RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: JustHover
Showing results 1 to 23 of 23
Search took 0.14 seconds.
08-04-2011, 11:39 AM
Replies: 7
Views: 802
Posted By JustHover

RE: Brushless motor questions...

Just ordered the BL systems (2) will see how it goes! :D
08-03-2011, 08:06 AM
Replies: 7
Views: 802
Posted By JustHover

RE: Brushless motor questions...

Ah I see. That's a lot simpler than I thought. lol Even a 45:1 gear reduction will be challenging enough. I will go ahead and get the lower kv motor option. Thanks for the help!
08-03-2011, 06:55 AM
Replies: 7
Views: 802
Posted By JustHover

RE: Brushless motor questions...

Hi thanks for the feedback. While I waited for a response I found the Mongoose Micro 1/18 BL System 8.5T (9000kv). It's cheaper than the CC options and it has a robot mode which has the symmetrical...
08-02-2011, 11:28 AM
Replies: 7
Views: 802
Posted By JustHover

Brushless motor questions...

I know there is a place for robotics specific questions, however this is an unusual request, even for robots... I know there are folks here who use CC brushless motor controllers...

I'm wanting...
08-02-2011, 09:17 AM
Replies: 2
Views: 537
Posted By JustHover

Brushless motor questions

I know there is a place for robotics specific questions, however this is an unusual request, even for robots... I know there are folks here who use CC brushless motor controllers...

I'm wanting...
08-02-2011, 09:12 AM
Replies: 2
Views: 2,088
Posted By JustHover

Brushless motor controller for robot...

I'm wanting to use a couple 1/18th scale brushless motors for a differentially steered mini sumo robot. I'm looking at the CC Mamba Micro Pro or the Sidewinder Micro. I need the forward and reverse...
08-02-2011, 08:48 AM
Replies: 3
Views: 1,243
Posted By JustHover

RE: Servo Question

The 805 has the potential to draw a lot of current. What are you using to send control pulses to the servo?
04-15-2011, 02:14 PM
Replies: 0
Views: 436
Posted By JustHover

CX3 battery slide COG shift...

I was wondering if anyone has used a servo on channel 5 to slide the battery forward for increased speed? I'm thinking of trying it on my CX3. It's got all aluminujm parts in the drivetrain. A red...
03-09-2011, 02:40 PM
Replies: 4
Views: 1,336
Posted By JustHover

RE: MCX or MCX2??

My personal preference is the MCX. I have two of the MCX's and two of the MCX2's and I think the MCX flies much much better! I have one of the original yellow MCX's and one that was converted to the...
02-26-2011, 11:19 AM
Replies: 1
Views: 542
Posted By JustHover

CX2 body on a CX3?

I got the CX3 and a red body that fits a CX2. I think it will fit but I have to get a piece of 2mm carbon rod and some tubing that fits snugly as gromets. Anyone tried this? The first feat will be...
02-10-2011, 09:16 AM
Replies: 6
Views: 742
Posted By JustHover

RE: mCX first outdoor flight!

This is perfect! Thanks for the info. I thank you, and my heli thanks you. :D
02-09-2011, 09:25 AM
Replies: 6
Views: 742
Posted By JustHover

RE: mCX first outdoor flight!

I know the original lubricant is an oil, not graphite. Either would probably work, but would like to stick with what the factory uses. Where would someone find thin machine oil? Any mfg info? I don't...
02-08-2011, 09:32 AM
Replies: 6
Views: 742
Posted By JustHover

mCX first outdoor flight!

Hi there!

I got an unexpected warm day (above freezing) so I thought I would attempt some outdoor flying. I set the little guy on the driveway and lifted off. Yaahoo! It immediately went over...
02-08-2011, 09:18 AM
Replies: 1
Views: 427
Posted By JustHover

RE: blade mcx getting a little squirrely!!!

Define "glitching"...

I have been flying my mCX's for a few months with no issues. I have not heard of any trends as far as problems go. I love my mSR.
01-18-2011, 07:17 AM
Replies: 10
Views: 1,088
Posted By JustHover

RE: Flew my MSR for the firt time... Gaaa!

Hard to say... It would be easier to learn the MSR after flying the MCX's. But I enjoy flying my MCX and MCX2 a lot. But if money is tight I suppose just getting the MSR would be ok.
01-16-2011, 07:08 AM
Replies: 50
Views: 4,117
Posted By JustHover

RE: new MSR defect ? please help!!

Also make sure you have full or at least 75% throw, or it may not be enough to correct.
01-16-2011, 07:07 AM
Replies: 50
Views: 4,117
Posted By JustHover

RE: new MSR defect ? please help!!

I can offer some advice. Make sure the room is large enough. I was able to learn my MSR in about 4 battery charges and my only previous experience was only MCX and MCX2 which I got for Christmas......
01-16-2011, 06:39 AM
Replies: 2
Views: 326
Posted By JustHover

RE: Beginner with MCX questions

Hi cubaneight,

Thanks for the reality check. The more I fly the easier it is to get the results I'm after. Thanks again.
01-16-2011, 06:35 AM
Replies: 10
Views: 1,088
Posted By JustHover

RE: Flew my MSR for the firt time... Gaaa!

Hahaha I got it!!! :D

Two things...

I changed the throws from 60% throw and 15% exponential to 75% throw and 25% exp.

My flight attempts were in a 10' x 12' x 8' room. I went to a...
01-14-2011, 10:01 AM
Replies: 0
Views: 261
Posted By JustHover

Does ch5 effect throw on MCXx / DX6i?

I read in the MSR manual that the 5-in-1 board uses ch5 to limit throw. The manual could have added a little more details on this... I'm using DX6i with dual rates. I had the gear switch in the 0...
01-14-2011, 09:50 AM
Replies: 10
Views: 1,088
Posted By JustHover

Flew my MSR for the firt time... Gaaa!

I have been flying an MCX and MCX2's for a couple weeks now and am able to fly using throttle, rudder and elevator. This is a major accomplishment for me. :D I actually have 4 heli's set up in my...
01-13-2011, 02:54 PM
Replies: 15
Views: 1,143
Posted By JustHover

RE: Need advice on which heli to choose

Google Quadcopter and camera. It seams to be a more popular way to get a camera up in the air. :D
01-13-2011, 10:16 AM
Replies: 2
Views: 326
Posted By JustHover

Beginner with MCX questions

Hiya!</p>

I have jumped into this hobby with both feet! I currently own an MCX, 2 MCX2's, and an MSR that I have not flown yet. :D I've gotten them set up on my DX6i as airplanes and I have all...
Showing results 1 to 23 of 23


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.