RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: Wideopen
Showing results 1 to 25 of 43
Search took 0.56 seconds.
Forum: RC Jets
05-20-2012, 08:56 AM
Replies: 6,790
Views: 1,382,693
Posted By Wideopen

RE: C-ARF Ultra Flash build Thread + Video

Helihover_1,

Check post 1378, 1379 and 1380. I had the same problem, just open the hole to bigger.
Forum: RC Jets
04-10-2012, 05:47 AM
Replies: 71
Views: 7,038
Posted By Wideopen

RE: what caused the turbine jet crash??!!!!!

I have always used (nimh)2000mah batteries with no problems, Boomerang XL, Viper jet and Avonds F-15. I do check the battery after charging with a voltage tester under load and never had a problem....
Forum: RC Jets
03-08-2012, 05:49 PM
Replies: 6,790
Views: 1,382,693
Posted By Wideopen

RE: C-ARF Ultra Flash build Thread + Video

Consoleworld,

Very nice installation, neat and tidy, post some video of your flight, I should have mine ready in a few more weeks, also with a P120.
Forum: RC Jets
02-13-2012, 10:08 AM
Replies: 6,790
Views: 1,382,693
Posted By Wideopen

RE: C-ARF Ultra Flash build Thread + Video

Thanks Airforce7 & Sailing1, I will give use both of your suggestions and give it another try.

Airforce7, our flying field is an old US base that was closed back in 1995. It is a bit ruff but we...
Forum: RC Jets
02-13-2012, 07:12 AM
Replies: 6,790
Views: 1,382,693
Posted By Wideopen

RE: C-ARF Ultra Flash build Thread + Video

I am having a problem setting up the flaps to the servo push rods, this seems like a real PITA [:o]

1. is there some type of easy way to do this.
2. does the servo arm face down the opposite...
09-27-2011, 10:43 AM
Replies: 5
Views: 983
Posted By Wideopen

RE: P120 and Flight Works Pump

I tried that about 6 times as I read this on some old posts. It still did not work. Pump voltage on GSU read 3.80 volts, and would not go any higher. I think the 400-B would be better like you said....
09-27-2011, 07:14 AM
Replies: 5
Views: 983
Posted By Wideopen

RE: P120 and Flight Works Pump

Well it does work, but I don't get the full RPM. I only get 104,000 RPM at full trottle when I should be getting 123,000. I think this is from the flightworks pump being too small, the model is 300B....
09-23-2011, 07:31 PM
Replies: 5
Views: 983
Posted By Wideopen

P120 and Flight Works Pump

Is it OK to use a Flight Works Pump with a P120. This pump was used with my simjet 2300 turbine, I am having pump problems with my jetcat pump.
Forum: RC Jets
08-26-2011, 01:20 PM
Replies: 5
Views: 535
Posted By Wideopen

RE: 9 cap programming help

Go to the Futaba website and look up your transmitter, then look under frequently asked questions for programming your radio, it will show you how to do what you want step by step. I used this for my...
07-08-2011, 10:42 AM
Replies: 3
Views: 616
Posted By Wideopen

RE: 10C radio having binding issues

Krysta,

I switched to 7ch Mode and everything is now working Thanks.

Another question, I have one airplane using the 6ch receiver and the other using the 7ch receiver, I notice that I can...
07-08-2011, 05:46 AM
Replies: 3
Views: 616
Posted By Wideopen

10C radio having binding issues

I have 2 new receivers that won't bind to my radio. Am I doing something wrong. R6106HFC 6 channel and R617FS 7 channel receivers. I turn on radio, select model, then push link button on receiver,...
07-04-2011, 08:06 AM
Replies: 9
Views: 2,160
Posted By Wideopen

RE: What causes a P120 to Flame Out

What voltage do I use to check the pump. Do I use the turbine battery or a lower voltage battery. The pump and turbine is about 8 years old.
07-04-2011, 05:59 AM
Replies: 9
Views: 2,160
Posted By Wideopen

RE: What causes a P120 to Flame Out

Did you plug in the GSU after the flameouts.

No.

Did you get a puff of white smoke just prior to the flame out?

Yes, a good bit of white smoke. I was only 2 minutes into the flight.
07-03-2011, 06:48 PM
Replies: 9
Views: 2,160
Posted By Wideopen

What causes a P120 to Flame Out

The last 3 times I have been flying I have had 3 flame outs. Can someone give me some advice on what I should check. The first 2 times I landed OK. Today I was not able to land without doing damage...
Forum: RC Jets
03-18-2011, 06:39 PM
Replies: 3,653
Views: 518,199
Posted By Wideopen

RE: The new Tornado sport jet

Henry, can you post some video of both jets.
12-24-2010, 08:12 AM
Replies: 1
Views: 687
Posted By Wideopen

GSU cord to LED I/O Board

I just brought a P120 from a friend, but it is missing the cord that plugs the GSU to the LED I/O Board. Can I use a use a regular telephone cord with 4 or 6 pins to make this connection.
Forum: RC Jets
12-09-2010, 07:42 AM
Replies: 17
Views: 3,233
Posted By Wideopen

RE: AVONDS F-15

Hi guys, can someone tell me where the CG is located on this Jet. I just got one that is nearly completed but it does not state were the CG is located. Also I would like to know where the elevators...
Forum: RC Jets
11-11-2010, 05:47 PM
Replies: 3,653
Views: 518,199
Posted By Wideopen

RE: The new Tornado sport jet

Henry,

When will we see some flight video.
07-10-2010, 09:04 AM
Replies: 10
Views: 3,670
Posted By Wideopen

Nesail.com, No response

Does anyone know whats up with Nesail.com. I placed an order with them back in March and have not received my order. They have taken my money off of my credit card. I have called many times and left...
03-29-2007, 08:08 PM
Replies: 8
Views: 2,096
Posted By Wideopen

Forum: RC Jets
01-10-2007, 06:59 PM
Forum: RC Jets
12-14-2006, 08:32 PM
Replies: 51
Views: 8,244
Posted By Wideopen

RE: Turbine Enforcer with Canards

Yes, nose was extended by 6 inches. Canards are mounted 24 inches in front of CG. Canards are 6-3/4 inches long at trailing edge and 3-3/4 wide. If I had to make them again I would make them longer...
Forum: RC Jets
11-19-2006, 10:41 AM
Replies: 51
Views: 8,244
Posted By Wideopen

RE: Turbine Enforcer with Canards

4 flights, each flight is only 6 mins. do to the turbine size/fuel tank a 12 to 16lb thrust turbine will give a longer flight. I was using 25lb of thrust way to much.:D I never checked the batt after...
Forum: RC Jets
11-19-2006, 10:13 AM
Replies: 51
Views: 8,244
Posted By Wideopen

RE: Turbine Enforcer with Canards

The Rx battery is a Hobbico Hydrimax 6.0V 2000 mAh

2 Hitec 5645 digital servo for elevons
2 Hitec 5125 digital servo for rudder
1 Hitec 5245 digital for canard
1 standard servo for...
Forum: RC Jets
11-19-2006, 08:25 AM
Replies: 51
Views: 8,244
Posted By Wideopen

Showing results 1 to 25 of 43
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.