RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: Jetpilot24
Showing results 1 to 19 of 19
Search took 0.01 seconds.
Forum: RC Jets
08-23-2021, 12:10 PM
Replies: 76
Views: 10,390
Posted By Jetpilot24

I don't have any crow in mine. It doesn't need...

I don't have any crow in mine. It doesn't need it. Slows down very nice. Just don't try to do a high angle of attack on the flare. It will drop a wing.

Joe
Forum: RC Jets
07-29-2021, 03:06 AM
Replies: 76
Views: 10,390
Posted By Jetpilot24

The specs from Tower Hobbies web site. ...

The specs from Tower Hobbies web site.

Completion Level Almost Ready-To-Fly
Engine Size Turbine jet engine w/8-10kg thrust (sold separately)
Minimum Required Radio 8-channel (sold separately)...
Forum: RC Jets
07-27-2021, 01:56 PM
Replies: 76
Views: 10,390
Posted By Jetpilot24

Its a carbon fiber looking sticker. Its is stuck...

Its a carbon fiber looking sticker. Its is stuck directly to the balsa wood sheeting.
Forum: RC Jets
07-26-2021, 02:48 PM
Replies: 76
Views: 10,390
Posted By Jetpilot24

A 120 would be too much for this jet. I have...

A 120 would be too much for this jet.

I have a K80 in mine and it flies great. As far as servos, If you look at the manual, it gives dimensions of servos needed. You would have to research the...
Forum: RC Jets
03-24-2021, 03:04 AM
Replies: 76
Views: 10,390
Posted By Jetpilot24

Gary Any Video of your flight? Joe

Gary
Any Video of your flight?
Joe
Forum: RC Jets
03-22-2021, 02:36 PM
Replies: 76
Views: 10,390
Posted By Jetpilot24

Good to here Gary. Are you going to First in...

Good to here Gary. Are you going to First in flight at the end of May?
Forum: RC Jets
03-15-2021, 04:21 PM
Replies: 76
Views: 10,390
Posted By Jetpilot24

Put 5 more flights on the Hawk this pass weekend....

Put 5 more flights on the Hawk this pass weekend. It is a very stable jet and flies really well on the Kingtech K80.

Joe
Forum: RC Jets
03-01-2021, 05:30 PM
Replies: 76
Views: 10,390
Posted By Jetpilot24

Here is the link to the video. Was taken with a...

Here is the link to the video. Was taken with a phone and it stopped recording right before the landing.
https://www.youtube.com/watch?v=FtW22oJoURE
Forum: RC Jets
03-01-2021, 03:58 PM
Replies: 76
Views: 10,390
Posted By Jetpilot24

Gary thanks. I set the Rates to the...

Gary
thanks. I set the Rates to the recommended but I also had a higher setting one the three position rate switch. Not sure what I ended up with as I only put 2 flights on it. I did not use any...
Forum: RC Jets
03-01-2021, 04:08 AM
Replies: 76
Views: 10,390
Posted By Jetpilot24

I did the Maiden flight on my Hawk. It flies...

I did the Maiden flight on my Hawk. It flies great. Looks good in the air and no bad tendency's. I balanced it with the C/G rig that is in the kit. I also checked balance with a balancing...
Forum: RC Jets
01-29-2021, 04:03 AM
Replies: 76
Views: 10,390
Posted By Jetpilot24

Bob Have you installed batteries yet. I am...

Bob
Have you installed batteries yet. I am getting ready for equipment installation, RX, Retract controller, Engine ECU and fuel pump, and wanted to get some Idea where the Batteries end up being...
Forum: RC Jets
01-20-2021, 04:11 AM
Replies: 76
Views: 10,390
Posted By Jetpilot24

On the rudder mount, Are you talking about the...

On the rudder mount, Are you talking about the hinges or the servo mount, I have just started on mine but I am not that far on the installation.

Joe
Forum: RC Jets
01-15-2021, 02:19 PM
Replies: 76
Views: 10,390
Posted By Jetpilot24

So have you flown yours yet? Joe

So have you flown yours yet?

Joe
Forum: RC Jets
12-22-2020, 05:05 PM
Replies: 76
Views: 10,390
Posted By Jetpilot24

Could be you have the tail cone of the engine too...

Could be you have the tail cone of the engine too deep into the bell mouth if its an older engine with the temp probe in the tail cone. Or you may have an issue with the Temp probe. Pull the engine...
Forum: RC Jets
12-13-2020, 04:31 PM
Replies: 76
Views: 10,390
Posted By Jetpilot24

Bob Thanks I was not aware that it did not have...

Bob Thanks
I was not aware that it did not have brakes.

Joe
Forum: RC Jets
12-13-2020, 04:17 AM
Replies: 76
Views: 10,390
Posted By Jetpilot24

Bob, Nice to hear there is someone else...

Bob, Nice to hear there is someone else assembling one. Curios has to why you updated the wheels and brakes?
Do you have any pics of yours?

Joe
Forum: RC Jets
12-11-2020, 01:43 PM
Replies: 76
Views: 10,390
Posted By Jetpilot24

Thanks for the info. I went ahead and pulled the...

Thanks for the info. I went ahead and pulled the trigger on the Hawk. Going to put my trusty K80 in it. When I get it and start on it I might do an Assembly thread on it

Joe
Forum: RC Jets
12-11-2020, 03:59 AM
Replies: 76
Views: 10,390
Posted By Jetpilot24

Gary Hi Doing good thanks for asking. Hope all...

Gary Hi
Doing good thanks for asking. Hope all is well with you> I am considering the hawk. Like I said I want something thst will fit in the back of the truck. Want something that is k-i-s-s.
...
Forum: RC Jets
12-09-2020, 04:13 AM
Replies: 76
Views: 10,390
Posted By Jetpilot24

Phoenix Models BAE Hawk

Anyone flying one of these or know someone who is or has flown it?
Looking for a put in the back of the truck and go fly jet. What is the overall thought on it?
Thanks
Joe
...
Showing results 1 to 19 of 19


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.