Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: full rudder
Showing results 1 to 25 of 53
Search took 0.53 seconds.
09-28-2012, 05:27 PM
Replies: 10
Views: 4,180
Posted By full rudder

RE: 5 mm strut pin alternative

Ask any of the electric 450 size heli guys for bent main rotor shafts, they are 5mm and cut em down to the size you need with a dremel cutoff wheel!
01-28-2012, 09:05 AM
Replies: 20
Views: 6,038
Posted By full rudder

RE: Bud Nosen 1/4 Aeronca champ setup?

Hi, I got one and it's a floater! Mine is 18lbs and flies very well with an RCGF 26cc and an 18x6 prop.
Ailerons are around 1" up and 3/8" down (differential) and mixed with the rudder at 25%,...
Forum: Kit Building
06-03-2010, 06:37 AM
Replies: 172
Views: 15,785
Posted By full rudder

RE: What airplane would you like to see kitted at .40 or .60 size?

Hi,
if they could bring back the Top flite FW-190 D9 I'd be a happy guy! And of course all the old
Royal kits.
Forum: Gas Engines
05-24-2010, 06:23 AM
Replies: 151
Views: 30,706
Posted By full rudder

RE: RCG 26cc

Hi,

Stick2000, my needles were at 1 3/4 for the low and 2 1/4 for the high, it was mushing at high speed so my high still needs some leaning.
I measured my sensor at 29 degrees before TDC.
Forum: Gas Engines
05-21-2010, 06:18 AM
Replies: 151
Views: 30,706
Posted By full rudder

RE: RCG 26cc

Well mine had it's maiden flight, the high end was a bit too rich but it never burped or died, using an 18 x 6 MA classic,
unfortunately in the excitement I didn't take any rpm reading but I will...
03-31-2010, 09:46 AM
Replies: 184
Views: 28,382
Posted By full rudder

RE: SHOW YOUR DETAILED ARF WARBIRDS

My CMPro 72" P47 !

Wing panel lines, new paint job, new canopy, wing guns, full cockpit, YS120.
03-25-2010, 05:52 AM
Replies: 116
Views: 24,676
Posted By full rudder

RE: cmp p47 thunderbolt

Thanks Neo, by the way can I have the adress of your model shop ... maybe I'll sit quietly close to the
back window... mind you the airfare to get there will be more than the FG20! Keep with it,...
03-24-2010, 12:08 PM
Replies: 116
Views: 24,676
Posted By full rudder

RE: cmp p47 thunderbolt

Hello Neogold,

I have one of these, loved it so much that I did a complete makeover because I didn't care much
for the camo scheme it had. I changed the canopy to one for the top flite .60 and...
Forum: Gas Engines
03-22-2010, 10:02 AM
Replies: 151
Views: 30,706
Posted By full rudder

RE: RCG 26cc

Hello propshaft, my experience has been very similar to yours except the needles were not that far
off, maybe a 1/4 to 1/2 a turn each. I also started a thread somewhere else:

...
02-22-2010, 08:02 AM
Replies: 7
Views: 866
Posted By full rudder

RE: wish list kit ?

1- All the old Royal kits.

2- Top Flite FW190 D9

3- I really wish Top flite would make a giant scale ME109 or FW190 KIT in the same series as the
P-51 or P-47 GS.

Wishful...
12-02-2009, 04:16 PM
Replies: 31
Views: 2,665
Posted By full rudder

RE: Great WWI read

Hi, as somebody who is french (Canadian) here is my 2 cents:

Virage - Quite simply means a turn be it turning while climbing, diving or staying at the same altitude.

Vrille - A spin, or...
Forum: Kit Building
07-18-2009, 08:00 AM
Replies: 420
Views: 49,841
Posted By full rudder

RE: Learjet .40 Build

Hello guys!

Haven't posted since a long long time, but mine has maidened (june 21st) and it flys good!
I had to add 5 ounces of lead to the tail to balance and came out around 7 lbs 3...
05-08-2009, 04:20 PM
Replies: 27
Views: 2,303
Posted By full rudder

RE: What to do with these planes....

