RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: jkinosh
Showing results 1 to 25 of 155
Search took 0.78 seconds.
07-11-2012, 07:26 AM
Replies: 14
Views: 1,397
Posted By jkinosh

RE: Charging question

Not sure if it would have damaged the pack or not, the Charger is a Delta Peak charger, so it should shutoff when it is complete, atleast for NiMh packs
Replies: 1
Views: 2,570
Posted By jkinosh

Battery and charging question

I have the dynamite Speedpack 1800Mah Ni-MH that came with my sons Torment on the charger right now. I had it set to limit capacity ot 2100 maH and it finished with the message of Capa on the...
07-11-2012, 05:16 AM
Replies: 14
Views: 1,397
Posted By jkinosh

Charging question

I have the dynamite Speedpack 1800Mah Ni-MH that came with my sons Torment on the charger right now. I had it set to limit capacity ot 2100 maH and it finished with the message of Capa on the...
Replies: 51
Views: 3,230
Posted By jkinosh

RE: First truck for Son

Sounds about like ours. Think we got around 15 - 20 minutes total out of the stock pack with him just doing some slow playing. It even seemed to go through the grass pretty good, But I'll probably...
Replies: 51
Views: 3,230
Posted By jkinosh

RE: First truck for Son

It came on monday, and after a very impatient wait by a 6 year old, he was finally able to run his new truck last night. Just did the slow speed break in on the driveway for about half a pack, maybe...
Replies: 51
Views: 3,230
Posted By jkinosh

RE: First truck for Son

where did you get the SPC batteries?
Replies: 176
Views: 69,490
Posted By jkinosh

RE: Official ECX Torment Thread

Hope we can be that lucky with ours. My 6 year old cann't wait to drive it in the backyard. See previous Post Here
Replies: 176
Views: 69,490
Posted By jkinosh

RE: Official ECX Torment Thread

I have looked at the Hardcase Lipos from Hobbypartz, and it seems that most of them are out of stock.

But I will check again befor I order anything.

Any other suggestions on places to get...
Replies: 176
Views: 69,490
Posted By jkinosh

RE: Official ECX Torment Thread

OK, I'll probably get these ordered tomorrow.

I just wasn't sure if the 20C was a high enough current rating. New to lipo. Last car I had was a RC10GT, and and an old Radioshack Redarrow in...
Replies: 51
Views: 3,230
Posted By jkinosh

RE: First truck for Son

Would these give me a decent runtime? or do I need something higher than 20C for this.

http://www.hobbypartz.com/77p-sl4400-2s1p-20c-2222.html
Replies: 176
Views: 69,490
Posted By jkinosh

RE: Official ECX Torment Thread

Would these give me a decent runtime?

http://www.hobbypartz.com/77p-sl4400-2s1p-20c-2222.html

or do I need something hight than 20C
Replies: 176
Views: 69,490
Posted By jkinosh

RE: Official ECX Torment Thread

Finally Pulled the trigger. Just ordered him the Black and Orange Torment. Should be here next week sometime.

Now I just need to get some better Batteries and a charger ordered.

Jacob
Replies: 51
Views: 3,230
Posted By jkinosh

RE: First truck for Son

Finally Pulled the trigger. Just ordered him the Black and orange Torment. Should be here next week sometime.

Now I just need to get some better Batteries and a charger ordered.

Jacob
Replies: 10
Views: 818
Posted By jkinosh

RE: LiPo Question

Would I need to Modify the chassis in order for the wires to exit the batteries properly? I know some of them exit directly from the side of the pack.
Replies: 10
Views: 818
Posted By jkinosh

LiPo Question

GOign to be ordering a ECX Torment for my son, and not sure if I should get Hardcase Lipo or if the Normal ones would be fine.

I will also be ordering a Low Voltage Cutoff and Dynam Supermate...
Replies: 51
Views: 3,230
Posted By jkinosh

RE: First truck for Son

Was thinking I'd like to stay away from lipo for now, don't want him burning out the motor to fast. Figured it would be able to cool off a little between batteries. The nimh's are 20 each and I have...
Replies: 51
Views: 3,230
Posted By jkinosh

RE: First truck for Son

Planning on staying stock for the time being, just want him to be able to get some enjoyable runtime out of the batteries.

I can get the 6 or 7 cell 3000Mah Duratrax batteries for the same...
Replies: 176
Views: 69,490
Posted By jkinosh

RE: Official ECX Torment Thread

Trying to keep it budget friendly. Have a 20 off 50 coupon for tower.
Replies: 51
Views: 3,230
Posted By jkinosh

RE: First truck for Son

Might also be considering an ECX Torment, Son got to see one and pick it up over the weekend, and really liked it.
Advantage I see is it already has a Spektrum radio in it.

but one more...
Replies: 176
Views: 69,490
Posted By jkinosh

RE: Official ECX Torment Thread

Wasn't planning an hour per pack, was thinking 45 - 60 minutes with all 3 packs
Replies: 176
Views: 69,490
Posted By jkinosh

RE: Official ECX Torment Thread

So if I pickup, let say 3 DuraTrax Onyx NiMH 7C 8.4V 3000mAh Stick Standard Plug, he should be good for at least running an hour?

would it be better to use the flat packs of the Hump packs?

...
Replies: 6
Views: 458
Posted By jkinosh

RE: Cuts Out

I am actually thinking about getting one of these for my son, and just saw this in the manual.

Sounds Like the Low Voltage Cutoff
Replies: 176
Views: 69,490
Posted By jkinosh

RE: Official ECX Torment Thread

Yes, planning stock out of the box.
Replies: 176
Views: 69,490
Posted By jkinosh

RE: Official ECX Torment Thread

Any idea what the runtime would look like with a 7 cell 3000Mah NiMh?
Replies: 51
Views: 3,230
Posted By jkinosh

RE: First truck for Son

Here's the picture I promised.
Showing results 1 to 25 of 155
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.