Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: Zafer
Showing results 1 to 25 of 169
Search took 0.64 seconds.
01-30-2010, 02:30 PM
Replies: 11
Views: 1,408
Posted By Zafer

RE: TT Titan Clutch disengages

This morning I went out despite bad weather, and checked the heli. It hovers well. No visible or audible trouble. Autorotation hub holds, RPM and headspeed steady.

I couldn't stay outside more...
01-30-2010, 01:58 PM
Replies: 6
Views: 2,287
Posted By Zafer

RE: A new Tiger ?? X-50

Yes, And you can have it with belt drive or with torque-tube.
01-30-2010, 01:33 AM
Replies: 6
Views: 2,287
Posted By Zafer

A new Tiger ?? X-50

Hi

Thunder Tiger has a new heli for you in 2010

Enjoy.

http://www.heligarage.at/dieheligarage/heligarage-startseite_files/X50%20flyer-2.jpg
...
01-28-2010, 10:18 AM
Replies: 11
Views: 1,408
Posted By Zafer

RE: TT Titan Clutch disengages

I have already checked that. Besides It is an original and brandnew part.

I have high hopes that the cleaning (de-greasing) of the autorotation hub will work. (But We have snow everywhere right...
01-27-2010, 11:38 AM
Replies: 11
Views: 1,408
Posted By Zafer

RE: TT Titan Clutch disengages

As I was not satisfied with my work, today I took the main gear and the auto rotation hub out. I forced the one way hub to the other way and I felt it was slipping.

I disassembled the hub and...
01-25-2010, 04:50 PM
Replies: 11
Views: 1,408
Posted By Zafer

RE: TT Titan Clutch disengages

""I'd advise against ever running a nitro heli without blades. " I will keep that in mind.

Today I took the engine out. Clutch was in good condition but shiney in one point (I think that shows...
01-25-2010, 11:43 AM
Replies: 11
Views: 1,408
Posted By Zafer

RE: TT Titan Clutch disengages

Nothing is broken or missing on or around the main shaft. Blades moving clockwise.
01-24-2010, 10:12 AM
Replies: 11
Views: 1,408
Posted By Zafer

TT Titan Clutch disengages

Hi,

I have built a TT Titan kit and took her out to try. Engine started easy and idled pretty well. I burned one tank without blades. Second tank, I put the blades on and hit the throttle. When...
08-20-2009, 04:02 PM
Replies: 20
Views: 4,437
Posted By Zafer

RE: Yak-55M 30%

Here is Yak-55 50cc ARF.

http://www.flight-model.com/product/eproduct_detail.asp?catalogid=0006p&productid=270

Zafer
Replies: 15
Views: 19,102
Posted By Zafer

RE: Turnigy receiver controlled on off switch

Hi,

Yes, I have soldered a wire between the (-) wires of the batteries and the switch is now functional.

I use gear channel of JR x9303 and gear switch turns the ignition on and off.

...
Replies: 15
Views: 19,102
Posted By Zafer

Turnigy receiver controlled on off switch

Hi,

I have bought a receiver controlled switch to kill the ignition. But I failed to connect it to the system correctly. I am not good at electronics . I am trying to put the switch between...
08-16-2009, 09:32 AM
Replies: 5
Views: 760
Posted By Zafer

RE: Hissing X9303 2.4

Hi again,

Today I have flown with the new radio.

No casualties. So far so good.

Regards.

Zafer
08-14-2009, 02:31 PM
Replies: 5
Views: 760
Posted By Zafer

Hissing X9303 2.4

Hi.

I have decided to move to 2.4 Ghz. and found (and bought) a second hand JR X9303 2.4H.

It seems o.k. It binds to the original JR 921 receiver. But it (transmitter) makes a hissing...
07-18-2009, 02:03 PM
Replies: 1
Views: 1,121
Posted By Zafer

RE: compare the ST 3000 power to the OS 1.60 FX

Hi.

I have a Super Tigre ST3000 and a MVVS 160 (with glow carb. ) I believe MVVS 160 is very close to (or in the same class with ) O.S.160 in performance wise.

Super Tigre can swing an...
Forum: Gas Engines
07-18-2009, 07:28 AM
Replies: 22
Views: 4,868
Posted By Zafer

RE: DL-55 Starting problems

This morning I have had same problem with DLE 55. Firing and stopping.

Thank you for your clue. The small spring inside the cap was a little bit short. I made it longer by pulling out.:D. Now it...
06-18-2009, 01:25 PM
Replies: 4
Views: 951
Posted By Zafer

RE: ST 3000 question

17x8 prop is a little small for ST 3000. Mine turns a 20x8 prop 7000 rpm with tune pipe with %10 oil no nitro. ( at 1.000 mt ASL)

Regards.

Zafer
Replies: 2
Views: 654
Posted By Zafer

RE: One EDF motor quits after half throttle.Why.

Thanks,

I will change the battery first. I have ordered a 20C pack 2200 mah batt. Then we will see if it is the fault of the batt...

Well if this doesnt work out, I will look into ESCs.
...
06-10-2007, 12:35 PM
Replies: 1
Views: 752
Posted By Zafer

F20 Tigershark .40 Conversion

Hi all,

I would like to convert a F20 Tigershark Phoenix .40 ARF. I have already had glow version. It weights less then 6 Lbs. ( 2.600 grams)

I want to fly plus 100 MPH. Please advise...
Replies: 2
Views: 654
Posted By Zafer

One EDF motor quits after half throttle.Why.

Hi I am new to electric planes. I have just bought a twin EFD Sukoi 27. ( made by art tech- China) It has two 400 class brushless motors two ESCs and one lipo 3 cell 2200 mah batt.

When I would...
06-08-2007, 01:45 PM
Replies: 77
Views: 29,336
Posted By Zafer

RE: Art Tech SU-27

This is the best I can do. The motors are 400 Class. No other info I was able to find.

Zafer
06-08-2007, 12:40 PM
Replies: 77
Views: 29,336
Posted By Zafer

RE: Art Tech SU-27

Hi there,

I have no idea about the specs. All I know, they are brushless. the lipo came with the plane is a 3 cell 2200MAH. LHS has also brushed version (blue-white) The kit has basically same...
06-05-2007, 02:37 PM
Replies: 77
Views: 29,336
Posted By Zafer

RE: Art Tech SU-27

Sorry for quality of the pictures.
06-05-2007, 02:24 PM
Replies: 77
Views: 29,336
Posted By Zafer

RE: Art Tech SU-27

Here she is...
06-05-2007, 01:00 PM
Replies: 77
Views: 29,336
Posted By Zafer

RE: Art Tech SU-27

Hi,

Just bought the brushless version of the SU 27 in her Russian dressing.

I would like to check the CG.

There is nothing in the booklet.

Thanks and regards.
Forum: Glow Engines
04-08-2007, 11:42 AM
Replies: 7
Views: 852
Posted By Zafer

RE: MVVS 1.6 muffler pressure nipple ???

So, I have had chance to try MVVS today,

With 10% nitro and menz 18x6 wooden prop, first tank my tacho showed 8,3K which was indeed very rich. It is not O.S. but I think it is close. The...
Showing results 1 to 25 of 169
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.