RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: indycustombikes
Showing results 1 to 6 of 6
Search took 0.02 seconds.
Forum: Gas Engines
11-08-2013, 04:11 AM
Replies: 221
Views: 51,890
Posted By indycustombikes

I would say that is too much rpms because when...

I would say that is too much rpms because when unloaded in the air you are right at redline........ could cause premature wear issues... try a 19x8 prop and I bet you would be very pleased with the...
Forum: Gas Engines
11-07-2013, 02:17 PM
Replies: 221
Views: 51,890
Posted By indycustombikes

as best I can tell, after break in we should be...

as best I can tell, after break in we should be looking for a static of around 7000 to 7500 rpm so unloaded in the air it will be in the sweet spot of 8000 to 8200.. I am going to try the 18x10 3...
Forum: Gas Engines
10-27-2013, 02:54 PM
Replies: 221
Views: 51,890
Posted By indycustombikes

Maiden went very well, with the needles both set...

Maiden went very well, with the needles both set at 1 1/2 turns out, she idles at 1850 and pulls 7600 static on 17x8-3, the p-39 came in at 20lbs. the 40 pulled it very well and just a tad better...
Forum: Gas Engines
10-26-2013, 04:00 AM
Replies: 221
Views: 51,890
Posted By indycustombikes

Hope to get a maiden in this sunday if the...

Hope to get a maiden in this sunday if the weather is tolerable..... anyone know where the needle settings ended up with their o.s. 40? I am afraid I have it set lean at 1 1/2 turns on each, runs...
Forum: Gas Engines
10-22-2013, 03:59 PM
Replies: 221
Views: 51,890
Posted By indycustombikes

use a turboheader muffler on the 40 and youll get...

use a turboheader muffler on the 40 and youll get it in the cowl plus its worth 300 more rpms over stock... sounds great too!
Forum: Gas Engines
10-22-2013, 03:31 AM
Replies: 221
Views: 51,890
Posted By indycustombikes

So far I am at 7600 with a 17x8-3 blade xoar prop...

So far I am at 7600 with a 17x8-3 blade xoar prop with this engine but I am still thinking it is rich. I am at 1-1/2 turns out on both low and high needles.... engine has great transition but the...
Showing results 1 to 6 of 6


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.