RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: George
Showing results 1 to 25 of 500
Search took 0.89 seconds.
Forum: RC Jets
02-17-2020, 03:48 AM
Replies: 74
Views: 6,301
Posted By George

Thank you Hans!

Thank you Hans!
Forum: RC Jets
02-16-2020, 05:21 PM
Replies: 74
Views: 6,301
Posted By George

Well, the maiden is complete and was a success!! ...

Well, the maiden is complete and was a success!!

I have a question though regarding the elevator. Since I did not build it, and the "mark" to set elevator neutral is no longer visible, I did not...
Forum: RC Jets
01-29-2020, 01:53 PM
Replies: 8
Views: 688
Posted By George

VERY nice Kris. Congrats to Barry, Dirk, ...

VERY nice Kris.

Congrats to Barry, Dirk, and you (PRCJ)!
Forum: Marketplace
01-16-2020, 03:36 AM
Replies: 3
Views: 358
Posted By George

Sorry

Sorry
Forum: RC Jets
01-10-2020, 01:43 PM
Replies: 3
Views: 348
Posted By George

I believe the Standard will only take Serial...

I believe the Standard will only take Serial (SBUS, etc.) in, with PWM out (must use the wire loom). The Pro on the other hand will do SBUS in & SBUS out.
Forum: Marketplace
01-07-2020, 04:37 AM
Replies: 0
Views: 141
Posted By George

BVM Main Gear

BVM Main gear, one is brand new, and one used with brand new cylinder.
Forum: Marketplace
12-08-2019, 03:27 PM
Replies: 2
Views: 188
Posted By George

I have BobCat Case

I have BobCat Case
Forum: Marketplace
12-08-2019, 03:24 PM
Replies: 3
Views: 481
Posted By George

orry, didn't get a notification there was a...

orry, didn't get a notification there was a reply, and didn't see this until now.

Check your PM
Forum: RC Jets
12-07-2019, 02:58 PM
Replies: 74
Views: 6,301
Posted By George

Thanks guys! Someone has offered to send me...

Thanks guys!

Someone has offered to send me pics of the pages. I have a little while, but if I need to contact Tom, I will...I just didn't want to bother him if not necessary.
Forum: Marketplace
12-07-2019, 07:14 AM
Replies: 1
Views: 119
Posted By George

Sold pending funds.

Sold pending funds.
Forum: RC Jets
12-06-2019, 07:03 PM
Replies: 74
Views: 6,301
Posted By George

Reviving an old thread since I just got one of...

Reviving an old thread since I just got one of these.

Does anyone have the manual in electronic form that shows throws, CG, elevator position at neutral, etc.?

Thanks in advance.

...
Forum: Marketplace
12-06-2019, 05:55 PM
Replies: 0
Views: 183
Posted By George

JetCat P200

P200 (#0109) Kero-start engine with 1 hour, 45 minutes of run time. 50 lbs. of thrust, updated to latest software (6.30T), includes fuel pump, valves/solenoids, engine cables, I/O board, mount, and...
Forum: Marketplace
12-06-2019, 05:45 PM
Replies: 1
Views: 119
Posted By George

Jr 1221

JR 1221 receiver with satellites and two voltage regulators. Almost new with only 13 flights, removed from airplane I traded and do not need because I fly a different radio brand. I will include two...
Forum: Marketplace
11-24-2019, 01:47 PM
Replies: 3
Views: 481
Posted By George

BVM Retracts (Purple)

One new, one used retract.
Forum: Marketplace
11-23-2019, 10:10 AM
Replies: 2
Views: 226
Posted By George

Due to it being "rounded", approx. 56" long, 26"...

Due to it being "rounded", approx. 56" long, 26" wide, and 13" deep.
Forum: Marketplace
11-22-2019, 03:22 PM
Replies: 2
Views: 226
Posted By George

BVM BobCat Jet Case

BVM BobCat Jet Case
Forum: Marketplace
11-01-2019, 05:18 PM
Replies: 5
Views: 874
Posted By George

Price reduced.

Price reduced.
Forum: Marketplace
10-26-2019, 03:11 AM
Replies: 5
Views: 874
Posted By George

Would consider any jet.

Would consider any jet.
Forum: Marketplace
10-20-2019, 02:38 PM
Replies: 0
Views: 164
Posted By George

Spektrum AR636 (AS3X)

Brand new / Never used Spectrum Receiver w/AS3X. It was removed from a BNF Havoc XE.
Forum: Marketplace
10-20-2019, 02:29 PM
Replies: 5
Views: 874
Posted By George

Air Trade Turbo Raven (RTF)

Air Trade Turbo Raven w/JetCat SPT5 Turbo Prop. Currently set-up with S-Bus and Futaba servos, Rose Engineering main wheels with custom electric brakes and RE tail wheel. Has custom paint and comes...
Forum: Marketplace
08-09-2019, 03:54 PM
Replies: 16
Views: 922
Posted By George

I never heard back on PM, and now I bought...

I never heard back on PM, and now I bought another, so no longer need.

R/
Forum: Marketplace
08-07-2019, 01:16 PM
Replies: 16
Views: 922
Posted By George

Steve, Is this still available?

Steve,
Is this still available?
Forum: Marketplace
08-02-2019, 12:45 PM
Replies: 16
Views: 922
Posted By George

PM sent

PM sent
Forum: Marketplace
12-06-2018, 05:13 PM
Replies: 5
Views: 1,033
Posted By George

Is this Extreme Jets? Is the scheme the same as...

Is this Extreme Jets? Is the scheme the same as pictured? Interested in any trades?
05-20-2018, 12:59 PM
Replies: 7
Views: 1,166
Posted By George

Hello Gonzo, Yes, you can use the ECU. If...

Hello Gonzo,

Yes, you can use the ECU. If the engine doesn't change the ECU to SPT5 after plugged in and powered, then the ECU will have to be programmed manually to SPT5. This can be done by you...
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.