RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: floridagyro
Showing results 1 to 7 of 7
Search took 0.02 seconds.
Forum: AutoGyros
03-16-2002, 12:49 AM
Replies: 19
Views: 1,967
Posted By floridagyro

My gyro project.

Hi Rich,

The cable goes between the external sensors which is mounted on the outside of the aricraft and the little computer where the servos plug in.

Phil
Forum: AutoGyros
03-14-2002, 01:49 AM
Replies: 19
Views: 1,967
Posted By floridagyro

Co-Pilot

I'm not sure but I think you can only purchase them from FMA Direct. I just tried to buy another one and they are out of stock. Expect to have delivery in 2 weeks.

Phil
Forum: AutoGyros
03-13-2002, 03:54 AM
Replies: 19
Views: 1,967
Posted By floridagyro

My gyro project.

Rich,

One thing for sure, the Spacewalker would sure look nice as as gyro.

I have a suggestion. Marry the girlfried and sell the boat and you will have plenty of money for an autogyro.

Phil
Forum: AutoGyros
03-12-2002, 07:38 PM
Replies: 19
Views: 1,967
Posted By floridagyro

Best Gyro to start with

Hi,

Me again. :rolleyes: My recommendation, as long as you are building the delta hubs would be to put one on a single rotor autogyro and install the Co-Pilot. (I know it's another $119.0) If...
Forum: AutoGyros
03-12-2002, 04:57 PM
Replies: 19
Views: 1,967
Posted By floridagyro

My gyro project.

Hi Rich,

The most difficult part of flying autogyros is getting them off the ground and high enough to recover until you can get use to how they handle. I have seen experience gyro pilots make...
Forum: AutoGyros
03-12-2002, 02:14 PM
Replies: 19
Views: 1,967
Posted By floridagyro

My gyro project.

Hi Rich,

Just to comment on your 0, 15, -5 idea. If you build it with those parameters, when your blades reach autorotation and you throttle up it would probably roll over on it's back. I would...
Forum: AutoGyros
03-05-2002, 04:49 AM
Replies: 19
Views: 1,967
Posted By floridagyro

Dual Rotor Autogyro

Hi Rich,
This sounds like this autogyro may be your first. I have built several dual rotors with servos to control the incidence of the rotor heads. I did use the 132 oz servos that you mentioned...
Showing results 1 to 7 of 7


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.