RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: Hesco Racing
Showing results 1 to 25 of 500
Search took 0.59 seconds.
06-04-2014, 08:56 AM
Replies: 10
Views: 478
Posted By Hesco Racing

Stay away from Spektrum radio and water. Most of...

Stay away from Spektrum radio and water. Most of them are not water friendly. Save and buy a Futaba.
05-28-2014, 12:51 AM
Replies: 126
Views: 9,279
Posted By Hesco Racing

I don't disagree with Nick but heck in 8 years of...

I don't disagree with Nick but heck in 8 years of racing I have never had a ball joint pop off. When it is so worn that it will pop off your should have replaced it long ago. Also like the black ball...
05-21-2014, 09:02 PM
Replies: 126
Views: 9,279
Posted By Hesco Racing

IS the course short so you guys can not get up to...

IS the course short so you guys can not get up to speed? Looked like no one was ever over 35-40mph. That must be painful to run that slow. Boat will only come alive at the 50mph mark.

Cobus
04-14-2014, 10:48 PM
Replies: 2
Views: 679
Posted By Hesco Racing

Having more fun chatting on facebook Jims than on...

Having more fun chatting on facebook Jims than on Jims itself
04-10-2014, 08:17 AM
Replies: 126
Views: 9,279
Posted By Hesco Racing

Nice one on the steering rod much neater and...

Nice one on the steering rod much neater and straight. Just noticed you have the rudder bottom still parallel with the hull bottom. We file the rudder as to not have it generate lift just steering....
04-07-2014, 02:00 PM
Replies: 126
Views: 9,279
Posted By Hesco Racing

Do you have exponential curve on your transmitter...

Do you have exponential curve on your transmitter that you use? If not I would rethink you throttle servo horn setup. The way you have it you are going to have a very dead stick at WOT. If I had to...
04-07-2014, 11:30 AM
Replies: 126
Views: 9,279
Posted By Hesco Racing

Is that red silicone tubing or tygon tubing? ...

Is that red silicone tubing or tygon tubing?

Cobus
04-07-2014, 09:34 AM
Replies: 126
Views: 9,279
Posted By Hesco Racing

OK looks good, well done. been long time to get...

OK looks good, well done. been long time to get to this point.

1 tip where the stringer go into the transom plate. Notch the corner off at angle to allow any water maybe coming into the boat...
04-06-2014, 07:34 AM
Replies: 3
Views: 410
Posted By Hesco Racing

Rear of sponsons. Aim for 28-30% then go jump the...

Rear of sponsons. Aim for 28-30% then go jump the boat over wakes and check what the boat does. If if it jumps nose up adjust the cg slightly forward.

Cobus
04-04-2014, 04:34 AM
Replies: 126
Views: 9,279
Posted By Hesco Racing

I know you guys may not have exposed exhaust have...

I know you guys may not have exposed exhaust have you consider moving the motor back and having the radio box in front of it with the tune pipe running forward and exiting through the deck? Had a guy...
03-28-2014, 12:52 AM
Replies: 31
Views: 2,337
Posted By Hesco Racing

Hay it's been 4 days you must go run the boat...

Hay it's been 4 days you must go run the boat your fuel is going to go stail.

Cobus
03-26-2014, 02:03 AM
Replies: 31
Views: 2,337
Posted By Hesco Racing

Any thought on price yet if and when you sell...

Any thought on price yet if and when you sell them?

Cobus
03-26-2014, 12:52 AM
Replies: 31
Views: 2,337
Posted By Hesco Racing

Well I'm lucky i make my own struts so can make...

Well I'm lucky i make my own struts so can make what I need.

Cobus
03-25-2014, 01:11 AM
Replies: 31
Views: 2,337
Posted By Hesco Racing

I see you running a skeggless strut. Might think...

I see you running a skeggless strut. Might think about getting one with a skeg. Will help you a great deal in the turns.

Cobus
03-23-2014, 11:47 PM
Replies: 31
Views: 2,337
Posted By Hesco Racing

Come on I been waiting patiently here. Get it wet...

Come on I been waiting patiently here. Get it wet have a nice Go 28 waiting for it.
02-25-2014, 09:47 AM
Replies: 11
Dx3
Views: 527
Posted By Hesco Racing

Nope has water issues. Most Spectrum sets have...

Nope has water issues. Most Spectrum sets have water issues. Marine receiver has been successful for some but only a few.

http://forums.offshoreelectrics.com/archive/index.php/t-17480.html

Cobus
02-02-2014, 09:07 PM
Replies: 448
Views: 94,391
Posted By Hesco Racing

And those gremlins gave you 4 DNF's so you better...

And those gremlins gave you 4 DNF's so you better get them sorted. And added to your 18 DNF's out of 24 heats run this season so far. Speed has not been your friend this season so far.

Cobus
02-02-2014, 05:57 AM
Replies: 2,360
Views: 388,164
Posted By Hesco Racing

Johan You can go to our website www.cmbc.co.za...

Johan You can go to our website www.cmbc.co.za and on the contact us tab you can get our mail address and mail us.

Cobus
01-24-2014, 09:01 PM
Replies: 4
Views: 566
Posted By Hesco Racing

Yes with a viper outboard leg. Some more...

Yes with a viper outboard leg.

Some more pics here
https://www.facebook.com/media/set/?set=a.268213680001644.1073741933.119033224919691&type=1

Cobus
01-24-2014, 08:48 PM
Replies: 448
Views: 94,391
Posted By Hesco Racing

You have links to it?

You have links to it?
01-24-2014, 11:24 AM
Replies: 448
Views: 94,391
Posted By Hesco Racing

No Johno there is just not so much interest in a...

No Johno there is just not so much interest in a inboard tunnel. Specially from USA who mostly frequent this site. Put a leg on the thing and run it like it was made to be.

Cobus
01-19-2014, 02:00 AM
Replies: 4
Views: 566
Posted By Hesco Racing

Racing photos CMBC Cape Town

Some photos taken the weekend. Will post more as they come in.

Cobus
01-18-2014, 11:39 PM
Replies: 126
Views: 9,279
Posted By Hesco Racing

Will effect neatness of split line if you...

Will effect neatness of split line if you planning on molding color and not painting.
...
01-17-2014, 04:33 AM
Replies: 126
Views: 9,279
Posted By Hesco Racing

Are you now going top spray the board with gel...

Are you now going top spray the board with gel coat to get a good finish?

Cobus
01-09-2014, 08:55 PM
Replies: 6
Views: 2,015
Posted By Hesco Racing

Get some heat shielding above that receiver or it...

Get some heat shielding above that receiver or it will loose binding.

Cobus
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.