tedious pump factor setting issue? I have five Xicoy turbines, how do I tell which have the issue and which donít? Thanks for the help. -Tom
Forum: RC Jets
09-16-2021, 07:16 AM
Replies: 233
Views: 44,280
Posted By Tip22v

Iíím using the HAB single wall pipe with tape in...

Iíím using the HAB single wall pipe with tape in my FW T45, itís a good setup and works well. Iím using a double wall pipe with tape in my FW T33, works well. Iím using a double wall pipe with no...
Forum: RC Jets
05-03-2021, 12:29 PM
Replies: 1,602
Views: 218,740
Posted By Tip22v

https://cimg7.ibsrv.net/gimg/www.rcuniverse.com-vb...

https://cimg7.ibsrv.net/gimg/www.rcuniverse.com-vbulletin/2000x1504/img_0534_6ffd8d9b19ba742c80098816bb006f3fddf8cf96.jpg
This is my fourth T1 Mini, this one is powered by a Xicoy X90, my other two...
Forum: RC Jets
04-22-2021, 02:51 PM
Replies: 1
Views: 600
Posted By Tip22v

I have three of these CRUs, I cannot get the nose...

I have three of these CRUs, I cannot get the nose wheel to be gyro controlled. I've gone into the Jeti Device Explorer and enabled the gyro, but it's not compensating when the nose yaws left or...
Forum: RC Jets
03-06-2021, 02:13 PM
Replies: 1,095
Views: 284,586
Posted By Tip22v

cool, sounds the the shipping issues might be...

cool, sounds the the shipping issues might be fixed. All of the HAB pipes Iíve gotten so far are single wall, which might explain why they are lighter.
Forum: RC Jets
03-06-2021, 11:32 AM
Replies: 1,095
Views: 284,586
Posted By Tip22v

i have used the HAB kits in other conversions...

i have used the HAB kits in other conversions with much success. I acquired this jet used and it came with a Grumania pipe. I would order another kit from HAB but the last one I ordered (last summer)...
Forum: RC Jets
03-06-2021, 09:07 AM
Replies: 1,095
Views: 284,586
Posted By Tip22v

What diameter pipe are folks using on Sebart...

What diameter pipe are folks using on Sebart Mini-Avanti? I have a grumania pipe, rough measurements put the ID around 50mm and OD around 55mm. The problem is that the pipe touches the carbon spar...
Forum: RC Jets
03-01-2021, 01:12 PM
Replies: 233
Views: 44,280
Posted By Tip22v

Question for those of you using the AG63 gyro...

Question for those of you using the AG63 gyro brake controller. I installed one in my FW T33 powered by Xicoy X45. I went through the setup and everything seemed like it was working correctly. On my...
Forum: RC Jets
02-28-2021, 07:19 PM
Replies: 233
Views: 44,280
Posted By Tip22v

Looks awesome! I have mounted that same UAT with...

Looks awesome! I have mounted that same UAT with a K30 in a Habu32 and it works fine on it's side. As someone said here though, make sure you tilt the airframe when you are fueling to make sure you...
Forum: RC Jets
02-27-2021, 07:34 AM
Replies: 972
Views: 149,179
Posted By Tip22v

if the wire loom fixes the problem then the...

if the wire loom fixes the problem then the problem is not likely noise from the turbine. Are both of you using Futaba sBus connection? Iím running 5 cortex pros in 5 different jets with Jeti EX bus...
Forum: RC Jets
02-11-2021, 03:27 PM
Replies: 233
Views: 44,280
Posted By Tip22v

Greg, thanks for the info. If this unit works as...

Greg, thanks for the info. If this unit works as well as I'm thinking it will I'm going to retrofit my other micro turbine jets with them:). Has anyone tried this unit on a larger jet with electric...
Forum: RC Jets
02-11-2021, 12:19 PM
Replies: 233
Views: 44,280
Posted By Tip22v

I was finally able to get out and do some...

I was finally able to get out and do some hi-speed taxi testing to test this controller on my Habu32x with a K30, worked really well. The jet stopped straight every time:). However, I have not...
Forum: RC Jets
02-03-2021, 01:34 PM
Replies: 233
Views: 44,280
Posted By Tip22v

Using the above instructions, not the...

Using the above instructions, not the instructions that were included with the unit, I was able to get the unit to AUTOCONFIG. I verified that the steering servo self corrected when I move the nose...
Forum: RC Jets
02-03-2021, 12:20 PM
Replies: 233
Views: 44,280
Posted By Tip22v

Okay, so I received an email from GJC with new...

Okay, so I received an email from GJC with new instructions, which are different from the instructions included with the unit. I will give these instructions a try and see if I can get the unit to...
Forum: RC Jets
02-03-2021, 12:11 PM
Replies: 233
Views: 44,280
Posted By Tip22v

Thanks, fortunately our winters are fairly mild...

Thanks, fortunately our winters are fairly mild in comparison to Kentucky (spent 5 years at Ft. Campbell) so I hope to get out a try it soon. -Tom
Forum: RC Jets
02-03-2021, 09:47 AM
Replies: 233
Views: 44,280
Posted By Tip22v

Thanks, do your brakes adjust to keep the nose...

Thanks, do your brakes adjust to keep the nose straight?
Forum: RC Jets
02-02-2021, 07:59 PM
Replies: 233
Views: 44,280
Posted By Tip22v

So, I got my brake controller from GJC. I cannot...

So, I got my brake controller from GJC. I cannot get it to AUTOCONFIG. I must be doing something wrong. I followed the directions, they seem pretty straight forward. After power-on (within 1 min) I...
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright © 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.