RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: sysiek
Showing results 1 to 25 of 500
Search took 0.37 seconds.
Forum: RC Jets
Yesterday, 08:13 PM
Replies: 5
Views: 384
Posted By sysiek

Today I was working on the elevators servos and I...

Today I was working on the elevators servos and I wish that the company did the cutting for the servo arms this will cut the build time and all the hassle with measurements where those cuts should...
Forum: RC Jets
Yesterday, 08:09 PM
Replies: 5
Views: 384
Posted By sysiek

Usually Iím using dremell to make the glued aides...

Usually Iím using dremell to make the glued aides sanded so they could bite with the glue.
Forum: RC Jets
02-20-2020, 08:58 PM
Replies: 16
Views: 674
Posted By sysiek

But remember the most important thing is to have...

But remember the most important thing is to have the big vent lines to the fuel tanks or your uat tank will start to collapse and have fuel restrictions.
Forum: RC Jets
02-20-2020, 08:54 PM
Replies: 5
Views: 384
Posted By sysiek

Ok so wing servos today, so all the hardware are...

Ok so wing servos today, so all the hardware are supplied are up to the number all is included and they fit perfectly just need to drilled some holes into the servo plates, so Iím using the...
Forum: RC Jets
02-19-2020, 08:03 PM
Replies: 62
Views: 8,840
Posted By sysiek

So Iím not using flaps for takeoff just...

So Iím not using flaps for takeoff just landing,so the jet will go down with flaps if you donít have the flap-elevators setup, so after the gear pass Iím doing the half flaps until slow and straight...
Forum: RC Jets
02-19-2020, 05:55 PM
Replies: 5
Views: 384
Posted By sysiek

So all the horn pockets needed to be enlarged and...

So all the horn pockets needed to be enlarged and cleaned they smaller and shorter than the horns,very easily but still time consuming,so today all the horns are glued and the rudder hinges,next the...
Forum: RC Jets
02-19-2020, 04:34 PM
Replies: 5
Views: 384
Posted By sysiek

TopRc Voyager build

So Iím starting the big voyager building so Iím planning to post some build pictures, maybe someone will like to watch....
Forum: RC Jets
02-19-2020, 04:16 PM
Replies: 62
Views: 8,840
Posted By sysiek

So the best cg is right in front of the struts...

So the best cg is right in front of the struts when dry the manufacturerís cg is wrong make sure that thereís lots of throw on the elevators. This is my third super scorpion with lots of flight time...
Forum: Marketplace
02-17-2020, 10:54 PM
Replies: 3
Views: 219
Posted By sysiek

Is this falcon or super eagle ? And do you have...

Is this falcon or super eagle ? And do you have all the support equipment, thanks again
Forum: RC Jets
02-16-2020, 06:23 PM
Replies: 15
Views: 640
Posted By sysiek

This is a nice improvement to the field, be ready...

This is a nice improvement to the field, be ready for next year extension probably more people will like to stop by and fly at this nice field.
Forum: RC Jets
02-15-2020, 08:04 PM
Replies: 15
Views: 640
Posted By sysiek

Probably more guys from Chicago area me Sebastian...

Probably more guys from Chicago area me Sebastian ,Nick ,Joe, Dave ,and maybe Vick ,Peter, Paul and maybe more Iím working on it this is great place to fly and go away from the big city.
Forum: RC Jets
02-08-2020, 12:30 PM
Replies: 18
Views: 3,533
Posted By sysiek

😀 ...

😀
https://cimg6.ibsrv.net/gimg/www.rcuniverse.com-vbulletin/2000x1504/27e101af_77bd_401c_a635_b23ff7328d05_9d48d3f7d8de390d136676d43f34a0e8463638d4.jpeg
Forum: RC Jets
02-05-2020, 06:10 PM
Replies: 23
Views: 1,494
Posted By sysiek

Bravo Kris 👏

Bravo Kris 👏
Forum: RC Jets
02-05-2020, 06:49 AM
Replies: 23
Views: 1,494
Posted By sysiek

Hey Andy I have the dx18 for years than the DX20...

Hey Andy I have the dx18 for years than the DX20 for very short period and than I sold it to use the 18 back they about the same but I just canít use the slides on the DX20 and want some money back,...
Forum: RC Jets
02-03-2020, 12:20 PM
Replies: 135
Views: 10,135
Posted By sysiek

This f-22 itís definitely on my list but for now...

This f-22 itís definitely on my list but for now I need to clean my hangar from other jets to make a room for this one
Forum: RC Jets
02-03-2020, 09:23 AM
Replies: 135
Views: 10,135
Posted By sysiek

This building forum looks like a competition...

This building forum looks like a competition between two of you guys, this is actually fun to watch, good job guys, I have that Iím going see them both flying in Kentucky
Forum: RC Jets
01-29-2020, 06:32 AM
Replies: 86
Views: 4,756
Posted By sysiek

I have done something like that using just a drop...

I have done something like that using just a drop off goop glue and hold the servo with the rudder for 45 minutes and than drilled the screws holes and tided the servos, this was much easier at least...
Forum: Marketplace
01-28-2020, 07:16 AM
Replies: 6
Views: 271
Posted By sysiek

If you have the black pump with no valve it's...

If you have the black pump with no valve it's still the g1 version , I have the same one in my k-140 , but I'm not sure how the new pump withe the build inn valve will work withe the xicoy ecu and be...
Forum: Marketplace
01-27-2020, 07:21 PM
Replies: 6
Views: 271
Posted By sysiek

Thatís not possible to have the g2 pump with the...

Thatís not possible to have the g2 pump with the g version thatís totally different system, please post all the pictures with what you have.
Forum: Marketplace
01-26-2020, 02:32 PM
Replies: 4
Views: 199
Posted By sysiek

No idea maybe 45 shipped,

No idea maybe 45 shipped,
Forum: Marketplace
01-25-2020, 08:28 PM
Replies: 4
Views: 199
Posted By sysiek

Hi I donít have the wings but I have brand new...

Hi I donít have the wings but I have brand new elevators, one has monocote damage and the one on is perfect,let me know if you interested
Forum: RC Jets
01-23-2020, 08:02 PM
Replies: 86
Views: 4,756
Posted By sysiek

Hm I think that my brand new yellow f-22 arf is...

Hm I think that my brand new yellow f-22 arf is for sale right now 😀 , this is definitely on my list but for now Iím broke until something goes to make a room for this amazing f-22 .
Forum: RC Jets
01-19-2020, 03:32 PM
Replies: 15
Views: 640
Posted By sysiek

Winamac 15-23

Winamac 15-23
Forum: RC Jets
01-14-2020, 02:07 PM
Replies: 32
Views: 1,907
Posted By sysiek

The only thing that make me worry is the big...

The only thing that make me worry is the big canopy and is very flexible for high speed I hope that they will make optional version with solid panted canopy.
Forum: RC Jets
01-14-2020, 11:34 AM
Replies: 26
Views: 2,985
Posted By sysiek

This is the number to call for the best possible...

This is the number to call for the best possible service and accurate information 847-507-4373
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information

Copyright © 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.