RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: gpschult
Showing results 1 to 5 of 5
Search took 0.01 seconds.
Forum: Glow Engines
09-29-2021, 09:39 AM
Replies: 14
Views: 1,579
Posted By gpschult

Thanks! It would be nice to have a nut like that,...

Thanks! It would be nice to have a nut like that, might make things easier!
Forum: Glow Engines
09-29-2021, 05:41 AM
Replies: 14
Views: 1,579
Posted By gpschult

Could be. Mine is rounded, so I was curious about...

Could be. Mine is rounded, so I was curious about that as well.
Forum: Glow Engines
09-28-2021, 07:59 AM
Replies: 14
Views: 1,579
Posted By gpschult

Thanks! Another dumb question... do you clamp it...

Thanks! Another dumb question... do you clamp it around the nut? Does it slip at all on the nut, given the nut's rounded shape?
Forum: Glow Engines
09-28-2021, 07:57 AM
Replies: 14
Views: 1,579
Posted By gpschult

Thanks for your help! Sounds like I'm just not...

Thanks for your help! Sounds like I'm just not tightening enough, and the drill bit is too short. I'll try it with a longer allen wrench, will let you know if I have other problems.
Forum: Glow Engines
09-27-2021, 04:58 PM
Replies: 14
Views: 1,579
Posted By gpschult

Du-Bro Prop Nut Spinner - Dumb Question

What's the correct way to install an aluminum prop nut spinner onto a glow engine's drive shaft? I screwed one on to an O.S. 46LA and tightened it down by putting a drill bit through the hole in the...
Showing results 1 to 5 of 5


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.