RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: CARS II
Showing results 1 to 25 of 500
Search took 0.78 seconds.
02-20-2020, 08:26 AM
Replies: 98
Views: 14,119
Posted By CARS II

Have you flown the K160? Is the K30 back from...

Have you flown the K160? Is the K30 back from service?
Forum: RC Jets
02-15-2020, 01:47 AM
Replies: 34
Views: 891
Posted By CARS II

When I tested my K140F and K80G1, I turned off...

When I tested my K140F and K80G1, I turned off the radio to get it to fail safe, the engine stopped and it started the cooling down sequence right away, I turned the radio back on, I don't recall it...
Forum: RC Jets
02-14-2020, 06:46 PM
Replies: 27
Views: 1,321
Posted By CARS II

The spring loaded switch om my 10CAP I use it for...

The spring loaded switch om my 10CAP I use it for smoke, easy to get from the throttle and I just release it to stop the smoke.

When I started flying jets we were running out of chls all the time,...
Forum: RC Jets
02-13-2020, 08:08 PM
Replies: 27
Views: 1,321
Posted By CARS II

OMG! That is hilarious, can't wait when I get to...

OMG! That is hilarious, can't wait when I get to do something like that :)
Forum: RC Jets
02-13-2020, 04:53 PM
Replies: 65
Views: 6,343
Posted By CARS II

Thank you for posting that pic Jeremy, it's...

Thank you for posting that pic Jeremy, it's giving me some ideas.
Forum: RC Jets
02-13-2020, 04:50 PM
Replies: 65
Views: 6,343
Posted By CARS II

Quique, I prefer the way you installed the engine...

Quique, I prefer the way you installed the engine on your Roo, I'm ok with having the engine exposed, I just want to remove the bad tendencies out my Roo, I think it's a cool airplane and really like...
Forum: RC Jets
02-13-2020, 04:30 PM
Replies: 27
Views: 1,321
Posted By CARS II

Just came back from flying the Boomer, the first...

Just came back from flying the Boomer, the first landing was done using the elevator/ brakes mix, the jet landed slow, and on the center line, the brakes were applied using full elevator, it took a...
Forum: RC Jets
02-13-2020, 09:28 AM
Replies: 27
Views: 1,321
Posted By CARS II

I'm trying the elevator braking today, if I don't...

I'm trying the elevator braking today, if I don't like it then, it will go back to the slider only.

We will see.
Forum: RC Jets
02-13-2020, 09:11 AM
Replies: 16
Views: 649
Posted By CARS II

I'm running a 140 and I got an air trap like the...

I'm running a 140 and I got an air trap like the one on your picture, not a single problem in about 3 hrs of use, we learned some time ago that if you go above 140 then a bigger/diferent air trap...
Forum: RC Jets
02-12-2020, 09:34 PM
Replies: 65
Views: 6,343
Posted By CARS II

So, we want the engine to be just above the...

So, we want the engine to be just above the trealing edge or is it better to have it, ala King Cat, half of it hanging below the trealing edge?
02-12-2020, 09:12 PM
Replies: 2
Views: 164
Posted By CARS II

This is what I know, when you tell the ECU which...

This is what I know, when you tell the ECU which batt you are using is just to set up the low batt default alarm.
I recently set up a P120SE that had an LIFE upgrade, we are using a 2 cell 5K mah...
Forum: RC Jets
02-12-2020, 04:26 PM
Replies: 27
Views: 1,321
Posted By CARS II

I just completed the braking via the Elevators...

I just completed the braking via the Elevators set up on my Boomer and it end up kind of proportional, the brakes comes on on the last 20% of the down Elevator which is what I wanted, I wanted them...
Forum: RC Jets
02-12-2020, 04:03 PM
Replies: 27
Views: 1,321
Posted By CARS II

Thank you for sharing your experiences on the...

Thank you for sharing your experiences on the subject, very much appreciated.
Forum: RC Jets
02-12-2020, 02:06 PM
Replies: 27
Views: 1,321
Posted By CARS II

Braking with Elevators Set up

Last year at BITW ( can't wait to go back ) I was told by my good friend Alaska Bob to set up my jet's brakes using Elevator control, doing so I don't have to move my right hand to reach for the...
Forum: RC Jets
02-12-2020, 10:32 AM
Replies: 65
Views: 6,343
Posted By CARS II

Got it! I will be doing that mod and a new paint...

Got it! I will be doing that mod and a new paint job on the Roo this Summer.

Last time I flew the Roo I did a couple of go arounds and man! they felt bad, it was struggling to gain altitude doing...
02-11-2020, 07:33 PM
Replies: 17
Views: 305
Posted By CARS II

When I was setting up my K80 I tried to get it to...

When I was setting up my K80 I tried to get it to go into fail safe without runing it and couldn't make it happen, I end up runing the engine at home and it work as expected.
02-11-2020, 07:17 PM
Replies: 98
Views: 14,119
Posted By CARS II

Agreed! The batt most likely was not giving the...

Agreed! The batt most likely was not giving the start sequence the voltage that it needed to continue with the sequence.

Good job! with your troubleshooting, now you are a bit more knowledgeable...
Forum: RC Jets
02-11-2020, 05:29 PM
Replies: 65
Views: 6,343
Posted By CARS II

Enrique, I have plans to modifie my Roo's engine...

Enrique, I have plans to modifie my Roo's engine mount like it is on your Roo.

I like to know what should I be looking for when I cut the original mount and how to build the new one? also remind...
Forum: RC Jets
02-11-2020, 05:05 PM
Replies: 65
Views: 6,343
Posted By CARS II

Awesome ! As usual.

Awesome ! As usual.
02-11-2020, 02:06 PM
Replies: 17
Views: 305
Posted By CARS II

I will check the manual tonight.

I will check the manual tonight.
02-11-2020, 01:32 PM
Replies: 17
Views: 305
Posted By CARS II

Ok, I see what you are looking for, I have a...

Ok, I see what you are looking for, I have a K80G1, it has the Xicoy ECU, I believe the KT G2 ECU fallows that programming.

The fail safe on the Xicoy ECUs is set from factory to the 2 secs to...
02-11-2020, 12:17 PM
Replies: 17
Views: 305
Posted By CARS II

This is how I set up my fail safe on my 10CAP...

This is how I set up my fail safe on my 10CAP Futaba for my JC, KT and TJT turbines.

Set the top and bottom throttle travels to +/-100% then move the throttle and trim all the way down on the...
02-11-2020, 01:03 AM
Replies: 98
Views: 14,119
Posted By CARS II

https://youtu.be/LG6aXjPv53g

https://youtu.be/LG6aXjPv53g
02-11-2020, 12:35 AM
Replies: 98
Views: 14,119
Posted By CARS II

This spray cleaner was recomended by a long time...

This spray cleaner was recomended by a long time jet flyer friend to clean the filters at least once every season or when the idle PW is up from the normal numbers which may indicate that the filter...
02-10-2020, 11:47 PM
Replies: 98
Views: 14,119
Posted By CARS II

I can't think of another way to check the valves,...

I can't think of another way to check the valves, if I'm in the need to test the valves on one of my Kingtech engines, I use the test function, if they pass and they have in the pass and one of them...
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.