RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: MikeMayberry
Showing results 1 to 25 of 500
Search took 0.93 seconds.
12-06-2016, 03:11 PM
Replies: 7
Views: 551
Posted By MikeMayberry

No, in most cases one battery to power them both...

No, in most cases one battery to power them both is fine. I would recommend a 6V (5 cell NiMh) like this: http://www3.towerhobbies.com/cgi-bin/wti0001p?&I=LXNHS4&P=ML

Mike.
Forum: RC Jets
04-25-2014, 08:39 AM
Replies: 63
Views: 10,221
Posted By MikeMayberry

Hey guys... sorry to hear about the issue. To...

Hey guys... sorry to hear about the issue. To have two servos fail simultaneously in the flaps to me would indicate that there was a slight load on the servos when they were up. It is always good to...
Replies: 6
Views: 526
Posted By MikeMayberry

Make sure you activate the "adjust to trim"...

Make sure you activate the "adjust to trim" function in the menu which then allows you to set it with the throttle trim when the switch activates it.

Mike.
Replies: 4,979
Views: 782,958
Posted By MikeMayberry

RE: New Hitec Aurora 9-Channel 2.4Ghz Radio System

No, it cannot be fixed. Future Hitec radios will have this ability though but the current platform cannot support it.

Mike.
Replies: 11
Views: 875
Posted By MikeMayberry

RE: Hitec 5625 servo play

Hitec makes servos at all levels... the high end products like the 7954SH and up use brass bushings to support the pins since they have much more torque. Just as gears can wear, cases can wear as...
Replies: 11
Views: 875
Posted By MikeMayberry

RE: Hitec 5625 servo play

Check the case tops where the second pin is supported... if this is worn is can cause slop.

Mike.
Replies: 19
Views: 1,436
Posted By MikeMayberry

RE: PCM 512 to 2.4 convesion

If it has a module and is capable of PPM (FM) then it can be converted.

Mike.
Replies: 28
Views: 2,107
Posted By MikeMayberry

RE: 2.4. range greater than 72

Sport Flyer magazine recently did a range check comparison with the popular 2.4ghz systems... all are beyond line of sight but the winner was the Hitec AFHSS system, although they actually ran out of...
Replies: 4,979
Views: 782,958
Posted By MikeMayberry

RE: New Hitec Aurora 9-Channel 2.4Ghz Radio System

Sure they are... they send voltage telemetry back to the TX; you just can't add the additional sensors with the sensor station.

Mike.
Replies: 14
Views: 7,135
Posted By MikeMayberry

RE: Step by Step Hitec Aurora Throttle Cut Programming

Make sure you activate "adjust to trim" and then when the cut switch is on, use the throttle trim to set it. When you release it, then it will go back to the normal trim setting.

Mike.
Replies: 5
Views: 699
Posted By MikeMayberry

RE: HS5645MG for Flaps

You can reverse one of the servos as needed if using them on a Y-harness but still everything to control your flaps is done in the radio.

Mike.
Replies: 5
Views: 699
Posted By MikeMayberry

RE: HS5645MG for Flaps

You will want to ask this question in the Futaba forum then since it is radio, not servo related.

http://www.rcuniverse.com/forum/forumid_125/tt.htm

Mike.
Replies: 5
Views: 699
Posted By MikeMayberry

RE: HS5645MG for Flaps

This would be accomplished in the radio via the programming... which system do you have?

Mike.
Replies: 163
Views: 10,416
Posted By MikeMayberry

RE: New Radio Technology ????? HELP!

Note those not wanting to sell off all their 72Mhz RX can upgrade to the Aurora 9 system which supports both 72Mhz (any channel, any shift) and 2.4Ghz so you can fly all your old stuff and more...
Replies: 2
Views: 683
Posted By MikeMayberry

RE: Rate control mix support

Sorry no, you could not effect the rates with the throttle stick.

Mike.
Replies: 4,979
Views: 782,958
Posted By MikeMayberry

RE: New Hitec Aurora 9-Channel 2.4Ghz Radio System

Yes, just assign the dual rates to a 3 position switch. You could also use a flight condition which could allow for the low and middle rates to be on individual switches for each control surface and...
Replies: 4,979
Views: 782,958
Posted By MikeMayberry

RE: New Hitec Aurora 9-Channel 2.4Ghz Radio System

Low battery... at or below 4.4v with 4 cell or 5.4v with 5 cell.

Mike.
Replies: 6
Views: 1,189
Posted By MikeMayberry

RE: Optic 6 Throttle Setup

Set the trim to 25 (center) so you can trim up or down the same amount. Adjust mechanically as needed.

Mike.
Replies: 10
Views: 1,339
Posted By MikeMayberry

RE: Hitec Aurora9 or JR X9503 Which is better and why?

Disclaimer: I'm biased! ;)

Aurora 9

1. Easiest radio on the planet to program with it's large back lit touch screen and open architecture so that anything can be assigned anywhere!...
Replies: 4
Views: 2,335
Posted By MikeMayberry

RE: Low voltage warning using LIFE batterys

The problem with LiFe batteries is that the discharge curve is very flat and they do not have the gradual drop off like other battery chemistries which makes it hard to detect a low battery without...
Replies: 3
Views: 834
Posted By MikeMayberry

RE: 2.4 Module Beeping Twice

If moving the servo's activates the low battery alarm (4.4v w/ 4cell and 5.4V w/5 cell) then your battery is not sufficient for the application or not charged. I've also seen switches cause this...
Replies: 8
Views: 1,451
Posted By MikeMayberry

RE: HS-5085MG: What is a proper power supply?

The regulator then is the weak point!

Mike.
Replies: 8
Views: 1,451
Posted By MikeMayberry

RE: HS-5085MG: What is a proper power supply?

As discussed... high capacity AA size NiMh cells have difficulty providing adequate amperage for high powered servos although that high of a drop with a single servo is excessive! Sometimes the...
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.