Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: Clipclop
Showing results 1 to 25 of 47
Search took 0.65 seconds.
08-19-2010, 08:18 PM
Replies: 256
Views: 78,021
Posted By Clipclop

RE: Cox R/C Aircraft Collection

STOP...STOP...There's only so much nostalgia my finger can take!!
08-19-2010, 05:43 PM
Replies: 256
Views: 78,021
Posted By Clipclop

RE: Cox R/C Aircraft Collection

A few years ago at Joe Nall there was a fellow with a tent full of Cox and Testors for sale. The more I wandered around remembering the planes I flew as a boy, my right index finger started to...
03-25-2010, 10:42 AM
Replies: 17
Views: 1,598
Posted By Clipclop

RE: Why doesn't AMA pro-rate dues?

I hope you are as concerned about the consequences of what the House of Representatives did last Sunday night as you are about a few dollars you feel taken from you from an organization you...
Forum: Gas Engines
09-16-2009, 06:26 PM
Replies: 9
Views: 1,411
Posted By Clipclop

RE: Zenoah G20 stops on landing approach

My G20 did the same thing. I upgraded the ignition to a CH. It not only keeps running on landing approach, but also runs better in the air, and its battery doesn't need to be recharged after only...
Forum: Sport Flying
04-21-2009, 06:54 AM
Replies: 4
Views: 718
Posted By Clipclop

RE: 4 Star CG

Thanks, guys, for your help!
Forum: Sport Flying
04-20-2009, 07:21 PM
Replies: 4
Views: 718
Posted By Clipclop

4 Star CG

Does anyone know the CG point for a 4 Star Sixty?
04-17-2009, 07:26 PM
Replies: 2
Views: 646
Posted By Clipclop

Cowl Cutouts

Tom... If you have a photo of the underside of the cowl of the 88" Edge 540 that shows the location of the cutout for a DA 50, could you post it here? The photos of your throttle and choke servos...
04-13-2009, 07:21 PM
Replies: 5
Views: 1,066
Posted By Clipclop

RE: Throttle/Choke Servos-Edge 540

I figured I couldn't go wrong with a long-winged, wide-chord plane like the 88" Edge 540. The fact that you have kept two Wild Hare's aloft and alive for the past few years played strongly into my...
04-13-2009, 03:31 PM
Replies: 5
Views: 1,066
Posted By Clipclop

RE: Throttle/Choke Servos-Edge 540

Thank you Tom...A picture is worth a thousand words!!
04-13-2009, 01:48 PM
Replies: 5
Views: 1,066
Posted By Clipclop

Throttle/Choke Servos-Edge 540

I'm assembling the 88" Edge 540. I would like some suggestions for the best place to locate the throttle and choke servos and what additional construction might be required for those locations. The...
Forum: Gas Engines
09-28-2008, 10:04 AM
Replies: 8
Views: 684
Posted By Clipclop

RE: Brillelli 46 Flooding

I checked both sides of the carb and everything appeared to be as it should. No air passed through the carb when I blew into the fuel intake. I leaned both the high (11/8) and the low (1) ends, and...
Forum: Gas Engines
09-27-2008, 05:04 PM
Replies: 8
Views: 684
Posted By Clipclop

Brillelli 46 Flooding

My new Brillelli 46, despite following some excellent suggestions from other posters and knowledgeable flyers at my club, continues to be hard to start, hard to keep running, and gas drips and...
Forum: Gas Engines
09-16-2008, 08:34 PM
Replies: 4
Views: 680
Posted By Clipclop

RE: Engine Flooding

Thank you, Mike and Pe, for the suggestions for making the engine run and possible reasons for its behavior. I closed the low end from the factory setting of 1 1/4 turn to 1. The engine started...
Forum: Gas Engines
09-16-2008, 11:48 AM
Replies: 4
Views: 680
Posted By Clipclop

Engine Flooding

I have a new Brillelli 46 that started twice just as it should. Attempting to start it for the third time about one week later was different. The engine "popped" when choked but wouldn't start or...
12-05-2007, 06:56 AM
Replies: 3
Views: 490
Posted By Clipclop

Battery Chargers

What is a good charger for larger-size (1400 and higher) NiMH and NiCad batteries that is not a rapid, field charger and can charge multiple batteries at the same time?
09-21-2007, 02:29 PM
Replies: 1
Views: 423
Posted By Clipclop

G20 Ignition

I've been told that the electronic ignition on the Zenoah G20 draws an inordinate amount of power relative to other engines with electronic ignitions. Fifteen minutes of running is said to require...
06-17-2007, 06:23 AM
Replies: 2
Views: 474
Posted By Clipclop

Seagull Yak Antenna

The Seagull Yak has a tube for the antenna that runs almost parallel to the pull/pull wire on the right side and exits the fuse about 1/2 inch from the pull/pull wire. This makes me nervous. Has...
05-07-2007, 06:15 PM
Forum: The Clubhouse
05-02-2007, 02:17 PM
Replies: 109
Views: 6,193
Posted By Clipclop

RE: I've joined the "Dark Side" II

I've avoided the electric world because it does not create a carbon foot print and contribute to controversy. How much footprint does an ignited lipo battery cause? Where can I buy "carbon offsets"...
Forum: The Clubhouse
03-30-2007, 09:03 PM
Replies: 47
Views: 3,421
Posted By Clipclop

RE: Is this the end of HIGH PRICES by Hobby Companies?

I have managed retail operations that sold saddles and othe equestrian supplies/apparel. Many of my suppliers were also my competitors via catalog sales. They certainly didn't want their retailers...
Forum: ARF or RTF
02-26-2007, 09:14 PM
Replies: 316
Views: 24,488
Posted By Clipclop

RE: ARF people - What are your reasons for not building kits?

I assemble ARFs due to time contraints and the desire to keep something in the air. I also build, albiet, slowly because I like to build and pay respect to the heritage of the hobby. I suspect as...
02-13-2007, 09:12 PM
Replies: 5
Views: 22,203
Posted By Clipclop

RE: Is Gorilla Glue fuelproof ?

I hope its nitro and gas proof!! If not, I've got some surprises in my future.
02-13-2007, 09:07 PM
Replies: 0
Views: 320
Posted By Clipclop

Fuel Tank Dimensions for Lanier 300 Extra

Does anyone know the manufacturer whose fuel tank was supplied with Lanier's Extra 300L, 120 size ARF? The space provided in the ARF for the tank appears to be 2 inches by 2 inches square and...
01-23-2007, 06:27 PM
Replies: 3
Views: 621
Posted By Clipclop

What size servos?

I've been given a 120-size Lanier Extra 300. What size (torque) servos should I use? The manual doesn't specify size.
Forum: ARF or RTF
12-20-2006, 07:54 PM
Replies: 20
Views: 2,712
Posted By Clipclop

RE: Tiger Moth 120... but by who?

I have the Aeromodels Tiger Moth and love it. I do suggest that all wires be replaced with a quality, braided fishing leader that can be purchased at a good fishing tackle store or on line with an...
Showing results 1 to 25 of 47
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.