Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: avinut
Showing results 1 to 25 of 89
Search took 0.70 seconds.
Forum: Glow Engines
11-29-2015, 05:42 AM
Replies: 49
Views: 3,196
Posted By avinut

Finally ! a reasonable post. (Red750)

Finally ! a reasonable post. (Red750)
Forum: Glow Engines
11-28-2015, 03:44 PM
Replies: 49
Views: 3,196
Posted By avinut

This thread is overworked. Go back to my original...

This thread is overworked. Go back to my original post and DO IT. All the other stuff, though true, is academic. You will throw props lean, rich, inverted, or any other way until you do the over...
Forum: Aerodynamics
11-27-2015, 07:10 AM
Replies: 46
Views: 5,980
Posted By avinut

Just remember that only two things are required...

Just remember that only two things are required for flight.
Forum: Glow Engines
11-27-2015, 07:04 AM
Replies: 49
Views: 3,196
Posted By avinut

Hey fellas, you shouldn't be running nitro in...

Hey fellas, you shouldn't be running nitro in these things !
Forum: Glow Engines
11-26-2015, 10:21 AM
Replies: 49
Views: 3,196
Posted By avinut

Get a BIG wrench and tighten the prop nut as...

Get a BIG wrench and tighten the prop nut as tight as you can get it. I threw props all over the yard till I figured this out.
12-23-2014, 01:13 PM
Replies: 124
Views: 12,269
Posted By avinut

Reading your build log reminds me of the story...

Reading your build log reminds me of the story about the guy going to see Chet Atkins in concert. Went home and threw his guitar in the trash. :-)
Replies: 5
Views: 908
Posted By avinut

Kraft radio connectors

Is anyone on here old enough to remember how to replace pins in Kraft connectors? I have a bad pin/wire on the rf module connector (male) in a TX on the ham band. I just never had to replace a pin...
Forum: Glow Engines
08-04-2014, 04:09 PM
Replies: 7
Views: 1,044
Posted By avinut

THE NEWER ENGINE (on the left) has no head gasket...

THE NEWER ENGINE (on the left) has no head gasket showing. A flat disc with an o.d. to just clear the bolts. You need a replacement piston.
Forum: Control Lines
02-07-2014, 07:04 AM
Replies: 164
Views: 19,469
Posted By avinut

Who the heck ever heard of an ameco trainer with...

Who the heck ever heard of an ameco trainer with a pierce .29 in it ? (1947)
07-05-2007, 03:39 PM
Replies: 3
Views: 526
Posted By avinut

RE: Capacitor hunt!

Thats right Dan,
Its a filter capacitor for the power supply on a CRT. I do use my scope a lot for RC purposes though. I managed to find them at mouser.
07-04-2007, 06:56 PM
Replies: 3
Views: 526
Posted By avinut

Capacitor hunt!

I have an old piece of equipment that needs new filter capacitors. The existing ones have the following notation on the side.

GOOD-ALL
TYPE-522M
.1 MFD.
1600 V.D.C.
446

This...
Replies: 2
Views: 680
Posted By avinut

Capacitor vendors??

I have an old piece of equipment that needs new filter capacitors. The existing ones have the following notation on the side.

GOOD-ALL
TYPE-522M
.1 MFD.
1600 V.D.C.
446

This...
Replies: 286
Views: 90,585
Posted By avinut

RE: JR Announces 2.4Ghz 12 channel & 9 channel radio. X9303 and 12X

Why would anyone buy a new JR radio if they have a perfectly good radio now that just needs a new module??
Replies: 26
Views: 4,664
Posted By avinut

RE: Evolution of RC Radio Equipment

[size=7]Nice post phantom 1. I knew someone out there must have more radios than I do!
Replies: 18
Views: 1,002
Posted By avinut

RE: 6V Receiver Bat Charge

Charge rate is based on the current capacity of the cells, not the voltage. A normal charge rate is 1/10 of the Ma rating for 16 Hrs. Your wall wart charges at a 50 MA rate so anything rated at over...
Replies: 1
Views: 530
Posted By avinut

Kraft Channel Master

Where would I be able to find someone to repair a Kraft Channel Master TX module??
Replies: 5
Views: 737
Posted By avinut

RE: RF modules...

Hello,
There are 6 wires as follows: red (power), white (antenna), green (meter), yellow (modulation), orange/black (osc. kill), black (ground).
The osc. kill is a ground signal when the buddy...
Replies: 319
Views: 34,385
Posted By avinut

Replies: 5
Views: 1,273
Posted By avinut

RE: Futaba/Airtronics Compadibility (VG600)

Just buy one of the Polk Hobbies receivers and fly it with whatever TX you want.
Replies: 3
Views: 662
Posted By avinut

RE: Kraft Radio - Sport Series - for sale

Someone may bid to get the servos but selling a sport series is not too likely. I have four of them and I couldn't get a $10 bid on ebay.[:o]
Replies: 2
Views: 476
Posted By avinut

Replies: 14
Views: 1,099
Posted By avinut

do it yourself tuning?

What are the legalities in Italy?
Replies: 19
Views: 1,200
Posted By avinut

Idea for more reliable switch

I know I'm dense but I don't understand this discussion! Every switch harness I have bought is wired as suggested herein. I have never seen one that switched the black wire. All mine just switch the...
Replies: 319
Views: 34,385
Posted By avinut

There is a tracker ll

The Hitec mix does the same thing.
07-26-2003, 11:17 PM
Replies: 268
Views: 51,413
Posted By avinut

Giant Delta! 86 inches!!

who has built one by laminating 1" foam instead of using 2"?
Showing results 1 to 25 of 89
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.