RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: RLJohns
Showing results 1 to 11 of 11
Search took 0.01 seconds.
Forum: RC Tanks
02-19-2021, 05:21 PM
Replies: 13
Views: 1,205
Posted By RLJohns

That is the way I have things hooked up as you...

That is the way I have things hooked up as you described however, as I mentioned in an earlier post on this thread, instead of turning left with left stick input my Tiger 1 goes right and vise-versa.
Forum: RC Tanks
02-19-2021, 01:43 PM
Replies: 13
Views: 1,205
Posted By RLJohns

The HL U2 gearbox/motors had the plug type...

The HL U2 gearbox/motors had the plug type connectors while the HL 6.0 MFU had bullet connectors. For now I cut the plug type connectors off and soldered on the bullet cons. Would switching the...
Forum: RC Tanks
02-16-2021, 04:46 PM
Replies: 13
Views: 1,205
Posted By RLJohns

I am having a somewhat similar issue. Installed...

I am having a somewhat similar issue. Installed the HL U2 gearbox in my HL Tiger 1, the tank goes fwd./rev. just fine however L/R are backwards. Not sure whether the left motor (US Drivers Side) is...
Forum: RC Tanks
02-06-2021, 10:51 AM
Replies: 6
Views: 946
Posted By RLJohns

Awesome, thank you very much. I had to put the...

Awesome, thank you very much. I had to put the screws in at an angle to get the gearbox into the stock HL chassis. I am usually "mechanically inclined" having worked on/built RC cars and "real"...
Forum: RC Tanks
02-05-2021, 02:59 PM
Replies: 6
Views: 946
Posted By RLJohns

Any recommended vendors in the US? I could not...

Any recommended vendors in the US? I could not find it available on Amazon, did find one on e-bay.
Forum: RC Tanks
02-04-2021, 03:20 PM
Replies: 6
Views: 946
Posted By RLJohns

Will the Mato Metal Lower Chassis work better...

Will the Mato Metal Lower Chassis work better than the stock HL one?
Forum: RC Tanks
02-03-2021, 07:48 PM
Replies: 6
Views: 946
Posted By RLJohns

HL Tiger 1 (3818) and HL Ultimate II Gearbox

I recently got a HL Tiger 1 3818 (standard version) and a HL Ultimate II gearbox. I didn't get the tank with the metal gearbox because it was inexpensive and I wanted to learn how to work on things...
Forum: RC Tanks
02-02-2021, 05:12 PM
Replies: 5
Views: 759
Posted By RLJohns

Will that chip or remove paint if the accessory...

Will that chip or remove paint if the accessory falls of and you have to remove the glue to re apply?
Forum: RC Tanks
02-02-2021, 03:58 PM
Replies: 5
Views: 759
Posted By RLJohns

M4 Sherman "accessories"

How are you all mounting the "accessories" to your models? I recently got the Heng Long M4 Sherman and the instructions call for the accessories/dettails (extra wheels, track pieces and crates" to be...
Forum: RC Tanks
01-26-2021, 03:24 PM
Replies: 2
Views: 425
Posted By RLJohns

Thank you for replying. So basically about $180...

Thank you for replying. So basically about $180 (USD) per tank for the Clark TK80 plus tx/rx.
Forum: RC Tanks
01-25-2021, 01:04 PM
Replies: 2
Views: 425
Posted By RLJohns

TX/RX Swap

Hello. I recently got a Heng Long M41 walker bulldog as well as a Heng Long Tiger 1. Am I able to (with little hassle) to upgrade the tx/rx on these tanks to something like a Flysky I6s 10 ch? ...
Showing results 1 to 11 of 11


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.