RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: ibow24
Showing results 1 to 7 of 7
Search took 0.11 seconds.
01-03-2008, 05:20 PM
Replies: 503
Views: 101,839
Posted By ibow24

RE: 2 for one - Carden 40% Extra 300 Build

Kelly,
I haven't checked out your build thread for awhile. Finally got a chacne today to page through it. Excellent work, they look great.
The impressive thing to me is you're building 2 at...
10-29-2007, 01:32 PM
Replies: 503
Views: 101,839
Posted By ibow24

RE: 2 for one - Carden 40% Extra 300 Build

You can check out www.edge540.com
it is a build for a Carden 540. Bob has a few drawings that show exactly how he set up the servos with measurements etc.
Even if you opt to do something...
10-18-2007, 05:46 AM
Replies: 503
Views: 101,839
Posted By ibow24

RE: 2 for one - Carden 40% Extra 300 Build

With a 1.25 servo arm I set my hard point up at 1" offset from the centerline of the servo.
This seems to gives a good balance from neutral to endpoints.

Steve
10-08-2007, 08:48 AM
Replies: 503
Views: 101,839
Posted By ibow24

RE: 2 for one - Carden 40% Extra 300 Build

Nice shop...I would be building a full scale if I had that shop :D

Steve
10-06-2007, 10:54 AM
Replies: 503
Views: 101,839
Posted By ibow24

RE: 2 for one - Carden 40% Extra 300 Build

understood...the "down" thing had me going for awhile too on my first build.... I thought... HEY!!!...I got TWO left stabs what the ???

Steve
10-06-2007, 06:15 AM
Replies: 503
Views: 101,839
Posted By ibow24

RE: 2 for one - Carden 40% Extra 300 Build

The DOWN marking on the shuck is very important.
The DOWN side on the foam shucks is the side the goes DOWN when the foam parts are curing under weight.
When the foam cores are cut they true one...
10-02-2007, 09:29 AM
Replies: 503
Views: 101,839
Posted By ibow24

RE: 2 for one - Carden 40% Extra 300 Build

Nice work. This will be a nice build thread to follow.
I built 2 Cuda's at one time. It wasn't as easy as I thought it would be. I thought it would be easy to go through each step of the build...
Showing results 1 to 7 of 7


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.