RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: 600Bob
Showing results 1 to 25 of 137
Search took 0.11 seconds.
Forum: Beginners
11-01-2016, 11:48 AM
Replies: 27
Views: 1,372
Posted By 600Bob

Every turn I make with all my planes involves use...

Every turn I make with all my planes involves use of aileron, rudder and elevator at the same time to varying degrees.
Forum: Beginners
07-05-2016, 02:33 PM
Replies: 33
Views: 2,702
Posted By 600Bob

You should have plenty of RPM and the plane...

You should have plenty of RPM and the plane doesn't weigh much. Are you sure you have the prop on the right way? You would be surprised at how many people have had a prop on backwards LOL.
06-07-2016, 10:24 AM
Replies: 1
Views: 515
Posted By 600Bob

The ESC has a higher amp rating than what you...

The ESC has a higher amp rating than what you should pull with the motor so you should be fine.
Forum: Beginners
05-19-2016, 02:43 PM
Replies: 27
Views: 2,846
Posted By 600Bob

Well yes I meant that was 5 clicks of actual down...

Well yes I meant that was 5 clicks of actual down trim. If it needed 5 clicks up trim to fly right and i gave it 5 clicks back down I would be back to center where I started.

And yes this is for...
Forum: Beginners
05-19-2016, 10:08 AM
Replies: 27
Views: 2,846
Posted By 600Bob

I start with my elevator trim centered and the...

I start with my elevator trim centered and the elevator surface centered. I then fly and find I need 5 clicks of up elev. trim.

I then give the TX 5 clicks of down trim. I unhook the linkage and...
05-11-2016, 10:44 AM
Replies: 18
Mah
Views: 1,549
Posted By 600Bob

If the smaller pack voltage sags because of high...

If the smaller pack voltage sags because of high current draw then the larger capacity pack would sag less so the servos would effectively be operating at a higher voltage and operating closer to...
Forum: Gas Engines
05-11-2016, 10:36 AM
Replies: 18
Views: 2,143
Posted By 600Bob

A 20cc will pull a 1/4 scale Piper Cub, over 100"...

A 20cc will pull a 1/4 scale Piper Cub, over 100" wingspan, I have a 20cc in a 63" 13+ lb. P-47 which works well but I don't know what type of plane you have, if it's 3D then maybe it might not do...
Forum: Beginners
05-11-2016, 10:19 AM
Replies: 13
Views: 959
Posted By 600Bob

I too would say the Sig Kadet MkII would be a...

I too would say the Sig Kadet MkII would be a good plane. Fill that engine with glow fuel, it should free it up.
Forum: ARF or RTF
04-07-2016, 10:33 AM
Replies: 7
Views: 664
Posted By 600Bob

Uh I didn't know Hangar 9 made a 30cc P-47?...

Uh I didn't know Hangar 9 made a 30cc P-47? Please send me link I would like to take a look at it. What is the wingspan?

Okay I looked it up, so no those retracts won't work.

I'm surprised...
Forum: ARF or RTF
04-07-2016, 09:34 AM
Replies: 7
Views: 664
Posted By 600Bob

I use the E-flight gear and scale struts. I...

I use the E-flight gear and scale struts. I think you can find them on eBay too.

http://www.e-fliterc.com/Products/Support.aspx?ProdID=EFLG410
...
Forum: ARF or RTF
04-07-2016, 08:21 AM
Replies: 7
Views: 664
Posted By 600Bob

I have that plane but use electric retracts so no...

I have that plane but use electric retracts so no help there. The only thing hurt by the engine sticking out an extra inch is the looks, will it bug you, it would bug me.
02-08-2016, 11:54 AM
Replies: 8
Views: 1,446
Posted By 600Bob

How big is it? I have an 88" Tiger Moth, balance...

How big is it? I have an 88" Tiger Moth, balance it right side up on my finger tips, no balance rig required.
Forum: Beginners
10-23-2015, 10:53 AM
Replies: 17
Views: 822
Posted By 600Bob

Manuals have been wrong. Not all props are...

Manuals have been wrong. Not all props are labeled the same. I look at the props airfoil not the numbers.
Forum: Beginners
10-23-2015, 10:51 AM
Replies: 17
Views: 822
Posted By 600Bob

It looks like the prop is on backwards to me...

It looks like the prop is on backwards to me also, at least none of mine are on that way and they all fly OK.
09-09-2015, 10:27 AM
Replies: 26
Views: 4,054
Posted By 600Bob

You can buy LiFe batteries to replace Pb in...

You can buy LiFe batteries to replace Pb in motorcycles but not LiPo. So LiFe or A123 is closer to what you are looking for.
Forum: Gas Engines
07-20-2015, 02:18 PM
Replies: 421
Views: 54,219
Posted By 600Bob

"I've been to the field you mentioned. I...

"I've been to the field you mentioned. I recognize it from the photo. I went there last year (2014), to the November or December meeting, intending to join. I even brought some modular furniture to...
05-12-2015, 08:39 AM
Replies: 5
Views: 417
Posted By 600Bob

I don't have one. I believe when it was first...

I don't have one. I believe when it was first introduced they used muffler pressure like a glow engine. The new pumped carb wouldn't need it and there is no mention in the manual of using muffler...
04-28-2015, 09:02 AM
Replies: 4
Views: 420
Posted By 600Bob

I think 18% oil is the common recommend amount...

I think 18% oil is the common recommend amount for 4 stroke engines but it will probably be fine.
Forum: ARF or RTF
01-06-2015, 11:48 AM
Replies: 173
Views: 28,664
Posted By 600Bob

It has been some time since I did mine. I did...

It has been some time since I did mine. I did not assemble the wings to glue them in. Is there any difference between the pieces? I can't tell by looking at them after being installed. Maybe some...
Forum: Beginners
11-05-2014, 05:31 PM
Replies: 9
Views: 510
Posted By 600Bob

You are welcome :)

You are welcome :)
Forum: Beginners
11-05-2014, 12:08 PM
Replies: 9
Views: 510
Posted By 600Bob

Limited stock here: ...

Limited stock here:
http://www.valuehobby.com/xt60-male-to-ec3-female-adapter.html

15 here:
http://www.ebay.com/itm/1-XT60-Male-To-Female-EC3-Connector-Adapter-/330462587127

10 here but from...
Forum: Beginners
11-05-2014, 10:43 AM
Replies: 9
Views: 510
Posted By 600Bob

If you can solder just cut off and replace the...

If you can solder just cut off and replace the XT60 with EC3, or make an adapter lead, or there are a number of pre made adapters chances are you could buy one too.
Forum: Beginners
10-02-2014, 11:11 AM
Replies: 17
Views: 698
Posted By 600Bob

Huh? FAA regulates full scale aircraft and...

Huh? FAA regulates full scale aircraft and licensed pilots, not RC models flown line of sight unless you are near an airport. RC transmitters are a Part 15 device, no license required and can be...
08-08-2014, 08:18 AM
Replies: 23
Views: 1,872
Posted By 600Bob

I don't think you meant to say that the bind plug...

I don't think you meant to say that the bind plug shorts the + and - leads, that would short out your receiver battery or BEC. The bind plug shorts the Signal and neg. leads of the receiver.
08-07-2014, 12:38 PM
Replies: 23
Views: 1,872
Posted By 600Bob

Okay, then it doesn't lose "Bind", if it did you...

Okay, then it doesn't lose "Bind", if it did you would have to go through the bind process again. The flashing light generally indicates a loss of signal. It could be from the antennas being...
Showing results 1 to 25 of 137
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.