RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: Divesplat
Showing results 1 to 25 of 500
Search took 0.98 seconds.
09-08-2008, 04:50 PM
Replies: 19
Views: 3,252
Posted By Divesplat

Top-Flite Vs Hanger 9 P-47

Am wanting to build a P-47 Giant Scale. The problem is the huge cost difference between the TF $250 Kit, $270 Retracts, $100 Tailwheel retracts alone are more than the H9 with these things provided....
Forum: IMAC
03-14-2008, 02:00 AM
Replies: 14
Views: 2,110
Posted By Divesplat

RE: basic fot the first time

Hey Jason.

1) The roll direction in Basic doesn't matter.

2) Recommend going to the IMAC website and looking at the rules so you aren't surprised. This is a competition and as such,...
11-26-2007, 03:21 AM
Replies: 11
Views: 1,287
Posted By Divesplat

RE: Fishing antenna through antenna tube in fus

Tie at knot at the very end of the antenae, use very small piano wire to push through to the end of the tube, then you don't have to worry about glue or tape.

ed
Forum: IMAC
10-04-2007, 06:39 AM
Replies: 8
Views: 1,583
Posted By Divesplat

RE: Metal gear servos; how critical?

I guess I'll be the voice of dissention here.

I flew a 36% Aeroworks Edge 10 years ago, over 500 flights with 4721's all around. Yes that is right, non digital and non metal geared. I never...
09-24-2007, 10:25 PM
Replies: 27
Views: 3,538
Posted By Divesplat

RE: MIDAIRS!!!!

Hey guys.

"Avoidance" is what it is called in IMAC.

Our Tx don't have radar but that very quickly becomes the callers responsibility. John's son was calling for me at the Nats in IMAC as...
08-29-2007, 09:31 PM
Replies: 6
Views: 1,467
Posted By Divesplat

Patty's new scheme

Here is my freshly maidened 40% RadioWave Extra 300 single seat in the new Patty Wagstaff scheme. Am really happy with how it turned out.

Kirby's Kustom Graphics did the vinyl. Da 150 with...
08-28-2007, 07:45 AM
Replies: 3
Views: 757
Posted By Divesplat

RE: Lubbock High Plains Championships

We had 16 pilots, fairly evenly spread out through the classes. Spagetti and lasagna was really good with that home made ice cream at John's House.

No crashes, and some really close contests. ...
08-12-2007, 08:52 PM
Replies: 3
Views: 757
Posted By Divesplat

RE: Lubbock High Plains Championships

After flying in El Paso this weekend I am really pumped up for our contest in 2 weeks.

Looking forward to seeing everyone.

Ed
08-12-2007, 08:51 PM
Replies: 5
Views: 1,007
Posted By Divesplat

RE: El Paso Pattern

I'll echo John's comments.

Will be there next year and want to thank all the volunteers that helped and spent their weekend at the contest. Saturday night food was really good. Also good to...
08-07-2007, 04:26 PM
Replies: 8
Views: 1,266
Posted By Divesplat

RE: 160DZ question

Update:

Joe installed a header tank, engine ran well, except the same problem, spitting and sputtering on an outside loop.

Ed
08-06-2007, 07:16 PM
Replies: 3
Views: 757
Posted By Divesplat

Lubbock High Plains Championships

Hey everyone. Everything is set for the High Plains Championships Aug 25-26 but the flying site has changed to the city field. Last year we practiced at this field on Fri.

It is located...
08-05-2007, 07:01 PM
Replies: 8
Views: 1,266
Posted By Divesplat

160DZ question

Asking for a friend who is having a hard time getting his pump set.

Coolpower 30% heli fuel, hatori header and pipe, 17X10 APC prop, Tetra tank, foam YS clunk.

Flying the masters sequence,...
07-31-2007, 06:57 PM
Replies: 5
Views: 1,007
Posted By Divesplat

El Paso Pattern

Hey everyone.

Am wondering who is planning on attending the El Paso Pattern contest next weekend.

Several of us from Lubbock are going. Should be a fun weekend and am looking forward to...
07-10-2007, 04:34 AM
Replies: 11
Views: 969
Posted By Divesplat

RE: 140dz prop and rpm?

I ran the 16.5X12W APC on my 140Dz's. Good combo.

Ed
Forum: IMAC
07-06-2007, 12:07 AM
Replies: 7
Views: 2,462
Posted By Divesplat

RE: NATS RESULTS

Thanx Dan. Keep up the good work!!!!

Ed
06-29-2007, 07:23 AM
Replies: 4
Views: 652
Posted By Divesplat

RE: Graphics Question

I have been told to use a paper towel over the graphics and apply the iron for a short time to tighten the covering, while protecting the graphics.

Have tried it with some success. Think the...
06-12-2007, 07:15 PM
Replies: 28
Views: 4,080
Posted By Divesplat

RE: Home-made gas cans

The LHS has a set of fuel fittings. Drill 2 holes very close to the spout in the tank itself on top. Place these 2 fittings and run one fuel line with clunk to the bottom of the tank. Use fuel...
05-29-2007, 06:51 PM
Replies: 25
Views: 3,235
Posted By Divesplat

RE: Jetero Pattern Contest - June 2-3, Houston

Hope you guys have fun. Will be thinking of you guys.

Ed
05-21-2007, 09:56 AM
Replies: 1
Views: 505
Posted By Divesplat

Albuquerque Pattern

Well, the 20 something pattern contest is in the books. For anyone who hasn't been to an Alb contest they are missing some unique things and should consider coming. This was my 9 year and still...
Forum: IMAC
05-14-2007, 09:05 PM
Replies: 2
Views: 788
Posted By Divesplat

Zero's

hey everyone. I was ready the new rules and it seems the mandatory judge agreement on zero's has been changed.

Has anyone else gotten this impression?? Or more appropriately what is the exact...
05-12-2007, 11:43 PM
Replies: 5
Views: 931
Posted By Divesplat

RE: Walk me through the Reverse Shark's Tooth, 1/2 Roll at 45...

Your flying towards the end of the box, Pull into a 45 upline, establish, perform 1/2 roll, push a little down to keep the line, establish, pull to a vertical downline, and lastly pull to horizontal...
Forum: IMAC
05-12-2007, 04:55 AM
Replies: 4
Views: 956
Posted By Divesplat

Advanced figure 9

Hey everyone. Had a simple question for discussion.

manuever 6 in the advanced sequence is a figure 9 with a full integrated roll at the top and 1.5rolls on exit.

The aresti shows the exit...
05-06-2007, 06:32 AM
Replies: 22
Views: 2,030
Posted By Divesplat

RE: BEST QUALITY ARF

I have had a 35% Extra and currently have the 41% Extra from Wildhare and the quality and prefabrication is tops. There prices are also typically lower than others.

Tom also gives excellent...
05-02-2007, 07:19 PM
Replies: 6
Views: 1,198
Posted By Divesplat

RE: Pattern/IMAC cross fliers

Just an update.

It has taken 2 weeks to get back to a pattern feel and flying smoothly with slow rolls on a wire, not over bumping down inverted and watching my entries and exits. I haven't...
04-30-2007, 02:30 PM
Replies: 2
Views: 555
Posted By Divesplat

RE: 10X and 10SX

Thank You

ed
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.