Hi, the P-39 is a Top flite red box kit from the early 80s except for the glass cowling, dont know where
that came from, but the canopy-top deck-air scoop is the same.

Here's a few pictures...
Forum: Kit Building
12-17-2008, 08:07 AM
Replies: 420
Views: 49,841
Posted By full rudder

RE: Learjet .40 Build

Hello guys, sorry I haven't contributed in a long time, what time I have I spend building and usually have none left to take pics or post here [:o] . So far it's going well, the wings are complete...
Forum: Kit Building
11-26-2008, 08:16 PM
Replies: 420
Views: 49,841
Posted By full rudder

RE: Learjet .40 Build

Hi guys, I started buiding this kit about 8 years ago and just started again on it this week! Had to stop for moving and work and bla bla bla ... Anyway I already had the wings completed (not...
06-06-2008, 07:02 AM
Replies: 11
Views: 987
Posted By full rudder

RE: monocote model cleaning

Hi, I just use windshield washer fluid, the plane is squeaky clean afterwards. Mind you the stuff we have
here is rated -40 degrees so it might contain more alcohol.
05-16-2008, 06:48 AM
Replies: 4
Views: 872
Posted By full rudder

RE: Transmitter batteries

Just replaced my 600mah futaba with a 2500mah NiMh that I picked up on the bay for 12$ and you know
what, it's perfect! I can go fly two days in a row without charging my TX!! I don't think I'll...
05-05-2008, 11:02 AM
Replies: 24
Views: 4,833
Posted By full rudder

RE: Echo GT 1000

Thanks for the replies, now im off to hunt for a bigger one!
05-02-2008, 05:44 PM
Replies: 24
Views: 4,833
Posted By full rudder

RE: Echo GT 1000

Hi, I just picked up one of these engine (16cc GT1000)
, the guy at the small engine shop didn't know how many cc's this one was and I really
wanted something more like 24-26 cc range. It looks...
04-14-2008, 08:34 AM
Replies: 6
Views: 1,749
Posted By full rudder

RE: Help! Looking for Uravitch Fokker DVII construction article

Thanks Aerowoof, I''d like very much to get a copy if it''s not too much trouble, I''ll let you know
if there are any difference btwn the HH kit and the plan version. Tried to PM you my e-mail...
04-11-2008, 04:09 PM
Replies: 6
Views: 1,749
Posted By full rudder

Help! Looking for Uravitch Fokker DVII construction article

Hi all, I just aquired the Rich Uravitch fokker d-7 plan (the .40 size) but the construction article didn't come with it,
just wondering if anybody out there would have it? I do have his...
03-27-2008, 09:28 PM
Replies: 11
Views: 3,882
Posted By full rudder

RE: Cambria Miri 120" ever seen one? pics

Thanks for the reply, geez it's even older than what I was figuring... only flew it thermal up to now, maybe
one day on the slope. The only mod I made is adding spoilers on it, sure helps because...
03-25-2008, 08:37 PM
Replies: 11
Views: 3,882
Posted By full rudder

Cambria Miri 120" ever seen one? pics

Built this one maybe 15 years ago, it's a UK kit made by Cambria, fiberglass fuse with an aluminium
tail boom tube, wings and tail feathers are built up, flies real good and smooth. It's probably a...
Forum: Sport Flying
03-25-2008, 08:26 PM
Replies: 58
Views: 11,590
Posted By full rudder

RE: Your WEIRDEST looking planes! Please post pics!

Here's two of them, flying race car and the other Maggie the flying witch! (broom is elevator, rudder and
the cape acts like a flying delta wing!).
03-22-2008, 07:42 AM
Replies: 16
Views: 1,446
Posted By full rudder

RE: Covering a Spitfire, Help needed

Go see www.tompierce.net for glassing and fininshing information, it's all detailed step by step. An all
around great place to start!
Showing results 1 to 25 of 53
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.