RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: darticus
Showing results 1 to 25 of 500
Search took 0.52 seconds.
Replies: 9
Views: 813
Posted By darticus

I ordered the Futaba Attack and it should do the...

I ordered the Futaba Attack and it should do the job. Thanks Ron
Forum: RC Sailboats
07-19-2017, 07:46 AM
Replies: 4
Views: 898
Posted By darticus

Thanks very much! Will go and check it out. Ron

Thanks very much! Will go and check it out. Ron
Replies: 9
Views: 813
Posted By darticus

Found out today that the jitters happen, to the...

Found out today that the jitters happen, to the servos, daily between the hours of 9am and and 7pm even on Sundays. What is causing this and is there a fix for this? Other boat are OK. I guess a...
Replies: 9
Views: 813
Posted By darticus

I think 75 mhz am. This is for a sailboat. I...

I think 75 mhz am. This is for a sailboat. I really don't know what fm or pcm are for. Thanks Ron
Forum: RC Sailboats
07-16-2017, 03:39 PM
Replies: 4
Views: 898
Posted By darticus

Could use suggestions for a radio for my sailboat

My radio not really working good. Could use a radio with two channels 2 servos and a receiver. Looking for a cheaper one for this one boat about 24 inches. Crystal is fine! Are digital a better deal?...
Replies: 9
Views: 813
Posted By darticus

Its doing it again. Just tried it today. I did...

Its doing it again. Just tried it today. I did cut the travel with the adjusters and its helping. I think I need a new cheap radio 2 channel for my sailboat with servos. Can be crystal or is it...
Replies: 9
Views: 813
Posted By darticus

These are new servos. Today its not doing it. I...

These are new servos. Today its not doing it. I did move both crystals to make sure they were seated correctly but now its stopped. Don't think what I did fixed it. Maybe a CB or Ham Radio in the...
Replies: 9
Views: 813
Posted By darticus

Servo jitters when almost full travel help

The servo starts jittering when the lever is almost all the way up and when its all the way up? It also is causing the other servo to jitter when this one is up.. Is there a method to test why? This...
Forum: RC Sailboats
07-10-2017, 04:53 AM
Replies: 7
Views: 820
Posted By darticus

I am using low voltage led lights. Can I use any...

I am using low voltage led lights. Can I use any of the unused receiver plugs marked + - to get the 6 v for the leds? I'm using a 6 channel receiver so a lot of extra plugs I might be able to get the...
Forum: RC Sailboats
07-10-2017, 04:28 AM
Replies: 7
Views: 820
Posted By darticus

OK Thanks Ron

OK Thanks Ron
Forum: RC Sailboats
07-10-2017, 03:50 AM
Replies: 7
Views: 820
Posted By darticus

Wanted to add a few lights to the sail boat. I...

Wanted to add a few lights to the sail boat. I did wire up 3- 3mm led lights and wondered what type of switch to use. I guess the small servo would move and arm and hit the switch. Know anything...
Replies: 0
Views: 303
Posted By darticus

Turnigy receiver controlled on/off switch use

Does anyone know how these work? Do they have 4 modes? Can you switch to each of the 4 modes somehow? Would this work good to turn lights on in a sailboat. Thanks Ron
07-09-2017, 09:45 AM
Replies: 38
Views: 24,343
Posted By darticus

Where do you get the power for this? Do you just...

Where do you get the power for this? Do you just plug it onto the receiver somewhere? Please explain. Thanks Ron
Forum: RC Sailboats
07-09-2017, 08:08 AM
Replies: 7
Views: 820
Posted By darticus

Extra channel add on help suggestions

I don't too much about adding extra stuff to a sailboat or anything thing else RC but maybe you can suggest some things. My radio stuff in my little sailboat stopped working and I had a 6 channel...
10-13-2016, 09:06 AM
Replies: 0
Views: 399
Posted By darticus

How about paddle boats or show boats

Anything reasonably priced and short build time which uses RC and electric motor. Can't seem to find anything good to build this winter. Delta Queen nice but can't find something like it. Thanks Ron
07-27-2015, 01:21 PM
Replies: 0
Views: 556
Posted By darticus

3d foamy throw gauge building

Built some simple foamy Throw gauges but find most to be too heavy for a light foamy. Finally built a gauge to even work with the AS3XTRA. Less than 1 gram so it doesn't pull the aileron or elevator...
07-13-2015, 04:46 PM
Replies: 0
Views: 411
Posted By darticus

1s 3.7v 150mah 45c multi charger needed suggestions needed

I think a 1S is a 1S but some people say there are other 1S batteries. I need a charger to charge the little slide in batteries like for the AS3XTRA EFLITE plane. Anyone know the best charger for...
Forum: RC Sailboats
07-13-2015, 04:28 PM
Replies: 4
Views: 2,040
Posted By darticus

Very nice info. Still working on it. Ron

Very nice info. Still working on it. Ron
06-24-2015, 07:15 AM
Replies: 26
Views: 15,130
Posted By darticus

Is there an easy way to get this to also run slow...

Is there an easy way to get this to also run slow in reverse? Thanks Ron
Forum: RC Sailboats
06-22-2015, 03:24 PM
Replies: 4
Views: 2,040
Posted By darticus

Need sailboat rescue boat! Suggestions wanted!

Don't know what people use for a rescue boats to get your sailboat out of trouble. Any suggestions would be great. Thanks Ron
06-19-2015, 04:13 AM
Replies: 33
Views: 38,240
Posted By darticus

This camera was 5 dollars. Is the Phantom 3 pro a...

This camera was 5 dollars. Is the Phantom 3 pro a better deal? Thanks Ron
Replies: 2
Views: 470
Posted By darticus

Dx6 dx9 radio voice help!

I had my radio DX6 setup where it would come on and say the remaining time (total time) switch C, and high or low rate switch H for the model it was on. I can't get this to work any more. Do any of...
05-08-2015, 11:21 AM
Replies: 33
Views: 38,240
Posted By darticus

Thanks I will try again over the weekend. Thanks...

Thanks I will try again over the weekend. Thanks Ron
05-07-2015, 12:45 PM
Replies: 33
Views: 38,240
Posted By darticus

You guys are very helpful. I tried to upload a...

You guys are very helpful. I tried to upload a 377mb 4 minute rc plane video to utube. It said it would take 107 minutes to upload so I stopped. Anyone know what I could try to cut up and edit my...
05-07-2015, 03:58 AM
Replies: 33
Views: 38,240
Posted By darticus

Thanks I don't have window 7 so I don't know what...

Thanks I don't have window 7 so I don't know what I can use. Ron
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.