RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: wakle
Showing results 1 to 5 of 5
Search took 0.14 seconds.
05-01-2005, 08:36 AM
Replies: 47
Views: 19,135
Posted By wakle

RE: BUILDING your own VPP Setup

I got the EVP yesterday. It is a smart simplified design, but the head is awfully contrived. I'll try it, but already thinking that it needs to be modified.
No luck yet ardering the Ikarus PPS.
04-29-2005, 09:14 AM
Replies: 47
Views: 19,135
Posted By wakle

RE: BUILDING your own VPP Setup

About the AXI's conversion to hollow shaft. The procedure we followed was pretty much as described by Levi for the Hacker.

But, there is one crucial difference. The shaft retaing setscrew is...
04-28-2005, 09:15 PM
Replies: 47
Views: 19,135
Posted By wakle

RE: BUILDING your own VPP Setup

The AXI 2208 series uses standard bearings. One 1/8 ID by 3/8 OD, and one 1/8 ID x 5/16 OD. I got mine from BOCA Bearings, but they are widely available.
04-28-2005, 03:57 PM
Replies: 47
Views: 19,135
Posted By wakle

RE: BUILDING your own VPP Setup

I have not flown Helis. Looking on the web I found only crash kits for the raptor 30 ($60). Do you have a source for just the tail blades?
04-28-2005, 12:58 PM
Replies: 47
Views: 19,135
Posted By wakle

RE: BUILDING your own VPP Setup

Tnanks Levi,
I ordered the tail rotor parts and tubing. Where do we get the blades?
I had used roll pins for the .125 D AXI, but your solution is more elegant and also works on my 3 mm Hackers.
...
Showing results 1 to 5 of 5


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.